4.7 Article

Room-temperature hydrogen gas sensor composed of palladium thin film deposited on NiCo2O4 nanoneedle forest

Journal

SENSORS AND ACTUATORS B-CHEMICAL
Volume 376, Issue -, Pages -

Publisher

ELSEVIER SCIENCE SA
DOI: 10.1016/j.snb.2022.132958

Keywords

Gas sensor; Room temperature; Palladium; Hydrogen sensor

Ask authors/readers for more resources

This paper presents a sensitive Pd gas sensor with a NiCo2O4 nanoneedle forest (NNF) for the detection of hydrogen (H2). The Pd film on NiCo2O4 NNF maximized the reactive surface area with H2, resulting in excellent sensitivity and response speed. Integrated with a temperature sensor and heater using MEMS processes, the sensor's sensitivity and response speed can be adjusted by controlling the operating temperature. The proposed sensor exhibited fast response and recovery times at both room temperature (RT) and 300°C, with linear response and high sensitivity at RT and faster response at higher temperatures. The sensor can be utilized as a low-power, high-sensitivity sensor at RT or as a fast-response sensor at elevated temperatures using an integrated heater.
This paper reports the performance and fabrication method of a palladium (Pd) gas sensor with a NiCo2O4 nanoneedle forest (NNF) that is very sensitive to hydrogen (H2). The Pd surface area that could react with H2 was maximized by sputtering Pd on NiCo2O4 NNF, which resulted in excellent sensitivity and response speed. Also, the temperature sensor and heater are integrated by using microelectromechanical system (MEMS) processes, where the sensitivity, as well as the response and recovery speeds, can be adjusted by controlling the operation temperature. The proposed sensor showed relative resistance changes of at RT and at 300 degrees C when saturated with a H2 concentration of 300 ppm. The response times were as fast as 117 and 102 s at RT for the rising and recovering cycles, respectively. However, at 300 degrees C, the response times in the rising and recovery cycles were 26 and 23 s, respectively, which were faster than those at RT. The sensor response at RT was linear throughout the measurement range, with a sensitivity of and a detection limit of 28 ppb. Therefore, the proposed sensor can be used as a low-power, high-sensitivity sensor at RT or as a sensor with a fast response time at a high operating temperature using an integrated heater.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.7
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available