4.7 Article

Laminar burning velocity measurement of CH4/H2/NH3-air premixed flames at high mixture temperatures

Related references

Note: Only part of the references are listed.
Article Thermodynamics

Measurement of the laminar burning velocity and kinetics study of the importance of the hydrogen recovery mechanism of ammonia/hydrogen/air premixed flames

Gabriel J. Gotama et al.

Summary: The study focuses on the chemical kinetics of NH3/H-2/air flames at rich conditions and elevated pressures, validating a new detailed kinetics mechanism that accurately predicts flame speed.

COMBUSTION AND FLAME (2022)

Article Chemistry, Physical

Experimental and numerical study on premixed partially dissociated ammonia mixtures. Part I: Laminar burning velocity of NH3/H2/N2/air mixtures

Changwei Ji et al.

Summary: This study measured the laminar burning velocity at various equivalence ratios and dissociation degrees of ammonia using the constant pressure spherical flame method, and compared fifteen kinetic models with the experimental data to find the model with the best consistency.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2022)

Article Green & Sustainable Science & Technology

Ignition delay time and laminar flame speed measurements of ammonia blended with dimethyl ether: A promising low carbon fuel blend

Gani Issayev et al.

Summary: Ammonia has been recognized as a promising future fuel for mobility and power generation due to its potential to reduce global warming. Blending ammonia with DME can enhance its reactivity, as DME is a highly reactive fuel with zero-carbon emission potential in a sustainable carbon cycle.

RENEWABLE ENERGY (2022)

Article Thermodynamics

The influence of ammonia on the laminar burning velocities of methylcyclohexane and toluene: An experimental and kinetic modeling study

Marco Lubrano Lavadera et al.

Summary: Blending ammonia with methylcyclohexane and toluene results in a non-proportional decrease in laminar burning velocity, with a slightly larger impact on toluene. A detailed kinetic model accurately predicts the experimental measurements after minor modifications to the chemistry and shows good agreement with the effect of equivalence ratio and ammonia fraction ranges investigated.

COMBUSTION AND FLAME (2022)

Article Chemistry, Physical

Experimental investigations on laminar burning velocity variation of CH4+H2+air mixtures at elevated temperatures

Pragya Berwal et al.

Summary: This study investigated the laminar burning velocity variation of CH4+H-2+air mixtures at elevated temperatures using an externally heated diverging-channel method. Results showed an increase in burning velocity with higher H2 fraction due to the formation of H-atom as an intermediate, establishing a temperature dependency through a power-law correlation.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2022)

Article Thermodynamics

Continuous rotating detonation engine fueled by ammonia

Si-Yuan Huang et al.

Summary: This paper proposes and realizes the combustion process of ammonia-oxygen continuous rotating detonation (CRD) in a hollow chamber. The formation process and propagation characteristics of the detonation wave are investigated through pressure measurement and optical observation. This study is of great significance for improving the detonation theory and enhancing the efficiency of ammonia utilization.

ENERGY (2022)

Article Thermodynamics

An experimental and modeling study of ammonia with enriched oxygen content and ammonia/hydrogen laminar flame speed at elevated pressure and temperature

Krishna Prasad Shrestha et al.

Summary: This study experimentally investigated the laminar flame speeds of ammonia and ammonia-hydrogen blends under different temperature, pressure, and oxygen content conditions, and developed a new kinetic model for predicting the oxidation mechanisms, considering the formation and reduction of nitrogen oxides. The results showed that the laminar flame speed increases with increasing initial temperature, fuel hydrogen content, or oxidizer oxygen content, but decreases with increasing initial pressure. The proposed kinetic model predicts the same trends as experiments and highlights the importance of N2H2 formation under rich conditions.

PROCEEDINGS OF THE COMBUSTION INSTITUTE (2021)

Article Thermodynamics

Experimental investigation on ammonia combustion behavior in a spark-ignition engine by means of laminar and turbulent expanding flames

Charles Lhuillier et al.

Summary: The study aims to elucidate the combustion characteristics of ammonia blends under engine-relevant turbulent conditions, finding that the effects of hydrogen or methane enrichment observed in SI engines cannot be fully explained by the measured laminar burning velocities. The combustion regimes studied are at the boundary between thin and broken reaction zones, influenced by flame-turbulence interactions.

PROCEEDINGS OF THE COMBUSTION INSTITUTE (2021)

Article Energy & Fuels

Comparative Effect of Ammonia Addition on the Laminar Burning Velocities of Methane, n-Heptane, and Iso-octane

Marco Lubrano Lavadera et al.

Summary: Experimental results showed that adding ammonia to methane, n-heptane, and iso-octane decreases the laminar burning velocity, and this reduction is not proportional to the ammonia mole fraction. Ammonia has a similar impact on the burning velocities of n-heptane and iso-octane, but slightly higher effect on methane. The reduction in burning velocity is due to synergistic thermal, kinetic, and indirect transport effects.

ENERGY & FUELS (2021)

Article Energy & Fuels

Laminar Burning Velocities of Hydrogen-Blended Methane-Air and Natural Gas-Air Mixtures, Calculated from the Early Stage of p(t) Records in a Spherical Vessel

Maria Mitu et al.

Summary: The study investigates the effect of hydrogen addition on the laminar burning velocity of methane and natural gas mixtures, showing that hydrogen addition increases LBV and the variation in LBV becomes more significant with higher hydrogen fractions.

ENERGIES (2021)

Article Chemistry, Physical

Chemical structure and laminar burning velocity of atmospheric pressure premixed ammonia/hydrogen flames

Ksenia N. Osipova et al.

