4.5 Article

Comparative Analysis of Numerical Methods for Simulating N-Heptane Combustion with Steam Additive

Related references

Note: Only part of the references are listed.
Article Energy & Fuels

Combustion of liquid hydrocarbon fuel in an evaporative burner with forced supply of superheated steam and air to the reaction zone

A. V. Minakov et al.

Summary: This study investigated experimentally and numerically the combustion of n-heptane in a laboratory evaporative-type burner, showing a significant difference in combustion characteristics between steam and air supply, with steam supply significantly reducing nitrogen oxides and soot emissions.
Article Energy & Fuels

Numerical analysis of a pre-chamber vortex burner with a steam blast atomizer

A. V. Minakov et al.

Summary: This study numerically investigates the combustion of diesel fuel in a pre-chamber vortex burner with a steam blast atomizer. The results show that the burner can achieve almost complete combustion while meeting environmental emission standards.
Article Energy & Fuels

Effect of port water injection on the characteristics of combustion and emissions in a spark ignition direct injection engine

Yadong Fan et al.

Summary: Port water injection techniques are a potential solution to enhance the combustion performance of internal combustion engines by suppressing engine knock. This research systematically investigates water injection strategies and their impacts, providing recommendations for optimizing design and achieving improvements in thermal efficiency and emissions reduction. Results show that proper water injection can lead to significant improvements in brake thermal efficiency and a reduction in particulate emissions.
Article Thermodynamics

Study of the water injection control parameters on combustion performance of a spark-ignition engine

Deborah Domingos da Rocha et al.

Summary: This study experimentally validated the impact of different water injection strategies on engine combustion parameters, finding that variations in water injection temperature had limited influence on fuel conversion efficiency, while proper injection timing and pressure calibration significantly reduced specific fuel consumption.

ENERGY (2021)

Article Energy & Fuels

Numerical and chemical kinetic analysis to evaluate the effect of steam dilution and pressure on combustion of n-dodecane in a swirling flow environment

Subhankar Mohapatra et al.

Summary: The present study used numerical analysis to investigate the effect of steam dilution and high pressure on liquid fuel swirl combustion. The results showed that pressure had a significant impact on ignition delay, while steam dilution had a minor effect. Additionally, pressure and dilution also affected the combustion products and NO formation.
Article Energy & Fuels

Diesel and waste oil combustion in a new steam burner with low NOX emission

I. S. Anufriev et al.

Summary: A new low-power burner has been developed and tested, capable of burning low NOx liquid combustible waste. The burner design significantly reduces nitrogen oxides emissions and has been tested with diesel and waste oil combustion performance.
Article Energy & Fuels

Water injection as a way for pollution control

Michael Fratita et al.

Summary: The study tracks the impact of water injection on reducing pollutant emissions by conducting experimental tests on a spark ignition side-valve engine at different water-to-fuel ratios. The research shows that a well-designed water injection system can reduce the pollutant emissions of internal combustion engines.

ENERGY REPORTS (2021)

Article Engineering, Chemical

Numerical study on the physical and chemical processes in n-decane spray ignition

Xin Liang et al.

Summary: The numerical study on n-decane spray ignition in a constant volume combustion chamber revealed that chamber temperature has a greater impact on the physical process than oxygen concentration, while the chemical process is simultaneously affected by chamber temperature and oxygen concentration.

CHEMICAL ENGINEERING SCIENCE (2021)

Article Engineering, Environmental

NOx reduction by steam injection method during liquid fuel and waste burning

Igor S. Anufriev et al.

Summary: Incineration of waste generates toxic combustion products, which can be reduced by using steam in the combustion process. Steam enhances carbon burnout and decreases thermal nitrogen oxides formation in the combustion zone, solving waste disposal and toxic products reduction simultaneously.

PROCESS SAFETY AND ENVIRONMENTAL PROTECTION (2021)

Article Thermodynamics

CLEANER CRUDE OIL COMBUSTION DURING SUPERHEATED STEAM ATOMIZATION

Igor Anufriev et al.

Summary: The study investigates the use of superheated steam jet for burning crude oil to reduce NOx emissions and improve fuel combustion efficiency. Experimental results show that this method prevents nozzle chocking and coking, while also reducing toxic emissions.

THERMAL SCIENCE (2021)

Article Engineering, Chemical

Study on oxy-fuel combustion behaviors in a S-CO2 CFB by 3D CFD simulation

Jinrao Gu et al.

