4.7 Article

On the crown formation and cavity dynamics of free-falling thick disks

Related references

Note: Only part of the references are listed.
Article Mechanics

Effects of immiscible interface and particle channelization on particle dynamics of oblique oily sand jets

Mahsa Janati et al.

Summary: This paper investigates the evolution of oblique sand jets passing through a thin layer of oil and entering stagnant water known as oily sand jets. Two scaling parameters, aspect ratio and particle to nozzle size ratio, were found to control the evolution of oily sand jets. The width of the oblique oily sand jets increased as they descended into water, and was greater than the width of vertical sand jets without an oil layer. A two-stage cluster bursting was observed due to the excess shear stress between the outer boundary of clusters and the ambient water. Particle channelization was found as the main factor affecting the magnitude of shear stress at the boundary of sand clusters.

PHYSICS OF FLUIDS (2022)

Article Mechanics

Accurate predictions of chaotic motion of a free fall disk

Tianzhuang Xu et al.

Summary: Research shows that accurate predictions of chaotic trajectories of free-fall objects can be achieved using the Clean Numerical Simulation (CNS), while traditional algorithms in double precision provide relatively poor predictions. The CNS can reliably predict the posture of free-falling objects near bifurcation points of physical parameters over a long duration.

PHYSICS OF FLUIDS (2021)

Article Mathematics, Interdisciplinary Applications

Updated Lagrangian particle hydrodynamics (ULPH) modeling of solid object water entry problems

Jiale Yan et al.

Summary: The ULPH method, a Lagrangian meshfree particle method, is enhanced and applied to simulate solid object water entry problems, showing advantages in handling negative pressure and spurious tensile instability. The stability and accuracy of the ULPH approach in simulating water entry problems have been validated through several 2D and 3D examples, demonstrating good agreement with experimental data.

COMPUTATIONAL MECHANICS (2021)

Article Engineering, Mechanical

Mixing of Twin Particle Clouds in Stagnant Water

Mahsa Janati et al.

Summary: The study investigated the interaction and mixing of twin particle clouds in stagnant water through laboratory experiments, focusing on source separation distance and sand particle mass. A critical source separation distance was identified based on maximum frontal velocity and minimum mass loss of the twin particle clouds. The study also found that the maximum cloud width occurred at a nondimensional time of t/T=0.5, and the boundary depth between thermal and swarm regimes in twin particle clouds occurred at t/T=1.4, regardless of initial conditions or source separation distances.

JOURNAL OF ENGINEERING MECHANICS (2021)

Article Mechanics

Impact force reduction by consecutive water entry of spheres

Rafsan Rabbi et al.

Summary: The study shows that throwing another object in front of a free-falling object impacting onto water surface can reduce the impact force in some cases, but the effect varies under different conditions. The formation of cavity by the first object and the timing of impact by the second object are found to influence the impact acceleration on the trailing object.

JOURNAL OF FLUID MECHANICS (2021)

Article Engineering, Mechanical

On the Motion of Single and Twin Oblique Particle Clouds in Stagnant Water

Mahsa Janati et al.

Summary: The evolution of single and twin oblique particle clouds in stagnant water was investigated in laboratory experiments, with parameters such as sand mass and nozzle spacing being studied. The effects of release angle and particle interactions on the clouds were analyzed, showing that the velocity of twin oblique particle clouds increased with nozzle spacing. Particle interactions due to frontal head collision in twin oblique particle clouds significantly increased the cloud width until reaching the swarm phase.

JOURNAL OF FLUIDS ENGINEERING-TRANSACTIONS OF THE ASME (2021)

Article Mechanics

Eccentric disks falling in water

Xinping Zhou et al.

Summary: This paper experimentally investigates the falling regimes of eccentric disks in water and finds that eccentricity is a significant parameter when describing the descent modes. Sufficiently large eccentricity stabilizes freely falling disks, while small eccentricity results in chaotic and tumbling motions.

