4.7 Article

Active control for stick-slip behavior of the marine propeller shaft subjected to friction-induced vibration

Related references

Note: Only part of the references are listed.
Article Engineering, Mechanical

Analytical Approximations for Dry Friction-Induced Stick-Slip and Pure-Slip Vibration Amplitudes of a Self-Excited Smooth and Discontinuous Oscillator

Junfeng Yan et al.

Summary: This paper presents an investigation into pure-slip and stick-slip oscillations induced by dry friction. The friction force is modeled using the Stribeck effect. Perturbation methods are used to establish approximate analytical expressions for the occurring conditions, vibration amplitudes, and base frequencies of the oscillations. The accuracy of the analytical approximations is verified through numerical simulations.

JOURNAL OF COMPUTATIONAL AND NONLINEAR DYNAMICS (2022)

Article Engineering, Marine

Impact factors on friction induced vibration of shaft-bearing system considering stick-slip behavior

Qianwen Huang et al.

Summary: An appropriate assessment of the dynamical response of the marine propeller shaft is crucial for optimal power delivery to the propeller and minimizing unnecessary mechanical friction of supporting bearings. This study proposes a numerical model to analyze friction-induced vibration with velocity-dependent and stick-slip friction, and validates a Newton-Raphson & Newmark-fl solving method to solve the nonlinear model. The response of the dynamic friction coefficient, relative velocity, and reaction force are obtained, and an optimized design for the propeller shaft and supporting bearings is achieved based on the proposed numerical model.

MARINE STRUCTURES (2022)

Article Chemistry, Analytical

Stick-Slip Vibration Suppression in Drill String Using Observer-Based LQG Controller

Rami Riane et al.

Summary: This paper aims to eliminate severe stick-slip vibrations along the drill string of a rotary drilling system using the LQG observer-based controller approach. An observer was designed to estimate unknown inputs, and a controller with 10 degrees of freedom was implemented in the drill string model. Simulation and experimental results showed that the proposed controller had better performance and robustness compared to other controllers. It is recommended to use this approach in smart rotary drilling systems.

SENSORS (2022)

Article Acoustics

Active vibration control and stability analysis of a time-delay system subjected to friction-induced vibration

J-J Sinou et al.

Summary: This paper discusses a strategy for estimating the critical time delay in the problem of Friction-Induced Vibration and Noise (FIVE) by conducting stability analysis and frequency sweep test. The proposed approach is illustrated to be efficient through numerical examples, providing a clear understanding and illustration of the phenomena involved and observed.

JOURNAL OF SOUND AND VIBRATION (2021)

Article Physics, Multidisciplinary

Feedback control method to suppress stick-slip in drill-strings featuring delay and actuation constraints

James D. J. MacLean et al.

Summary: This study numerically investigates the performance of a modified-integral resonant controller with integral tracking under actuator delay and constraints. The control scheme is found to be highly effective at coping with these limitations and outperforming sliding-mode control in various operational regimes. Detailed analysis by varying gains and system parameters, especially actuation delay, is performed to further understand the scheme's behavior.

EUROPEAN PHYSICAL JOURNAL-SPECIAL TOPICS (2021)

Article Automation & Control Systems

Design and Hardware in-the-Loop Validation of an Effective Super-Twisting Controller for Stick-Slip Suppression in Drill-String Systems

Abdelbasset Krama et al.

Summary: This paper presents a novel controller for drill string systems based on a super-twisting sliding mode theory that aims to eliminate stick-slip vibration and maintain a constant drill string velocity. By considering a torsional model of drill strings and adopting a friction model for bit-rock interaction, the proposed controller demonstrates high efficiency and stability while controlling the drill string dynamics.

JOURNAL OF DYNAMIC SYSTEMS MEASUREMENT AND CONTROL-TRANSACTIONS OF THE ASME (2021)

Article Engineering, Marine

Study on bearing force of marine propeller induced by longitudinal vibration of propulsion-shafting*

Donglin Zou et al.

SHIPS AND OFFSHORE STRUCTURES (2020)

Article Engineering, Mechanical

Research and experimental analysis of drill string dynamics characteristics and stick-slip reduction mechanism

Jialin Tian et al.

JOURNAL OF MECHANICAL SCIENCE AND TECHNOLOGY (2020)

Article Engineering, Mechanical

On the wear of dynamically-loaded engine bearings with provision for misalignment and surface roughness

J. Y. Jang et al.

TRIBOLOGY INTERNATIONAL (2020)

Article Engineering, Mechanical

Coupled dynamic analysis of a heavily-loaded propulsion shafting system with continuous bearing-shaft friction

Zhenguo Zhang et al.

INTERNATIONAL JOURNAL OF MECHANICAL SCIENCES (2020)

Article Engineering, Multidisciplinary

Stick-slip suppression and speed tuning for a drill-string system via proportional-derivative control

Wei Lin et al.

APPLIED MATHEMATICAL MODELLING (2020)

Article Engineering, Mechanical

Friction-induced stick-slip vibration and its experimental validation

X. C. Wang et al.

MECHANICAL SYSTEMS AND SIGNAL PROCESSING (2020)

Article Automation & Control Systems

Research on Dynamic Characteristic of Marine Shafting-Oil Film-Stern Structure System

Liang-Xiong Dong et al.

JOURNAL OF DYNAMIC SYSTEMS MEASUREMENT AND CONTROL-TRANSACTIONS OF THE ASME (2019)

Article Engineering, Mechanical

Revealing transitions in friction-excited vibrations by nonlinear time-series analysis

Merten Stender et al.

NONLINEAR DYNAMICS (2019)

Article Engineering, Mechanical

Influence of temperature on friction of polymeric materials in water

Jian Huang et al.

Article Chemistry, Physical

Friction weakening by mechanical vibrations: A velocity-controlled process

V. Vidal et al.

EUROPEAN PHYSICAL JOURNAL E (2019)

Article Acoustics

Nonlinear control of stick-slip oscillations by normal force modulation

Jyayasi Nath et al.

JOURNAL OF VIBRATION AND CONTROL (2018)

Article Engineering, Mechanical

Stick-slip behaviours of water lubrication polymer materials under low speed conditions

Conglin Dong et al.

TRIBOLOGY INTERNATIONAL (2017)

Article Engineering, Mechanical

On the Stribeck Curves for Lubricated Counterformal Contacts of Rough Surfaces

Dong Zhu et al.

JOURNAL OF TRIBOLOGY-TRANSACTIONS OF THE ASME (2015)

Article Engineering, Mechanical

Experimental investigation of film pressure distribution in water-lubricated rubber journal bearings

Tao Geng et al.

PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART J-JOURNAL OF ENGINEERING TRIBOLOGY (2014)

Article Engineering, Marine

Research on shafting alignment considering ship hull deformations

Lei Shi et al.

MARINE STRUCTURES (2010)

Article Engineering, Mechanical

The Stribeck curve and lubrication design for non-fully wetted surfaces

M. Kalin et al.

Article Engineering, Mechanical

Calculation of Stribeck curves for (water) lubricated journal bearings

Alex de Kraker et al.

TRIBOLOGY INTERNATIONAL (2007)