4.6 Article

Tungsten nanopore-based near-ideal spectral selective solar absorber for a wide temperature range

Related references

Note: Only part of the references are listed.
Article Energy & Fuels

Optical-thermal-mechanical characteristics of an ultra-high-temperature graphite receiver designed for concentrating solar power

Yuanting Zhang et al.

Summary: This study presents the design and evaluation of a solar receiver using liquid tin as the heat transfer fluid. The receiver demonstrates safe and efficient solar energy capture at high temperatures, but challenges arise at higher temperatures and incident power levels.

APPLIED ENERGY (2022)

Article Engineering, Electrical & Electronic

Wavelength-selective metamaterial absorber based on 2D split rhombus grating for thermophotovoltic solar cell

Hagar Hamdy et al.

Summary: This paper proposes a novel wavelength selective metamaterial absorber based on a 2D split rhombus grating and analyzes its absorption characteristics. By coupling surface plasmon polaritons, Fabry-Perot resonance, and magnetic polaritons, the absorber achieves perfect absorption over a wide wavelength range and is insensitive to the incident angle. It shows great potential for use in solar energy harvesting and conversion systems.

OPTICAL AND QUANTUM ELECTRONICS (2022)

Article Green & Sustainable Science & Technology

Receiver with light-trapping nanostructured coating: A possible way to achieve high-efficiency solar thermal conversion for the next-generation concentrating solar power

Wen-Qi Wang et al.

Summary: This paper proposes a receiver with a light-trapping nanostructured coating to improve the solar-thermal conversion efficiency of the next-generation CSP. A multi-scale model combining MCRT, FDTD, and FVM methods is used to evaluate the optical and thermal performance of the receiver. The study shows that the cone nanostructure coating maximizes the receiver's optical-thermal performance, achieving an efficiency higher than the commercial Pyromark2500 coating by 6-10 percentage points.

RENEWABLE ENERGY (2022)

Article Thermodynamics

Conceptual design of novel He-SCO(2 )Brayton cycles for ultra-high-temperature concentrating solar power

Qing Li et al.

Summary: This study proposed four novel He-SCO2 combined Brayton cycles to improve the power cycle performance of ultra-high-temperature concentrating solar power. By conducting parameter analysis and multi-objective optimizations, it was found that different cycles have varying strengths in achieving high thermal efficiency and large temperature differences. Overall, the designed He-SCO2 cycles show promising potential for enhancing power cycle performance under ultra-high temperatures.

ENERGY CONVERSION AND MANAGEMENT (2022)

Article Green & Sustainable Science & Technology

A low-cost sustainable coating: Improving passive daytime radiative cooling performance using the spectral band complementarity method

Yan Dong et al.

Summary: In this study, a PDRC coating with high solar reflectance and excellent cooling performance was prepared using the spectral band complementarity method. It has the potential for large-scale commercial production with a simple and low-cost manufacturing process.

RENEWABLE ENERGY (2022)

Article Energy & Fuels

Realization of an efficient wide-angle solar selective absorber via the impedance matching

Zuoxu Wu et al.

Summary: A wide-angle high absorption solar selective absorber has been constructed using a quasi-optical cavity structure with a cermet-based material, which enables high absorption over a wide range of incident angles and achieves high solar energy conversion efficiency.

SOLAR ENERGY MATERIALS AND SOLAR CELLS (2022)

Article Green & Sustainable Science & Technology

Enhanced optical absorption and solar steam generation of CB-ATO hybrid nanofluids

Dan Qu et al.

Summary: In this study, a hybrid nanofluid consisting of carbon black and antimony doped tin oxide was developed to enhance the performance of a solar desalination system. The hybrid nanofluid showed improved stability and enhanced solar energy utilization compared to single-component nanofluids. Experimental results demonstrated that the addition of nanoparticles increased the evaporation efficiency by about four times. This study opens up new possibilities for the use of hybrid nanofluids in solar steam generation.

