Comparison of denture base adaptation between additive and conventional fabrication techniques

PurposeThis in vitro study compared the adaptation of denture bases fabricated by injection molding (IM), compression molding (CM), liquid crystal display (LCD), and digital light processing (DLP) techniques. Material and methodsA definitive maxillary cast was duplicated using a silicone mold to create 40 gypsum casts that were laser scanned before any fabrication procedures were initiated. For the DLP and LCD groups, 20 denture bases (10 in each group) were virtually designed and manufactured referring to the digitalized data. For the CM and IM groups, 20 denture bases (10 in each group) were molded using gypsum models. A total of 40 gypsum models and their corresponding denture bases were scanned. The scanned intaglio surface of each denture base was superimposed on the scanned reference cast to compare the degree of tissue surface adaptation. The three-dimensional surface deviations of the total intaglio surface, denture border apex, palatal vault, and crest of the ridge were evaluated on the basis of the best fit algorithm technique using inspection software. The data were statistically analyzed using one-way ANOVA and Tukey's multiple comparison test (alpha = 0.05). ResultsAccording to the superimposing results, for the total intaglio surface, the lowest deviation was present on the injection-molded group and the highest deviation occurred on the LCD group. For the palatal vault, the lowest deviation was present on the DLP group and the highest deviation occurred in the compression molded group. For the crest of the ridge, the lowest deviation was present in the injection-molded group and the highest deviation occurred in the LCD group. For the denture border apex, the lowest deviation was present in the DLP group and the highest deviation occurred in the LCD group. ConclusionsMaxillary denture bases fabricated using DLP and IM techniques showed higher surface adaptation than the bases fabricated using LCD and CM techniques. Among the conventional techniques, higher compatible dentures can be produced with IM; among the additive techniques, higher compatible dentures can be produced with DLP.

Automated summary

This in vitro study compared the adaptation of denture bases fabricated by injection molding (IM), compression molding (CM), liquid crystal display (LCD), and digital light processing (DLP) techniques. The results showed that denture bases fabricated using DLP and IM techniques exhibited better adaptation compared to those fabricated using LCD and CM techniques.