Related references
Note: Only part of the references are listed.Stereolithography vs. Direct Light Processing for Rapid Manufacturing of Complete Denture Bases: An In Vitro Accuracy Analysis
Alexey Unkovskiy et al.
JOURNAL OF CLINICAL MEDICINE (2021)
The effect of build angle on the tissue surface adaptation of maxillary and mandibular complete denture bases manufactured by digital light processing
Mei-Cen Jin et al.
JOURNAL OF PROSTHETIC DENTISTRY (2020)
Tissue surface adaptation of CAD-CAM maxillary and mandibular complete denture bases manufactured by digital light processing: A clinical study
Se-Na Yoon et al.
JOURNAL OF PROSTHETIC DENTISTRY (2020)
Effects of fabrication techniques on denture base adaptation: An in vitro study
Chih-Yuan Hsu et al.
JOURNAL OF PROSTHETIC DENTISTRY (2020)
Do hydrothermal aging and microwave sterilization affect the trueness of milled, additive manufactured and injection molded denture bases?
Gregor Wemken et al.
JOURNAL OF THE MECHANICAL BEHAVIOR OF BIOMEDICAL MATERIALS (2020)
Photo-curing 3D printing technique and its challenges
Haoyuan Quan et al.
BIOACTIVE MATERIALS (2020)
Assessment of the trueness and tissue surface adaptation of CAD-CAM maxillary denture bases manufactured using digital light processing
Hyun-Ji Hwang et al.
JOURNAL OF PROSTHETIC DENTISTRY (2019)
Investigation into the accuracy and measurement methods of sequential 3D dental scan alignment
Saoirse O'Toole et al.
DENTAL MATERIALS (2019)
CAD-CAM milled versus rapidly prototyped (3D-printed) complete dentures: An in vitro evaluation of trueness
Nicole Kalberer et al.
JOURNAL OF PROSTHETIC DENTISTRY (2019)
Accuracy and retention of denture base fabricated by heat curing and additive manufacturing
Akinori Tasaka et al.
JOURNAL OF PROSTHODONTIC RESEARCH (2019)
Comparing accuracy of denture bases fabricated by injection molding, CAD/CAM milling, and rapid prototyping method
Suji Lee et al.
JOURNAL OF ADVANCED PROSTHODONTICS (2019)
Evaluation of the trueness and tissue surface adaptation of CAD-CAM mandibular denture bases manufactured using digital light processing
Hyung-In Yoon et al.
JOURNAL OF PROSTHETIC DENTISTRY (2018)
EHMP-DLP: multi-projector DLP with energy homogenization for large-size 3D printing
Lifang Wu et al.
RAPID PROTOTYPING JOURNAL (2018)
Build Angle: Does It Influence the Accuracy of 3D-Printed Dental Restorations Using Digital Light-Processing Technology?
Reham Osman et al.
INTERNATIONAL JOURNAL OF PROSTHODONTICS (2017)
Factors Influencing the Dimensional Accuracy of 3D-Printed Full-Coverage Dental Restorations Using Stereolithography Technology
Nawal Alharbi et al.
INTERNATIONAL JOURNAL OF PROSTHODONTICS (2016)
Comparison of denture base adaptation between CAD-CAM and conventional fabrication techniques
Brian J. Goodacre et al.
JOURNAL OF PROSTHETIC DENTISTRY (2016)
Advancements in CAD/CAM technology: Options for practical implementation
Tariq F. Alghazzawi
JOURNAL OF PROSTHODONTIC RESEARCH (2016)
Quantitative Evaluation of Tissue Surface Adaption of CAD-Designed and 3D Printed Wax Pattern of Maxillary Complete Denture
Hu Chen et al.
BIOMED RESEARCH INTERNATIONAL (2015)
Three-dimensional processing deformation of three denture base materials
Andreas Artopoulos et al.
JOURNAL OF PROSTHETIC DENTISTRY (2013)
Share Paper