RENEWABLE ENERGY (2022)

Article Chemistry, Multidisciplinary

Solution-Processed All-Ceramic Plasmonic Metamaterials for Efficient Solar-Thermal Conversion over 100-727 °C

Yang Li et al.

Summary: The study has developed a high-performance plasmonic metamaterial selective absorber with high solar absorption efficiency, low infrared emission, and excellent temperature stability. Compared to vacuum-deposited absorbers, this solution-processed absorber has lower cost and performs exceptionally well in both low- and high-temperature solar thermal applications.

ADVANCED MATERIALS (2021)

Article Energy & Fuels

Efficiency enhancement of a solar trough collector by combining solar and hot mirrors

Yu Qiu et al.

Summary: The parabolic trough collector with a modified receiver enhanced by solar and hot mirrors can achieve higher optical efficiency compared to conventional receivers, especially under high irradiance and low temperature conditions. The addition of solar and hot mirrors can effectively improve the optical-thermal efficiency of the collector.

APPLIED ENERGY (2021)

Article Thermodynamics

A novel evacuated receiver improved by a spectral-selective glass cover and rabbit-ear mirrors for parabolic trough collector

Yu Qiu et al.

Summary: Improving the efficiency of the evacuated receiver in a parabolic trough solar plant significantly enhances performance. Four novel modified receivers were designed, with results suggesting that mirrors and heat-reflecting films can improve optical and thermal efficiencies. The modified receiver using only inner film and mirrors showed the highest efficiency compared to others, making it the optimal design for enhancing receiver performance.

ENERGY CONVERSION AND MANAGEMENT (2021)

Article Optics

Tailoring radiative properties of a complex trapezoidal grating solar absorber by coupling between SPP and multi-order MP for solar energy harvesting

Wen-Wen Zhang et al.

Summary: This study focused on the coupling resonance effect between surface plasmon polariton (SPP) and multi-mode magnetic polariton (MP) using a complex trapezoidal grating solar absorber. The research revealed the detailed coupling between SPP and multi-mode MP, explored the impact of geometric parameters on resonance conditions, and demonstrated the potential for manual control of absorptance in the structure. Additionally, high solar-thermal conversion efficiency and stable directional absorptance for a wide range of incident angles were achieved, with observations of abnormal behaviors due to Wood's anomaly. The findings offer valuable insights for optimizing solar absorber design.

OPTICS COMMUNICATIONS (2021)

Article Energy & Fuels

A perfect selective metamaterial absorber for high-temperature solar energy harvesting

Yu Qiu et al.

Summary: The paper introduces a selective metamaterial absorber with four-pointed star prisms, obtaining perfect spectrally selective performance through optimization. The optimal absorber demonstrates high solar-to-heat efficiency in high-temperature solar applications.

SOLAR ENERGY (2021)

Article Chemistry, Physical

Efficient radiative cooling coating with biomimetic human skin wrinkle structure

Ziming Cheng et al.

Summary: This study proposes a novel approach using biomimetic wrinkle structure combined with optimized particles to achieve efficient optical property regulation in radiative cooling materials. The large-scale radiative cooling coating demonstrated high reflectance of solar irradiance and high emissivity in the atmospheric window band. Outdoor-building tests confirmed significant reductions in indoor air temperature and energy-saving rates exceeding 50% when using the coating.

NANO ENERGY (2021)

Article Thermodynamics

Design and experimental study of a 30 kWe adjustable solar simulator delivering high and uniform flux

Jikang Wang et al.

Summary: A new high-flux solar simulator (HFSS) was designed to achieve good compromise between flux uniformity and peak flux. Error and sensitivity analysis confirmed the feasibility of the HFSS, showing that the system performance can meet the experimental requirements.

APPLIED THERMAL ENGINEERING (2021)

Article Physics, Multidisciplinary

Polarization-Independent Broadband Optical Regime Metamaterial Absorber for Solar Harvesting: A Numerical Approach

Ismail Hossain et al.

Summary: This article introduces a broadband metamaterial (MTM) absorber that demonstrates near-unity absorption in the terahertz regime. The proposed absorber shows symmetrical structure with polarization-insensitive behavior up to 90 degrees, as well as large bandwidth and minimal impact on cross-polarization.

