Effect of active cooling on the thermal effect of electromagnetic rail under single launch mode

In order to investigate the influence of active cooling on the rail thermal effect of electromagnetic gun under single launch mode, characteristics of the peak temperature, cross-section current density and temperature distribution, axial temperature distribution of rail with and without active cooling are simulated. In addition, the time-varying characteristics of the rail axial temperature distribution, the temperature time-varying character-istic in different temperature parts on the rail and the influence of the cooling water flow velocity on the tem-perature in different temperature parts are experimentally studied. The results show that during the launch, there is almost no difference between the rail peak temperature and its location with and without active cooling, and the peak temperature is basically located at the initial position of the armature. Without active cooling, the rail axial temperature distribution shows a trend of higher at the gun tail and lower at the gun muzzle. The current density and temperature distribution of rail cross-section show a trend of higher on the rail inner side and lower on the rail outer side, and the diffusion of heat lags behind the diffusion of current. Under the action of active cooling, the rail peak temperature will move to the muzzle along the armature moving direction, and there is a thermal inversion phenomenon. The rail cross-section temperature drops faster, and the lowest temperature region appears near the middle cooling channel. Active cooling has different effects on rail temperature in different temperature parts. In the high-temperature part, the rail temperature decreases monotonically with the increase of cooling water flow velocity, increasing the water velocity can accelerate the decline of rail tem-perature. In the middle-temperature parts, the variation trend of rail temperature is different with different water flow velocities. At low water velocity, the rail temperature increases gradually. When the water flow velocity is greater than 0.75 m/s, the phenomenon of thermal inversion will occur. i.e., the rail temperature increases first and then decreases. In the low-temperature part, thermal inversion will occur at different flow velocities, that is, the rail temperature increases first and then decreases. When the water flow velocity is greater than 1.0 m/s, the improvement of rail cooling effect will no longer be obvious. It is suggested that the appropriate water flow velocity is 0.75-1.0 m/s under the present experimental conditions.

Automated summary

This study investigates the influence of active cooling on the rail thermal effect of an electromagnetic gun under single launch mode. Simulation and experimental results show that active cooling does not significantly affect the peak temperature and its location of the rail, but it improves the temperature distribution along the rail. The appropriate water flow velocity can accelerate the decrease of rail temperature.