4.7 Article

Optical diagnostics of misfire in partially premixed combustion under low load conditions

Related references

Note: Only part of the references are listed.
Article Environmental Sciences

Experimental study on combustion and emission characteristics of diesel engine with high supercharged condition

Decan Zhu et al.

Summary: This study investigated the combustion and emission processes of a diesel engine at different intake pressures. The results showed that as the intake pressure increased, the combustion process shifted towards diffusion and post-combustion stages, resulting in a decrease in power increment. Furthermore, a decrease in excess air coefficient led to an increase in the proportion of heat release in the post-combustion stage, but a decrease in thermal efficiency and an increase in fuel consumption rate.

CHEMOSPHERE (2022)

Article Energy & Fuels

Gasoline spray characteristics using a high pressure common rail diesel injection system by the method of laser induced exciplex fluorescence

Lei Feng et al.

Summary: The study reveals that the liquid and vapor penetration lengths, as well as the mass of entrained gas of gasoline and diesel sprays, vary under different pressure conditions, while the mean equivalence ratio shows an increasing tendency under certain conditions.
Article Thermodynamics

Effects of fuel trapping in piston crevice on unburned hydrocarbon emissions in early-injection compression ignition engines

Qinglong Tang et al.

Summary: Early injection strategy is commonly used in advanced combustion concepts of compression ignition engines to enhance fuel-air premixing, but it may lead to fuel spray impingement on the cylinder wall and fuel trapping in crevice regions. This study utilized PLIF technique and computational modeling to investigate the impact of fuel trapping on the formation and distribution of unburned hydrocarbons (UHC). Results showed that early injection conditions led to increased UHC emissions and reduced engine work due to fuel trapping in the squish region and piston crevice. The formation of UHC from trapped fuel was found to be influenced by the local equivalence ratio distribution formed by different injection timings.

COMBUSTION AND FLAME (2021)

Article Energy & Fuels

Effects of n-heptane/toluene/ethanol ternary fuel blends on combustion, operating range and emissions in premixed low temperature combustion

Ahmet Bogrek et al.

Summary: Low temperature combustion engines are a new combustion model that can reduce nitrogen oxide emissions and increase thermal efficiency simultaneously. Experimentally investigating different chemical properties of low and high reactivity fuel mixtures in such engines can help optimize performance in various operating conditions.
Article Thermodynamics

Numerical simulation of a mixed-mode reaction front in a PPC engine

Christian Ibron et al.

Summary: Numerical simulation was used to study ignition process, combustion modes, and reaction front propagation in a PPC engine using a primary reference fuel. Different combustion modes and transition from premixed auto-ignition to non-premixed flame were observed. The simulation results showed good agreement with high temporal resolution optical data, indicating the model effectively captured the physics of mixed-mode combustion in PPC engines.

PROCEEDINGS OF THE COMBUSTION INSTITUTE (2021)

Article Thermodynamics

Detailed measurements of transient two-stage ignition and combustion processes in high-pressure spray flames using simultaneous high-speed formaldehyde PLIF and schlieren imaging

Hyung Sub Sim et al.

Summary: This study investigates the low- and high-temperature ignition and combustion processes in a high-pressure spray flame of n-dodecane using simultaneous PLIF and schlieren imaging. The results show that the formation and propagation of HCHO from lean to rich regions lead to high-temperature ignition events, supporting the identification of a phenomenon dubbed cool-flame wave propagation. High-temperature ignition consumes previously formed HCHO in the jet head, while HCHO formation persists near the flame base in the fuel-rich zone throughout the combustion period.

PROCEEDINGS OF THE COMBUSTION INSTITUTE (2021)

Article Thermodynamics

Simultaneous 36 kHz PLIF/chemiluminescence imaging of fuel, CH2O and combustion in a PPC engine

Zhenkan Wang et al.

PROCEEDINGS OF THE COMBUSTION INSTITUTE (2019)

Article Engineering, Mechanical

Analysis of misfires in a direct injection engine using proper orthogonal decomposition

Hao Chen et al.

EXPERIMENTS IN FLUIDS (2011)

Article Thermodynamics

Fuel reactivity controlled compression ignition (RCCI): a pathway to controlled high-efficiency clean combustion

S. L. Kokjohn et al.

INTERNATIONAL JOURNAL OF ENGINE RESEARCH (2011)

Article Thermodynamics

High-speed imaging analysis of misfires in a spray-guided direct injection engine

Brian Peterson et al.

PROCEEDINGS OF THE COMBUSTION INSTITUTE (2011)

Review Thermodynamics

Progress and recent trends in homogeneous charge compression ignition (HCCI) engines

Mingfa Yao et al.

PROGRESS IN ENERGY AND COMBUSTION SCIENCE (2009)