4.7 Article

Chemical functional characterization of immature and mature coals at the nanoscale by atomic force microscopy-based infrared spectroscopy (AFM-IR)

Journal

INTERNATIONAL JOURNAL OF COAL GEOLOGY
Volume 267, Issue -, Pages -

Publisher

ELSEVIER
DOI: 10.1016/j.coal.2023.104196

Keywords

Coal; Kerogen; Atomic Force Microscopy -Infrared spectros; copy (AFM-IR); NanoIR3s

Ask authors/readers for more resources

Understanding the composition and molecular structure of kerogens and coals is crucial for their chemical evolution and by-products. The use of atomic force microscopy coupled with infrared spectroscopy (AFM-IR) allows for high spatial resolution and reveals chemical heterogeneity. However, there are systematic differences between AFM-IR and conventional micro-IR techniques, as well as between tapping and contact modes, which require further investigation.
Understanding the composition and molecular structure of kerogens and coals is a key issue in geochemistry, as these parameters control their chemical evolution and their by-products generated in sedimentary basins. As they are chemically heterogenous, investing their structure and composition at various spatial scales is essential and relies on a variety of micro-analytical tools. Conventional infrared (IR) microscopy has proven to be a powerful and promising approach to characterize these heterogeneous materials, but due to the diffraction limit, the spatial resolution cannot get below-1 mu m, and cannot measure individual submacerals, tiny mineral inclusions, and more generally cannot access to chemical variations at the nanometer scale. In contrast, atomic force mi-croscopy coupled to infrared spectroscopy (AFM-IR) attains a much higher spatial resolution, down to tens of nanometers. In this paper, AFM-IR measurements were collected on three immature and mature coals, with mean-maximum vitrinite reflectance R0 of 0.33%, 1.16%, and 2.8%. Measurements were collected in both tapping and contact modes, on samples prepared as sulfur embedded ultrathin sections and pressed on diamond windows. These spectral data were compared to spectra collected with conventional micro-IR microscopy (mu-FTIR). Spectra with a high quality could be obtained, which point to chemical heterogeneity at the sub -micrometer scale, and they display similar bands than those observed in spectra collected by means of con-ventional micro-IR. The signal-to-noise ratio was better in spectra collected in contact mode compared to tapping mode. The spatial resolution was around-100 nm in contact mode, while a resolution of at least 20 nm was achieved in tapping mode. Kaolinite was detected as a -500 nm grain included in organic matter. These results show that sulfur embedded ultrathin sections are as a suitable sample preparation for AFM-IR. However, sys-tematic differences are reported compared to spectra collected by conventional mu-FTIR, possibly due to an instrumental artifact that increases the absorption signal as the wavenumber is decreased. Similarly, systematic differences are observed between data collected in tapping and contact modes, along with a much broader chemical heterogeneity. These differences are not fully understood, and should be investigated further in future studies.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.7
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available