Selenium Removal from Aqueous Solution Using a Low-Cost Functional Ceramic Membrane Derived from Waste Cast Iron

The high affinity of iron-based byproducts for anion removal can facilitate wastewater treatment using membranes functionalized with such byproducts. In this study, a low-cost functional ceramic membrane (LFCM) based on waste cast iron (WCI) was fabricated and applied to remove selenium from aqueous solutions. The effect of roasting (1250 degrees C) on the raw material properties was analyzed by X-ray diffraction and specific surface area measurements. Upon roasting, zero-valent iron (Fe-0) present in WCI was oxidized to hematite (Fe2O3), while the specific surface area of WCI increased from 2.040 to 4.303 m(2)/g. Raw WCI exhibited the highest Se(IV) and Se(VI) removal capacity among the prepared materials, and Se(IV) could be removed faster and more efficiently than Se(VI). The selenium removal properties of the synthesized LFCM were similar to those of WCI. This membrane could simultaneously and efficiently remove Se(IV) and turbidity-causing substances through filtration. The results are expected to provide insights into the fabrication of ceramic membranes using industrial byproducts for the removal of ionic contaminants from wastewater.

Automated summary

In this study, a low-cost functional ceramic membrane (LFCM) based on waste cast iron (WCI) was fabricated and found to efficiently remove selenium from aqueous solutions. The raw WCI exhibited the highest selenium removal capacity among the prepared materials, with a faster and more efficient removal of Se(IV) compared to Se(VI). The synthesized LFCM showed similar selenium removal properties to WCI and could simultaneously remove Se(IV) and turbidity-causing substances through filtration. These findings are valuable for the development of ceramic membranes using industrial byproducts for wastewater treatment.