4.5 Article

Petrogenesis and Geochemistry of Archean Komatiites

Journal

JOURNAL OF PETROLOGY
Volume 57, Issue 1, Pages 147-184

Publisher

OXFORD UNIV PRESS
DOI: 10.1093/petrology/egw004

Keywords

komatiite; partial melting; geochemistry; thermodynamics; temperature; mantle plume

Funding

  1. Australian Postgraduate Award
  2. ANU Vice-Chancellor's Scholarship
  3. Australian Research Council [DP130101355]

Ask authors/readers for more resources

Komatiites are products of decompression melting of mantle so hot that they are almost exclusively restricted to the Archean. The high degree of partial melting (F) and pressure (P) required for their generation facilitates comparison between the magma composition and its mantle source. To investigate compositional variations in Archean komatiites, a global selection of 38 Archean komatiites spanning five cratons (Kaapvaal, Zimbabwe, Yilgarn, Pilbara, Superior) were analysed for their major and trace element contents. Included are the Aluminium-Depleted (ADK, Barberton-Type) and Aluminium-Undepleted (AUK, Munro-Type) petrogenetic types that have been equated with high P/moderate F and moderate P/high F, respectively, on the basis of their Al/Ti and Gd/Yb ratios. Following calculation of the primary magma composition of each suite, we show that the absolute Al content at a specified MgO proves a more sensitive indicator of P than either of the above two ratios and hence we introduce a new classification using Al. The Mg# is a reliable proxy for F, independent of the two endmember melting styles, fractional and batch. We demonstrate that most komatiites form by batch melting, ceding to fractional melting with decreasing pressure as the density contrast between the liquid and solid grows. The Munro AUKs are the only suite to show evidence of fractional melting, with melt extraction occurring at the lowest F and P, a parts per thousand 25% melting at 5 GPa (mantle potential temperature, T-P = 1750A degrees C) whereas the ADKs of Barberton segregated at the highest F and P (a parts per thousand 40%, 9 GPa, T-P = 1950A degrees C). The petrogenetic type is a combination of P and F, where, at a given pressure, higher F will produce AUKs over ADKs as majorite is consumed in the source. Through numerical simulations, it is shown that both types can occur within the same mantle plume, with ADKs forming in its cooler, distal fringes whereas AUKs occur along its axis. Furthermore, and contrary to previous views, there is no temporal distinction between the two komatiite types, with both AUKs and ADKs occurring throughout the Archean. By contrast, younger, 2 center dot 7 Ga komatiites tend to have sources that are more depleted than those of older, 3 center dot 5 Ga komatiites. Komatiites are invaluable records of the mantle's chemical and physical evolution during the Archean.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.5
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available