CHINESE JOURNAL OF PHYSICS (2021)

Article Thermodynamics

Measurement and modeling of thermal conductivity for short chain methyl esters: Methyl butyrate and methyl caproate

Xiong Zheng et al.

Summary: Fatty acid methyl esters (FAMEs) are the main component of biodiesels. It is essential to investigate the thermophysical properties of FAMEs before their industrial application. Experimental and theoretical studies were conducted on the thermal conductivities of two short-chain FAMEs, leading to accurate data and the identification of a reliable model for predicting FAME thermal conductivities.

JOURNAL OF CHEMICAL THERMODYNAMICS (2021)

Article Multidisciplinary Sciences

Conceptual-based design of an ultrabroadband microwave metamaterial absorber

Sichao Qu et al.

Summary: By introducing metallic ring structural dipole resonances in the micro-wave regime, a metamaterial absorber with hierarchical structures has been designed and realized to achieve high absorption rates and efficiency. The absorber shows improved performance in terms of absorption, bandwidth, and thickness.

PROCEEDINGS OF THE NATIONAL ACADEMY OF SCIENCES OF THE UNITED STATES OF AMERICA (2021)

Article Energy & Fuels

Thermal-fluid-mechanical analysis of tubular solar receiver panels using supercritical CO2 as heat transfer fluid under non-uniform solar flux distribution

Kun Wang et al.

Summary: This study investigates the thermal-fluid-mechanical characteristics of S-CO2 tubular solar receiver panels under non-uniform solar flux distribution. The results indicate that adjusting flow arrangements to match solar flux distribution can improve performance.

SOLAR ENERGY (2021)

Article Nanoscience & Nanotechnology

Nanometer-Thick High-Entropy Alloy Nitride Al0.4Hf0.6NbTaTiZrN-Based Solar Selective Absorber Coatings

Shuai-Sheng Zhao et al.

Summary: A highly efficient solar selective absorber coating has been successfully developed, with high solar absorptance and low emittance, maintaining a high solar-thermal conversion efficiency at high temperatures. Comprehensive studies on optical properties, microstructure, element distribution, and failure mechanism provide important insights for the application of this coating in solar energy harvesting.

ACS APPLIED NANO MATERIALS (2021)

Article Green & Sustainable Science & Technology

Ultra-wideband solar absorber based on refractory titanium metal

Peiqi Yu et al.

RENEWABLE ENERGY (2020)

Article Materials Science, Multidisciplinary

Refractory Ultrathin Nanocomposite Solar Absorber with Superior Spectral Selectivity and Thermal Stability

Aikifa Raza et al.

ADVANCED OPTICAL MATERIALS (2020)

Article Nanoscience & Nanotechnology

A near-ideal solar selective absorber with strong broadband optical absorption from UV to NIR

Xiaoyun Jiang et al.

NANOTECHNOLOGY (2020)

Article Physics, Condensed Matter

Numerical investigation of gold metasurface based broadband near -infrared and near -visible solar absorber

Juveriya Parmar et al.

PHYSICA B-CONDENSED MATTER (2020)

Article Chemistry, Physical

A Near-Infrared Perfect Absorber Assisted by Tungsten-Covered Ridges

Buzheng Wei et al.

PLASMONICS (2019)

Article Materials Science, Coatings & Films

Enhanced properties of tungsten films by high-power impulse magnetron sputtering

A. M. Engwall et al.

SURFACE & COATINGS TECHNOLOGY (2019)

Article Materials Science, Multidisciplinary

Solar thermal absorber based on dielectric filled two-dimensional nickel grating

Qiuqun Liang et al.

OPTICAL MATERIALS EXPRESS (2019)

Article Multidisciplinary Sciences

Metamaterial emitter for thermophotovoltaics stable up to 1400°C

Manohar Chirumamilla et al.

SCIENTIFIC REPORTS (2019)

Article Green & Sustainable Science & Technology

Estimating the cost of high temperature liquid metal based concentrated solar power

Gregory Wilk et al.