Summary: This paper presents experimental data on the flame structure of laminar premixed ammonia and ammonia/hydrogen flames at different equivalence ratios and the laminar flame speed of ammonia/hydrogen flames. Experimental data were compared with modeling results obtained using detailed chemical-kinetic mechanisms of ammonia oxidation. The study shows that slightly rich conditions and increasing pressure can reduce NO formation in ammonia flames.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2021)

Article Energy & Fuels

An experimental study of laminar ammonia/methane/air premixed flames using expanding spherical flames

Tao Shu et al.

Summary: Experimental investigation of flame properties in ammonia/methane/air mixtures shows significant influence of gas composition and pressure on flame speeds and flammability limits. Linear correlation between flame speed and methane volume fraction is observed, with accurate prediction using Okafor et al. mechanism.
Article Thermodynamics

Enhancement of ammonia combustion with partial fuel cracking strategy: Laminar flame propagation and kinetic modeling investigation of NH3/H2/N2/air mixtures up to 10 atm

Bowen Mei et al.

Summary: This study investigates laminar flame propagation of partially cracked NH3/air mixtures and analyzes the effects of equivalence ratio, cracking ratio, and pressure on combustion performance. Results show that in the partial fuel cracking strategy, thermal effect plays a minor role while chemical effect is significant for enhanced laminar flame propagation.

COMBUSTION AND FLAME (2021)

Review Energy & Fuels

A comprehensive review on synthesis, chemical kinetics, and practical application of ammonia as future fuel for combustion

Pragya Berwal et al.

Summary: Ammonia is being explored as a potential fuel with its 17.6% hydrogen content making it a carbon-free emission option. Various studies on its applications as a fuel are discussed, along with suggestions for overcoming drawbacks such as lower burning velocities and high NOx emissions.

JOURNAL OF THE ENERGY INSTITUTE (2021)

Article Energy & Fuels

Kinetic study and optimization on SNCR process in pressurized oxy-combustion

Zia ur Rahman et al.

Summary: Pressurized oxy-combustion is a promising technology for carbon capture, utilization, and storage in coal utilization. Experimental results show that increasing pressure can improve the efficiency of SNCR; however, increasing oxygen concentration at high pressure reduces the efficiency of SNCR.

JOURNAL OF THE ENERGY INSTITUTE (2021)

Article Thermodynamics

Towards the development of an efficient low-NOx ammonia combustor for a micro gas turbine

Ekenechukwu C. Okafor et al.

PROCEEDINGS OF THE COMBUSTION INSTITUTE (2019)

Article Energy & Fuels

NH3 as a Transport Fuel in Internal Combustion Engines: A Technical Review

Herry Lesmana et al.

JOURNAL OF ENERGY RESOURCES TECHNOLOGY-TRANSACTIONS OF THE ASME (2019)

Article Chemistry, Physical

Laminar burning velocities of H2/CO/CH4/CO2/N2 -air mixtures at elevated temperatures

Robin John Varghese et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2019)

Article Thermodynamics

Experimental and numerical study of the laminar burning velocity of CH4-NH3-air premixed flames

Ekenechukwu C. Okafor et al.

COMBUSTION AND FLAME (2018)

Article Chemistry, Physical

Chemical kinetic modeling of ammonia oxidation with improved reaction mechanism for ammonia/air and ammonia/hydrogen/air combustion

Junichiro Otomo et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2018)

Review Thermodynamics

A comprehensive review of measurements and data analysis of laminar burning velocities for various fuel plus air mixtures

Alexander A. Konnov et al.

PROGRESS IN ENERGY AND COMBUSTION SCIENCE (2018)

Article Transportation Science & Technology

NOx Reduction Using a Dual-Stage Catalyst System with Intercooling in Vehicle Gasoline Engines under Real Driving Conditions

Jean P. Roy et al.

SAE INTERNATIONAL JOURNAL OF ENGINES (2018)

Article Chemistry, Physical

Preliminary study on lean premixed combustion of ammonia-hydrogen for swirling gas turbine combustors

A. Valera-Medina et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2017)

Article Engineering, Mechanical

Chemical Kinetic Mechanism Study on Premixed Combustion of Ammonia/Hydrogen Fuels for Gas Turbine Use

Hua Xiao et al.

JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER-TRANSACTIONS OF THE ASME (2017)

Article Engineering, Environmental

Inert gas influence on the laminar burning velocity of methane-air mixtures

Maria Mitu et al.

JOURNAL OF HAZARDOUS MATERIALS (2017)

Article Energy & Fuels

Ammonia-methane combustion in tangential swirl burners for gas turbine power generation

Agustin Valera-Medina et al.

APPLIED ENERGY (2017)

Article Engineering, Mechanical

NO formation/reduction mechanisms of ammonia/air premixed flames at various equivalence ratios and pressures

Akihiro Hayakawa et al.

MECHANICAL ENGINEERING JOURNAL (2015)

Proceedings Paper Energy & Fuels

Ammonia, Methane and Hydrogen for Gas Turbines

A. Valera-Medina et al.

CLEAN, EFFICIENT AND AFFORDABLE ENERGY FOR A SUSTAINABLE FUTURE (2015)

Article Chemistry, Physical

Studies on properties of laminar premixed hydrogen-added ammonia/air flames for hydrogen production

J. H. Lee et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2010)

Article Thermodynamics

Premixed ammonia-methane-air combustion

PF Henshaw et al.

COMBUSTION SCIENCE AND TECHNOLOGY (2005)

Article Thermodynamics

Measurement of propagation speeds in adiabatic cellular premixed flames of CH4+O2+CO2

AA Konnov et al.

EXPERIMENTAL THERMAL AND FLUID SCIENCE (2005)