4.2 Article

Experimental Investigations of a Minichannel Heat Sink for Electronic Applications

Related references

Note: Only part of the references are listed.
Article Engineering, Mechanical

Investigating the Effect of Heat Transfer Coefficient and the Heat Flux on the Thermal Performance of the PCM in the Heat Sink

Mohammad Taghilou et al.

Summary: In this paper, the use of phase change material to enhance the heat dissipation of small-sized electronic components is investigated. Numerical simulations are conducted to compare the base plate temperature with and without the phase change material. The results show that the phase change material can reduce the base plate temperature within a certain range of heat transfer coefficients.

IRANIAN JOURNAL OF SCIENCE AND TECHNOLOGY-TRANSACTIONS OF MECHANICAL ENGINEERING (2022)

Article Thermodynamics

CFD analysis of (TiO2)-H2O Nanofluids on Si-IGBT power electronic module with a new micro-nozzle model

M. Gholinia et al.

Summary: This paper investigates the thermal effects of using titanium oxide nanoparticles with different concentrations and perforated nozzles with paddle blades to improve cooling power. By presenting a new design for a Si-IGBT power module, three types of paddle blades with a simple nozzle type are evaluated and compared. The study concludes that turbulent kinetic energy increases with an increasing number of nozzle blades, increasing the volume fraction of nanoparticles improves heat transfer, and increasing the transverse mass flow rate enhances cooling.

JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY (2022)

Article Thermodynamics

Effect of two different nano-particles (GO-MoS2) and a new micro-sprayer model on power electronic module for thermal management

Mosayeb Gholinia et al.

Summary: This study investigates the performance of a cooling system with graphene oxide (GO) and molybdenum sulfide (MoS2) nanoparticles in reducing heat stress and increasing thermal efficiency and reliability of electronic modules. By adjusting the dimensional ratio of micro-sprays, cooling flow rate, and volume fraction of nanoparticles, it was found that increasing the volume fraction of nanoparticles enhances heat transfer of the nanofluid, leading to improved thermal efficiency. The thermal effects of GO nanoparticles were found to be more favorable compared to MoS2 nanoparticles.

ADVANCES IN MECHANICAL ENGINEERING (2022)

Article Thermodynamics

Novel condenser based cryogenic pulsating heat Pipe: Investigations on influence of geometrical parameters

Kalpak R. Sagar et al.

Summary: This study focuses on developing a novel cylindrical shell-type condenser to improve the cooling efficiency of cryogenic pulsating heat pipes. Experimental results show that the thermal resistance of cryogenic pulsating heat pipes can be significantly influenced by changing the number of turns and adiabatic length.

CRYOGENICS (2022)

Article Thermodynamics

Experimental investigation of the thermal performance of closed loop flat plate oscillating heat pipe

Kamlesh Mehta et al.

Summary: This study investigated the effects of operational and geometrical parameters on the thermal performance of CLFP-OHP. It was found that the thermal resistance was strongly dependent on these parameters, with acetone showing the best performance at a charge ratio of 60%, in vertical orientation, and square channels. The lowest thermal resistance achieved was 0.39 degrees C/W at 100 W, with a thermal conductivity of 3205 W/m degrees C.

EXPERIMENTAL HEAT TRANSFER (2021)

Article Engineering, Mechanical

Experimental Study of Backward Conduction in Multi-Microchannel Heat Sink

Nishit Bedi et al.

Summary: This paper experimentally investigates the effect of conjugate phenomenon on heat transfer in microchannel heat sinks. It is found that under different conditions, the phenomenon of longitudinal conduction in circular channels significantly affects the increase in fluid temperature.

IRANIAN JOURNAL OF SCIENCE AND TECHNOLOGY-TRANSACTIONS OF MECHANICAL ENGINEERING (2021)

Article Engineering, Mechanical

Heat Transfer Enhancement in a Double Pipe Heat Exchanger Using Different Fin Geometries in Turbulent Flow

Osama A. Mohsen et al.

Summary: The study investigates the effect of using different fin geometries for heat transfer in a double pipe heat exchanger. Results show that using different fin geometries can enhance heat transfer but the effect depends on the Reynolds number of the fluids.

IRANIAN JOURNAL OF SCIENCE AND TECHNOLOGY-TRANSACTIONS OF MECHANICAL ENGINEERING (2021)

Article Energy & Fuels

Employing a new micro-spray model and (MWCNTs - SWCNTs) - H2O nanofluid on Si-IGBT power module for energy storage: A numerical simulation

M. Gholinia et al.

Summary: This study investigates the effects of using a cooling fluid and micro-sprays to reduce the heat peak of the electrical system. Increasing the volume fraction of nanoparticles can elevate the thermal diffusivity of the fluid and reduce the temperature peak. Using micro spray can create turbulent fluid behavior, leading to hydrodynamic effects prevailing over thermal effects and reducing module temperature.