JOURNAL OF RENEWABLE AND SUSTAINABLE ENERGY (2018)

Article Engineering, Electrical & Electronic

Nearly perfect metamaterial plasmonic absorbers for solar energy applications

Nihal F. F. Areed et al.

OPTICAL AND QUANTUM ELECTRONICS (2018)

Review Green & Sustainable Science & Technology

A comprehensive review of state-of-the-art concentrating solar power (CSP) technologies: Current status and research trends

Md Tasbirul Islam et al.

RENEWABLE & SUSTAINABLE ENERGY REVIEWS (2018)

Article Multidisciplinary Sciences

Tungsten-based Ultrathin Absorber for Visible Regime

Ahsan Sarwar Rana et al.

SCIENTIFIC REPORTS (2018)

Article Thermodynamics

A Computational Simulation of Using Tungsten Gratings in Near-Field Thermophotovoltaic Devices

J. I. Watjen et al.

JOURNAL OF HEAT TRANSFER-TRANSACTIONS OF THE ASME (2017)

Article Thermodynamics

Tungsten Nanowire Metamaterials as Selective Solar Thermal Absorbers by Excitation of Magnetic Polaritons

Jui-Yung Chang et al.

JOURNAL OF HEAT TRANSFER-TRANSACTIONS OF THE ASME (2017)

Article Energy & Fuels

Advances in central receivers for concentrating solar applications

Clifford K. Ho

SOLAR ENERGY (2017)

Article Multidisciplinary Sciences

Broadband near-infrared metamaterial absorbers utilizing highly lossy metals

Fei Ding et al.

SCIENTIFIC REPORTS (2016)

Article Energy & Fuels

Highly efficient selective metamaterial absorber for high-temperature solar thermal energy harvesting

Hao Wang et al.

SOLAR ENERGY MATERIALS AND SOLAR CELLS (2015)

Review Chemistry, Multidisciplinary

A review of cermet-based spectrally selective solar absorbers

Feng Cao et al.

ENERGY & ENVIRONMENTAL SCIENCE (2014)

Review Green & Sustainable Science & Technology

Review of high-temperature central receiver designs for concentrating solar power

Clifford K. Ho et al.

RENEWABLE & SUSTAINABLE ENERGY REVIEWS (2014)

Article Multidisciplinary Sciences

Impedance matched thin metamaterials make metals absorbing

N. Mattiucci et al.

SCIENTIFIC REPORTS (2013)

Article Green & Sustainable Science & Technology

A MCRT and FVM coupled simulation method for energy conversion process in parabolic trough solar collector

Ya-Ling He et al.

RENEWABLE ENERGY (2011)

Article Chemistry, Multidisciplinary

Large Enhancement of Nonlinear Optical Phenomena by Plasmonic Nanocavity Gratings

Patrice Genevet et al.

NANO LETTERS (2010)

Article Materials Science, Multidisciplinary

Breakdown of the Planck blackbody radiation law at nanoscale gaps

Arvind Narayanaswamy et al.

APPLIED PHYSICS A-MATERIALS SCIENCE & PROCESSING (2009)

Article Materials Science, Multidisciplinary

A comparative morphological study of electron beam co-deposited binary optical thin films of HfO2:SiO2 and ZrO2:SiO2

R. B. Tokas et al.

CURRENT APPLIED PHYSICS (2008)

Article Physics, Multidisciplinary

Subwavelength discrete solitons in nonlinear metamaterials

Yongmin Liu et al.

PHYSICAL REVIEW LETTERS (2007)

Article Physics, Applied

Thermal radiation from two-dimensionally confined modes in microcavities

S Maruyama et al.

APPLIED PHYSICS LETTERS (2001)

Article Engineering, Electrical & Electronic

High resolution inductively coupled plasma etching of 30 nm lines and spaces in tungsten and silicon

AL Goodyear et al.

JOURNAL OF VACUUM SCIENCE & TECHNOLOGY B (2000)