Related references
Note: Only part of the references are listed.Self-lubricating behavior caused by tribo-oxidation of Ti3SiC2/Cu composites in a wide temperature range
Rui Zhang et al.
CERAMICS INTERNATIONAL (2022)
Microstructure and Mechanical Properties of Composites Obtained by Spark Plasma Sintering of Ti3SiC2-15 vol.%Cu Mixtures
Rui Zhang et al.
MATERIALS (2022)
The Holes of Zn Phosphate and Hot Dip Galvanizing on Electrochemical Behaviors of Multi-Coatings on Steel Substrates
Thiago Duarte et al.
METALS (2022)
EIS Investigation of the Corrosion Behavior of Steel Bars Embedded into Modified Concretes with Eggshell Contents
Yuri Alexandre Meyer et al.
METALS (2022)
Influence of Cu content on the microstructure and mechanical property of Ti3SiC2/Cu composites
Shuai Ma et al.
MATERIALS RESEARCH EXPRESS (2022)
Preparation of Ti3SiC2 MAX phase from Ti, TiC, and SiC by SPS
Stefan Csaki et al.
CERAMICS INTERNATIONAL (2022)
Effect of thermal stability of Mn+1AXn phases on microstructure and mechanical properties of Mn+1AXn/ZA27 composites
Hai-Yan Li et al.
INTERNATIONAL JOURNAL OF APPLIED CERAMIC TECHNOLOGY (2021)
The Ti3SiC2 max phases as promising materials for high temperature applications: Formation under various synthesis conditions
S. N. Perevislov et al.
MATERIALS CHEMISTRY AND PHYSICS (2021)
Synthesis, microstructure, and mechanical properties of TiC-SiC-Ti3SiC2composites prepared by in situ reactive hot pressing
Nan Liao et al.
INTERNATIONAL JOURNAL OF APPLIED CERAMIC TECHNOLOGY (2020)
Evaluation of properties of spark plasma sintered Ti3SiC2 and Ti3SiC2/SiC composites
Bilge Yaman Islak et al.
CERAMICS INTERNATIONAL (2019)
Electrochemical Corrosion Behavior of as-cast Zn-rich Zn-Mg Alloys in a 0.06M NaCl Solution
Talita A. Vida et al.
INTERNATIONAL JOURNAL OF ELECTROCHEMICAL SCIENCE (2017)
The effects of Zn segregation and microstructure length scale on the corrosion behavior of a directionally solidified Mg-25 wt.%Zn alloy
Nathalia C. Verissimo et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2017)
Electrochemical study on the corrosion behavior of Ti3sic2 in 3.5% NaCl solution
Ming Zhu et al.
RSC ADVANCES (2017)
Comparison of corrosion behavior of Ti3SiC2 and Ti3AlC2 in NaCl solutions with Ti
M. Zhu et al.
CERAMICS INTERNATIONAL (2017)
Influence of Cu on the mechanical and tribological properties of Ti3SiC2
Wentao Dang et al.
CERAMICS INTERNATIONAL (2016)
Tribological properties of Ti3SiC2 coupled with different counterfaces
Yuanyuan Zhu et al.
CERAMICS INTERNATIONAL (2015)
Intrinsic Mechanical Properties of 20 MAX-Phase Compounds
Wai-Yim Ching et al.
JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2013)
Effects of scan rate on the potentiodynamic polarization curve obtained to determine the Tafel slopes and corrosion current density
X. L. Zhang et al.
CORROSION SCIENCE (2009)
Electrochemical stability of anodic titanium oxide films grown at potentials higher than 3 V in a simulated physiological solution
E. Pelaez-Abellan et al.
CORROSION SCIENCE (2007)
Corrosion behavior of select MAX phases in NaOH, HCl and H2SO4
V. D. Jovic et al.
CORROSION SCIENCE (2006)
Validation of corrosion rates measured by the Tafel extrapolation method
E McCafferty
CORROSION SCIENCE (2005)
Micron-scale deformation and damage mechanisms of Ti3SiC2 crystals induced by indentation
ZF Zhang et al.
ADVANCED ENGINEERING MATERIALS (2004)
Evidence of coupling between film growth and metal dissolution in passivation processes
M Bojinov et al.
ELECTROCHIMICA ACTA (2003)
The corrosion behavior of Ti3SiC2 in common acids and dilute NaOH
J Travaglini et al.
CORROSION SCIENCE (2003)