Electro-oxidation of propylene by palladium functionalized titanium hollow fibre electrodes

The performance of Pd functionalized titanium hollow fibre electrodes (Pd@Ti-HFEs) in the electro-oxidation of propylene was investigated at pH 1 and pH 4 and at applied potentials ranging from 0.7 to 1.2 V vs RHE. Larger quantities of products were obtained at pH 1 in comparison to pH 4, mainly due to extensive dissolution of Pd to Pd2+ in the range of 0.9-1.1 V, initiating a homogeneous chemical reaction of propylene and water to form acetone and Pd nanoparticles. At the lower end of the applied potentials (0.7-0.9 V), allyl alcohol and acrolein are formed, likely heterogeneously by the Pd surface. At the most oxidative potential investigated (1.2 V), acetone production decreases, while propylene gly-col and CO2 emerge as reaction products. PdO2 likely forms at these potentials, limiting dissolution and inducing the shift in product selectivity. At pH 4, allyl alcohol and acrolein were detected in the elec-trolyte up to 1.1 V, while quantities of acetone were significantly smaller than observed at pH 1 at this potential. SEM images show extensive dissolution of Pd does not occur at pH 4, and formation of PdO is favored, as confirmed by post-analysis by XPS. At 1.2 V, quantities of propylene glycol again increase. Varying the flow rate of propylene through the HFE did not affect the product distribution, indicating that mass transfer limitations are likely absent. By taking results of cyclic voltammetry, and SEM and XPS of used electrodes into consideration, we provide an illustration of the correlation between electrode mor-phology and composition, and the product selectivity.(c) 2022 Published by Elsevier Inc.

Automated summary

The performance of Pd-functionalized titanium hollow fibre electrodes in the electro-oxidation of propylene was investigated. The pH and applied potentials significantly affected the product distribution, with Pd dissolution and PdO2 formation playing important roles.