PHYSICS OF FLUIDS (2021)

Article Mechanics

Viscoplastic water entry

Maziyar Jalaal et al.

JOURNAL OF FLUID MECHANICS (2019)

Article Mechanics

The water entry of multi-droplet streams and jets

Nathan B. Speirs et al.

JOURNAL OF FLUID MECHANICS (2018)

Article Engineering, Multidisciplinary

Experimental study on the vortex structure and path instability of freely falling annular disks

Bi DianFang et al.

SCIENCE CHINA-TECHNOLOGICAL SCIENCES (2018)

Article Engineering, Mechanical

Experimental Investigation of Sand Jets Passing Through Immiscible Fluids

Niyousha Mohammadidinani et al.

JOURNAL OF FLUIDS ENGINEERING-TRANSACTIONS OF THE ASME (2017)

Article Mechanics

Holes stabilize freely falling coins

Lionel Vincent et al.

JOURNAL OF FLUID MECHANICS (2016)

Article Mechanics

Crown sealing and buckling instability during water entry of spheres

J. O. Marston et al.

JOURNAL OF FLUID MECHANICS (2016)

Article Engineering, Multidisciplinary

Numerical Investigation of Water Entry of Half Hydrophilic and Half Hydrophobic Spheres

Sun Zhao et al.

MATHEMATICAL PROBLEMS IN ENGINEERING (2016)

Article Mechanics

Water entry without surface seal: extended cavity formation

M. M. Mansoor et al.

JOURNAL OF FLUID MECHANICS (2014)

Article Mechanics

Coins falling in water

Luke Heisinger et al.

JOURNAL OF FLUID MECHANICS (2014)

Article Mechanics

Falling styles of disks

Franck Auguste et al.

JOURNAL OF FLUID MECHANICS (2013)

Article Mechanics

Computational investigation of vertical slurry jets in water

Amir Hossein Azimi et al.

INTERNATIONAL JOURNAL OF MULTIPHASE FLOW (2012)

Article Mechanics

Experimental study of sand jet front in water

Amir Hossein Azimi et al.

INTERNATIONAL JOURNAL OF MULTIPHASE FLOW (2012)

Article Mechanics

Cavity formation by the impact of Leidenfrost spheres

J. O. Marston et al.

JOURNAL OF FLUID MECHANICS (2012)

Review Mechanics

Hull Slamming

Serge Abrate

APPLIED MECHANICS REVIEWS (2011)

Review Multidisciplinary Sciences

Slamming of ships: where are we now?

G. K. Kapsenberg

PHILOSOPHICAL TRANSACTIONS OF THE ROYAL SOCIETY A-MATHEMATICAL PHYSICAL AND ENGINEERING SCIENCES (2011)

Article Mechanics

The water entry of decelerating spheres

Jeffrey M. Aristoff et al.

PHYSICS OF FLUIDS (2010)

Article Mechanics

Water entry of small hydrophobic spheres

Jeffrey M. Aristoff et al.

JOURNAL OF FLUID MECHANICS (2009)

Article Mechanics

Water entry of spinning spheres

Tadd T. Truscott et al.

JOURNAL OF FLUID MECHANICS (2009)

Article Mechanics

Controlled impact of a disk on a water surface: cavity dynamics

Raymond Bergmann et al.

JOURNAL OF FLUID MECHANICS (2009)

Article Chemistry, Multidisciplinary

Impact of a superhydrophobic sphere onto water

Duck-Gyu Lee et al.

LANGMUIR (2008)

Article Mechanics

Dynamics of transient cavities

V. Duclaux et al.

JOURNAL OF FLUID MECHANICS (2007)

Article Physics, Multidisciplinary

Making a splash with water repellency

Cyril Duez et al.

NATURE PHYSICS (2007)

Review Engineering, Mechanical

Review of water entry with applications to aerospace structures

CM Seddon et al.

INTERNATIONAL JOURNAL OF IMPACT ENGINEERING (2006)