ENERGY REPORTS (2021)

Review Thermodynamics

A review on start-up characteristics of the pulsating heat pipe

Dongwei Zhang et al.

Summary: The start-up characteristics of a pulsating heat pipe (PHP) are crucial for its practical application and stable operating performance, which can be influenced by factors such as cross-sectional shape, physical property parameters, and external field action. Pressure distributions in PHP with non-circular or irregular channel sections are uneven, leading to oscillation cycle motion that benefits efficient operation. Fluids with high thermal conductivity and specific characteristics are conducive to PHP start-up, while external fields show potential for enhancing heat transfer efficiency and control.

HEAT AND MASS TRANSFER (2021)

Article Engineering, Mechanical

Influence of Geometry and Magnetic Field on Convective Flow of Nanofluids in Trapezoidal Microchannel Heat Sink

S. Sivasankaran et al.

IRANIAN JOURNAL OF SCIENCE AND TECHNOLOGY-TRANSACTIONS OF MECHANICAL ENGINEERING (2020)

Article Engineering, Mechanical

Influence of the channel profile on the thermal resistance of closed-loop flat-plate oscillating heat pipe

Kamlesh Mehta et al.

JOURNAL OF THE BRAZILIAN SOCIETY OF MECHANICAL SCIENCES AND ENGINEERING (2020)

Article Engineering, Mechanical

Design and Performance of a Novel Hybrid Photovoltaic-Thermal Collector with Pulsating Heat Pipe (PVTPHP)

Hassan Kavoosi Balotaki et al.

IRANIAN JOURNAL OF SCIENCE AND TECHNOLOGY-TRANSACTIONS OF MECHANICAL ENGINEERING (2019)

Article Thermodynamics

Variation in oscillating heat pipe performance

Kimberly A. Stevens et al.

APPLIED THERMAL ENGINEERING (2019)

Article Thermodynamics

Experimental investigations of heat transfer mechanisms of a pulsating heat pipe

Jaeyeong Jo et al.

ENERGY CONVERSION AND MANAGEMENT (2019)

Article Thermodynamics

Experimental investigation of flat plate closed loop pulsating heat pipe

P. Srikrishna et al.

HEAT AND MASS TRANSFER (2019)

Article Thermodynamics

Experimental investigation on the thermodynamic state of vapor plugs in pulsating heat pipes

Soohwan Jun et al.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2019)

Article Thermodynamics

Performance characteristics of flat-plate oscillating heat pipe with porous metal-foam wicks

Jian Qu et al.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2019)

Article Thermodynamics

Effect of a channel layout on the thermal performance of a flat plate micro pulsating heat pipe under the local heating condition

Jonghyun Lim et al.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2019)

Article Thermodynamics

Effects of splitter shape on thermal-hydraulic characteristics of plate-pin-fin heat sink (PPFHS)

E. Hosseinirad et al.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2019)

Article Thermodynamics

Effect of Operational Parameters on the Thermal Performance of Flat Plate Oscillating Heat Pipe

Kamlesh K. Mehta et al.

JOURNAL OF HEAT TRANSFER-TRANSACTIONS OF THE ASME (2019)

Article Thermodynamics

Analysis of straight and wavy miniature heat sinks equipped with straight and wavy pin-fins

Zohreh Chamanroy et al.

INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2019)

Article Thermodynamics

Effect of design and operating parameters on the thermal performance of aluminum flat grooved heat pipes

Hossein Alijani et al.

APPLIED THERMAL ENGINEERING (2018)

Article Thermodynamics

Effect of reentrant cavities on the thermal performance of a pulsating heat pipe

Wookyoung Kim et al.

APPLIED THERMAL ENGINEERING (2018)

Article Thermodynamics

Condensation flow patterns and heat transfer in horizontal microchannels

Ali H. Al-Zaidi et al.

EXPERIMENTAL THERMAL AND FLUID SCIENCE (2018)

Article Thermodynamics

Startup and transport characteristics of oscillating heat pipe using ionic liquids

Qianqing Liang et al.

INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER (2018)

Article Thermodynamics

Graphene nanoplatelets nanofluids thermal and hydrodynamic performance on integral fin heat sink

Waqas Arshad et al.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2017)

Article Thermodynamics

Effect of channel geometry on the operating limit of micro pulsating heat pipes

Jungseok Lee et al.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2017)

Article Thermodynamics

Characteristics of oscillating flow in a micro pulsating heat pipe: Fundamental-mode oscillation

Aejung Yoon et al.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2017)

Article Chemistry, Physical

Forced convective heat transfer of nanofluid as a coolant flowing through a heat sink: Experimental and numerical study

Seyed Ebrahim Ghasemi et al.

JOURNAL OF MOLECULAR LIQUIDS (2017)

Article Engineering, Electrical & Electronic

Experimental and numerical investigation of circular minichannel heat sinks with various hydraulic diameter for electronic cooling application

Seyed Ebrahim Ghasemi et al.

MICROELECTRONICS RELIABILITY (2017)

Article Engineering, Chemical

Numerical study on effect of CuO-water nanofluid on cooling performance of two different cross-sectional heat sinks

Seyed Ebrahim Ghasemi et al.

ADVANCED POWDER TECHNOLOGY (2017)

Article Thermodynamics

Thermal performance of a PCB embedded pulsating heat pipe for power electronics applications

Daniel J. Kearney et al.

APPLIED THERMAL ENGINEERING (2016)

Article Thermodynamics

Effect of Hydrophilic Nanostructured Cupric Oxide Surfaces on the Heat Transport Capability of a Flat-Plate Oscillating Heat Pipe

F. Z. Zhang et al.

JOURNAL OF HEAT TRANSFER-TRANSACTIONS OF THE ASME (2016)

Article Thermodynamics

Time-frequency analysis of flat-plate oscillating heat pipes

John D. Fairley et al.

INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2015)

Article Thermodynamics

Experimental study of a closed loop flat plate pulsating heat pipe under a varying gravity force

V. Ayel et al.

INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2015)

Article Thermodynamics

Thermal Spreading with Flat-Plate Oscillating Heat Pipes

Scott M. Thompson et al.

JOURNAL OF THERMOPHYSICS AND HEAT TRANSFER (2015)

Article Thermodynamics

An Experimental Investigation of an Oscillating Heat Pipe Heat Spreader

F. F. Laun et al.

JOURNAL OF THERMAL SCIENCE AND ENGINEERING APPLICATIONS (2015)

Article Thermodynamics

THERMAL-HYDRAULIC CHARACTERIZATION OF A FLAT PLATE PULSATING HEAT PIPE FOR AUTOMOTIVE APPLICATIONS

V. Manno et al.

INTERFACIAL PHENOMENA AND HEAT TRANSFER (2015)

Article Thermodynamics

Effects of Superhydrophobic and Superhydrophilic Surfaces on Heat Transfer and Oscillating Motion of an Oscillating Heat Pipe

Tingting Hao et al.

JOURNAL OF HEAT TRANSFER-TRANSACTIONS OF THE ASME (2014)

Article Thermodynamics

Advances in Electronics Cooling

Jackson B. Marcinichen et al.

HEAT TRANSFER ENGINEERING (2013)

Article Thermodynamics

Recent Advances in High-Flux, Two-Phase Thermal Management

Issam Mudawar

JOURNAL OF THERMAL SCIENCE AND ENGINEERING APPLICATIONS (2013)

Article Thermodynamics

Study of heat transfer enhancement in a nanofluid-cooled miniature heat sink

Seyyed Mohammad Hosseini Hashemi et al.

INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER (2012)

Article Engineering, Electrical & Electronic

An Investigation of Flat-Plate Oscillating Heat Pipes

Peng Cheng et al.

JOURNAL OF ELECTRONIC PACKAGING (2010)

Article Thermodynamics

Effect of Localized Heating on Three-Dimensional Flat-Plate Oscillating Heat Pipe

S. M. Thompson et al.

ADVANCES IN MECHANICAL ENGINEERING (2010)

Article Engineering, Electrical & Electronic

Numerical study of turbulent heat transfer and pressure drop characteristics in a water-cooled minichannel heat sink

X. L. Xie et al.

JOURNAL OF ELECTRONIC PACKAGING (2007)

Article Engineering, Electrical & Electronic

Multi-physics simulation of microprocessor package under water cooling

BM Liu et al.

JOURNAL OF ELECTRONIC PACKAGING (2004)

Article Thermodynamics

Thermofluid dynamic study of flat-plate closed-loop pulsating heat pipes

S Khandekar et al.

MICROSCALE THERMOPHYSICAL ENGINEERING (2002)

Article Thermodynamics

Thermal modeling of unlooped and looped pulsating heat pipes

MB Shafii et al.

JOURNAL OF HEAT TRANSFER-TRANSACTIONS OF THE ASME (2001)