CHEMICAL ENGINEERING SCIENCE (2020)

Proceedings Paper Thermodynamics

Investigation of pulverized coal flaring based on eddy-resolving turbulence models

A. Dekterev et al.

XXXVI SIBERIAN THERMOPHYSICAL SEMINAR (STS 36) (2020)

Article Mechanics

Burning of Heavy Fuel Oil in a Steam Jet in a New Burner

S. Alekseenko et al.

JOURNAL OF APPLIED MECHANICS AND TECHNICAL PHYSICS (2020)

Article Thermodynamics

Analysis of Combustion of Coal-Water Fuel in Low-Power Hot-Water Boiler via Numerical Modeling and Experiments

S. V. Alekseenko et al.

JOURNAL OF ENGINEERING THERMOPHYSICS (2019)

Article Chemistry, Applied

Diesel fuel combustion by spraying in a superheated steam jet

I. S. Anufriev et al.

FUEL PROCESSING TECHNOLOGY (2019)

Proceedings Paper Thermodynamics

Numerical simulation of premixed methane/air and synthesis gas/air flames for turbulence swirling jet

A. S. Lobasov et al.

XXXV SIBERIAN THERMOPHYSICAL SEMINAR, 2019 (2019)

Article Engineering, Aerospace

Influence of parameters of superheated steam on combustion of liquid hydrocarbons

S. V. Alekseenko et al.

THERMOPHYSICS AND AEROMECHANICS (2019)

Article Engineering, Aerospace

Numerical simulation of diesel combustion based on n-heptane and toluene

Kesong Zhang et al.

PROPULSION AND POWER RESEARCH (2019)

Article Thermodynamics

Effect of steam addition on gas turbine combustor design and performance

Rui Xue et al.

APPLIED THERMAL ENGINEERING (2016)

Article Thermodynamics

Characteristics of diesel fuel combustion in a burner with injection of a superheated steam jet

S. V. Alekseenko et al.

COMBUSTION EXPLOSION AND SHOCK WAVES (2016)

Article Thermodynamics

STUDY OF 3D FLOW STRUCTURE AND HEAT TRANSFER IN A VORTEX FURNACE

Sergey V. Alekseenko et al.

HEAT TRANSFER RESEARCH (2016)

Review Thermodynamics

Lagrangian Mixing Models for Turbulent Combustion: Review and Prospects

Cesar Celis et al.

FLOW TURBULENCE AND COMBUSTION (2015)

Article Thermodynamics

Numerical Simulations of the Sandia Flame D Using the Eddy Dissipation Concept

Dmitry A. Lysenko et al.

FLOW TURBULENCE AND COMBUSTION (2014)

Article Mechanics

Design of a massively parallel CFD code for complex geometries

Vincent Moureau et al.

COMPTES RENDUS MECANIQUE (2011)

Review Thermodynamics

Recent progress in the development of diesel surrogate fuels

William J. Pitz et al.

PROGRESS IN ENERGY AND COMBUSTION SCIENCE (2011)

Article Thermodynamics

NANOCLUSTER INITIATION OF COMBUSTION OF OFF-GRADE HYDROCARBON FUELS

S. V. Alekseenko et al.

JOURNAL OF ENGINEERING PHYSICS AND THERMOPHYSICS (2010)

Article Engineering, Mechanical

Sensitization of the SST Turbulence Model to Rotation and Curvature by Applying the Spalart-Shur Correction Term

Pavel E. Smirnov et al.

JOURNAL OF TURBOMACHINERY-TRANSACTIONS OF THE ASME (2009)

Article Thermodynamics

On the assumption of using n-heptane as a surrogate fuel for the description of the cool flame oxidation of diesel oil

Dionysios I. Kolaitis et al.

PROCEEDINGS OF THE COMBUSTION INSTITUTE (2009)

Article Thermodynamics

Experimental comparison of soot formation in turbulent flames of Diesel and surrogate Diesel fuels

R. Lemaire et al.

PROCEEDINGS OF THE COMBUSTION INSTITUTE (2009)

Article Thermodynamics

Laser-based experimental and Monte Carlo PDF numerical investigation of an ethanol/air spray flame

H. -W. Ge et al.

COMBUSTION SCIENCE AND TECHNOLOGY (2008)