Journal
INTERNATIONAL JOURNAL OF GEOMECHANICS
Volume 23, Issue 2, Pages -Publisher
ASCE-AMER SOC CIVIL ENGINEERS
DOI: 10.1061/(ASCE)GM.1943-5622.0002603
Keywords
Linear rock-cutting machine; Wear behavior; Cutting efficiency; Tungsten carbide; AlTiN; Sputter coating
Categories
Ask authors/readers for more resources
In this study, a newly designed shaping machine and a triaxial force dynamometer were used to measure the efficiency of rock cutting and the wear behavior of aluminum titanium nitride-coated conical cutting bits. The results showed that the coated bits had a higher hardness range and reduced wear rate compared to the uncoated bits. The findings of this research contribute to extending the application of surface miners in excavating harder rocks in mines.
In mining industries, the prime concern is to overcome the challenges of using conical cutting bits for excavating hard and abrasive rocks. In this research, a speculative investigation was performed to measure the efficiency of rock cutting and identify the wear behavior of aluminum titanium nitride-coated conical cutting bits. A newly designed and customized shaping machine is used with a triaxial force dynamometer to cut the rock samples linearly and to calculate their associated powers. Coated conical bits have a maximum hardness range of 2,291 to 2,459 HV, and uncoated conical bits possess minimum hardness range of 1,945 to 1,948 HV. Two rock samples of fine-grained sandstone with UCS of 83.77 and 97.00 MPa are used in this study. Various cutting ranges were investigated and the best range of cutting parameters are identified between the variables, such as cutting forces and extracted volume of rock, cutting effectiveness, specific energy produced while cutting, and bit wear. The percentage decrease in wear rate of a coated conical bit compared with an uncoated conical bit is 40.36%, 52.28%, and 53.30% for Rock 1 and 42.67%, 54.76%, and 60.90% for Rock 2 under varying depths of cut. The worn surface has been significantly investigated through scanning electron microscopy and energy dispersive X-ray analysis. The output of this study helps in extending the application of a surface miner for excavating harder rocks in mines.
Authors
I am an author on this paper
Click your name to claim this paper and add it to your profile.
Reviews
Recommended
No Data Available