Related references
Note: Only part of the references are listed.Thermal performance augmentation in round tube with louvered V-winglet vortex generator
Pongjet Promvonge et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2022)
Thermal-hydraulic performance in a tube with punched delta winglets inserts in turbulent flow
Jiangbo Wang et al.
INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2022)
Influence of a novel serrated wire coil insert on thermal characteristics and air flow behavior in a tubular heat exchanger
Teerapat Chompookham et al.
INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2022)
Thermohydraulic performance and entropy generation in heat exchanger tube with louvered winglet tapes
Pongjet Promvonge et al.
INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2022)
Experimental investigation of performance improvement of double-pipe heat exchangers with novel perforated elliptic turbulators
M. E. Nakhchi et al.
INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2021)
Enhanced thermal performance in tubular heat exchanger contained with V-shaped baffles
Pongjet Promvonge et al.
APPLIED THERMAL ENGINEERING (2021)
Numerical study of turbulent flow inside heat exchangers using perforated louvered strip inserts
M. E. Nakhchi et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2020)
Experimental and numerical heat transfer study of turbulent tube flow through discrete V-winglets
Pongjet Promvonge et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2020)
CFD approach for two-phase CuO nanofluid flow through heat exchangers enhanced by double perforated louvered strip insert
M. E. Nakhchi et al.
POWDER TECHNOLOGY (2020)
Effects of the configuration of winglet vortex generators on turbulent heat transfer enhancement in circular tubes
Kang Zhang et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2020)
Performance evaluation of the characteristics of flow and heat transfer in a tube equipped with twisted tapes of new configurations
Mohsen H. Fagr et al.
INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2020)
Thermal-fluidic correlations for turbulent flow in a serpentine heat exchanger with novel wing-shaped turbulators
Tong-Miin Liou et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2020)
Augmented heat transfer in tubular heat exchanger fitted with V-baffled tapes
Pongjet Promvonge et al.
INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2020)
A computational study of heat transfer analysis for a circular tube with conical ring turbulators
Mostafa M. Ibrahim et al.
INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2019)
Heat transfer in solar receiver heat exchanger with combined punched-V-ribs and chamfer-V-grooves
Pongjet Promvonge et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2019)
Thermal performance of heat exchanger tube inserted with curved-winglet tapes
Sompol Skullong et al.
APPLIED THERMAL ENGINEERING (2018)
Experimental investigation on heat transfer enhancement in a circular tube with equilateral triangle cross sectioned coiled-wire inserts
Orhan Keklikcioglu et al.
APPLIED THERMAL ENGINEERING (2018)
Heat transfer and flow characteristics in a circular tube fitted with rectangular winglet vortex generators
Huan-ling Liu et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2018)
Numerical investigation of entropy generation of turbulent flow in a novel outward corrugated tube
Wei Wang et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2018)
Convective heat transfer enhancement using Ag-water nanofluid in a micro-fin tube combined with non-uniform twisted tape
Smith Eiamsa-ard et al.
INTERNATIONAL JOURNAL OF MECHANICAL SCIENCES (2018)
Thermal hydraulic characteristics of turbulent single-phase flow in an enhanced tube using louvered strip insert with various slant angles
Indri Yaningsih et al.
INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2018)
Entropy generation analysis for a circular tube with equilateral triangle cross sectioned coiled-wire inserts
Orhan Keklikcioglu et al.
ENERGY (2017)
Turbulent flow and heat transfer enhancement in a heat exchanger tube fitted with novel discrete inclined grooves
Nianben Zheng et al.
INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2017)
Thermal characteristic of a turbulent flow through a circular tube fitted with perforated vortex generator inserts
Sunil Chamoli et al.
APPLIED THERMAL ENGINEERING (2017)
Experimental and numerical heat transfer investigation in a tubular heat exchanger with delta-wing tape inserts
Sompol Skullong et al.
CHEMICAL ENGINEERING AND PROCESSING-PROCESS INTENSIFICATION (2016)
Experimental and numerical heat transfer investigation in turbulent square-duct flow through oblique horseshoe baffles
Sompol Skullong et al.
CHEMICAL ENGINEERING AND PROCESSING-PROCESS INTENSIFICATION (2016)
Heat transfer and entropy generation in a parabolic trough receiver with wall-detached twisted tape inserts
Aggrey Mwesigye et al.
INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2016)
Heat transfer enhancement in tubular heat exchanger with double V-ribbed twisted-tapes
Sombat Tamna et al.
CASE STUDIES IN THERMAL ENGINEERING (2016)
Enhancement of heat transfer by nanofluids and orientations of the equilateral triangular obstacle
M. Bovand et al.
ENERGY CONVERSION AND MANAGEMENT (2015)
Thermal performance enhancement in a heat exchanger tube fitted with inclined vortex rings
Pongjet Promvonge et al.
APPLIED THERMAL ENGINEERING (2014)
Experimental investigation of heat transfer coefficient and friction factor of ethylene glycol water based TiO2 nanofluid in double pipe heat exchanger with and without helical coil inserts
M. Chandra Sekhara Reddy et al.
INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER (2014)
A CFD based thermo-hydraulic performance analysis of an artificially roughened solar air heater having equilateral triangular sectioned rib roughness on the absorber plate
Anil Singh Yadav et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2014)
Laminar flow heat transfer enhancement in a circular tube having integral transverse rib roughness and fitted with centre-cleared twisted-tape
Suvanjan Bhattacharyya et al.
EXPERIMENTAL THERMAL AND FLUID SCIENCE (2013)
A comprehensive review on passive heat transfer enhancements in pipe exchangers
S. Liu et al.
RENEWABLE & SUSTAINABLE ENERGY REVIEWS (2013)
ENHANCEMENT OF HEAT TRANSFER OF LAMINAR FLOW OF VISCOUS OIL THROUGH A CIRCULAR TUBE HAVING INTEGRAL AXIAL RIB ROUGHNESS AND FITTED WITH HELICAL SCREW-TAPE INSERTS
Sujoy Kumar Saha et al.
HEAT TRANSFER RESEARCH (2012)
Heat transfer in square duct fitted diagonally with angle-finned tape-Part 2: Numerical study
Pongjet Promvonge et al.
INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER (2012)
Heat transfer in square duct fitted diagonally with angle-finned tape-Part 1: Experimental study
Pongjet Promvonge et al.
INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER (2012)
Parametric study on turbulent heat transfer and flow characteristics in a circular tube fitted with louvered strip inserts
A. W. Fan et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2012)
Heat transfer enhancement in a tube with equilateral triangle cross sectioned coiled wire inserts
Sibel Gunes et al.
EXPERIMENTAL THERMAL AND FLUID SCIENCE (2010)
Numerical prediction on laminar heat transfer in square duct with 30° angled baffle on one wall
Sutapat Kwankaomeng et al.
INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER (2010)
Thermal characterization of turbulent flow in a channel with isosceles triangular ribs
C. Thianpong et al.
INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER (2009)
Thermal performance in circular tube fitted with coiled square wires
Pongjet Promvonge
ENERGY CONVERSION AND MANAGEMENT (2008)
Effect of propeller type swirl generators on the entropy generation and efficiency of heat exchangers
Irfan Kurtbas et al.
INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2007)
Entropy generation and thermodynamic optimization of fully developed laminar convection in a helical coil
TH Ko et al.
INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER (2005)
Enhancement of heat transfer in a tube with regularly-spaced helical tape swirl generators
S Eiamsa-Ard et al.
SOLAR ENERGY (2005)
Share Paper
