Microscopic Analysis of Hydrogen Production from Methane Sono-Pyrolysis

The sonolysis of certain substrates in water has proved its effectiveness for the enhancement of the sonochemical production of hydrogen. In this study, the sonolysis of methane has been investigated for the first time in a single acoustic bubble (microreactor) over a frequency from 140 to 515 kHz. The obtained findings have been compared to those available in the literature. Independently of the methane dose (inside the bubble), the yield of H-2 was improved especially with the decrease in wave frequency (from 515 to 140 kHz). For the driving frequencies 140, 213, 355, and 515 kHz, the production of hydrogen was maximized at 20, 15, 10, and 10% CH4, respectively. For 213 kHz, and the presence of 10% methane, the yield of hydrogen goes up by 111 fold compared to the case where the gas atmosphere is saturated only by argon. On the other hand, the highest methane conversions (similar to 100% for 2, 5 and 7% CH4) were retrieved at 140 and 213 kHz. In terms of hydrogen formation and methane decay, the use of 140 kHz was found to be the best choice, whereas for a multi-bubble system, the number of acoustic bubbles should be taken into account for an optimal choice of frequency. Interestingly, it was observed that at 140 and 213 kHz and for methane mole fractions lower than or equal to 30 and 10%, respectively, a maximal formation of H-2 and a relatively important production of (OH)-O-center dot could result simultaneously.

Automated summary

The sonolysis of methane in a single acoustic bubble at frequencies ranging from 140 kHz to 515 kHz was investigated. The yield of H2 was improved regardless of the methane dose, especially at lower wave frequencies. The optimal methane fraction, hydrogen production, and methane conversion were found at different frequencies.