Optical diagnostics of misfire in partially premixed combustion under low load conditions

To clarify the misfire mechanism is important for stabilizing combustion in partially premixed combustion (PPC) under low load. Fuel-tracer planar laser-induced fluorescence (PLIF), formaldehyde PLIF, flame and OH* natural luminosity imaging were utilized to qualify the local equivalence ratio, low-temperature reaction and the hightemperature flame features in an optical engine. Results show that in high direct injection (DI) pressure (1000 bar), due to excessive premixing, the local equivalence ratio in the initial timing of the high temperature heat release (HTHR) is low. Although the auto-ignition flame kernels are formed in high DI pressure, they cannot stably develop, resulting in misfire during the flame development process. In late DI timing (-5 crank angle degree after top dead center, degrees CA ADTC), since the whole heat release process occurs in the expansion stroke, the in-cylinder temperature and pressure continue decreasing. Although the local equivalence ratio in some regions is high enough, the in-cylinder thermodynamic environment does not support the generation of more autoignition flame kernels, thus a small amount of auto-ignition flame kernels can only develop through flame propagation. In short, the misfire of PPC occurs in regions where the equivalence ratio is low or the in-cylinder thermodynamic environment does not further support flame development. Therefore, the trade-off relationship between equivalence ratio and temperature determines the formation of auto-ignition kernels. The local equivalence ratio and temperature distribution near the initial timing of HTHR is the key factor to ensure the subsequent stable combustion. Taking the ambient pressure of 18 bar as an example, the boundary condition where the autoignition kernels are most likely formed or the charge is most likely ignited by the nearby flame kernels is in the range of 0.53-0.62 for equivalence ratio and 740-757 K for temperature. The misfire region most likely appears when the equivalence ratio is lower than 0.49. It can be concluded that the misfire of PPC results from the synergistic effect of local equivalent ratio and temperature. The controlling parameters of injection pressure and injection timing are actually optimizing the suitable combinations of equivalence ratio and temperature to stabilize combustion.

Automated summary

Clarifying the misfire mechanism is crucial for stabilizing combustion in partially premixed combustion (PPC). Experimental results show that misfire occurs when the equivalence ratio is low or the in-cylinder thermodynamic environment does not support flame development. Optimizing the combination of equivalence ratio and temperature is important for achieving stable combustion.