☆ 4.7 Article

Experimental study on delamination and strength characteristics of cemented waste rock backfill

CONSTRUCTION AND BUILDING MATERIALS (2023)

Related references

Note: Only part of the references are listed.

Article Construction & Building Technology

Mechanical properties and uniaxial compressive stress-strain behavior of fully recycled aggregate concrete

Yuxiang Tang et al.

Summary: This study proposes a fully recycled aggregate concrete (FRAC) prepared by replacing natural aggregates and partially replacing cement with recycled materials. The addition of recycled materials has a negative effect on concrete strength and shows little effect on the ascending branch of stress-strain curves but influences the descending branch. The elastic modulus decreases due to the incorporation of recycled aggregates and recycled powder.

CONSTRUCTION AND BUILDING MATERIALS (2022)

Add to Collection

Article Construction & Building Technology

Adopting an image analysis method to study the influence of segregation on the compressive strength of lightweight aggregate concretes

Afonso Miguel Solak et al.

Summary: Aggregate segregation in lightweight aggregate concretes has a significant impact on the mechanical strength and durability of concrete. This study employs image analysis techniques to accurately quantify the effect of segregation on compressive strength and finds that the type of molding has a considerable influence on concrete's mechanical properties.

CONSTRUCTION AND BUILDING MATERIALS (2022)

Add to Collection

Article Construction & Building Technology

Study on the strength characteristics and failure characteristics of the composite load-bearing structure in the cemented filling field

Bin Xu et al.

Summary: The technology of continuous mining and filling cemented coal mining (CMCB) solves the problem of unbalanced mining and filling efficiency in lane-type cemented filling. By studying the alternate bearing characteristics of the roof and the mechanical properties of the composite load-bearing structure, this research provides references for the design of the lane width, the optimization of the mining process, and the proportioning of the filling slurry.

CONSTRUCTION AND BUILDING MATERIALS (2022)

Add to Collection

Article Materials Science, Multidisciplinary

Enhanced ductility and toughness by tailoring heterogenous microstructure in an ultra-heavy gauge high strength steel with severe centerline segregation

Z. J. Xie et al.

Summary: In this study, a novel two-step intercritical heat treatment was used to adjust the microstructure of an ultra heavy E500 offshore engineering steel. The results showed that the mechanical properties of the steel were significantly improved after thermo-mechanical controlled processing, especially in terms of elongation and low-temperature toughness at the center location. This improvement can be attributed to a more homogeneous chemical composition distribution and the fine multiphase microstructure with stable retained austenite obtained in the segregation region.

MATERIALS LETTERS (2022)

Add to Collection

Article Engineering, Chemical

Effect of aggregate size distribution and confining pressure on mechanical property and microstructure of cemented gangue backfill materials

Yiming Wang et al.

Summary: This study investigates the effect of the fractal dimension of particle size distribution (PSD) and confining pressure on the mechanical properties of cemented gangue backfill material (CGBM). The results show that the compressive strength and elastic modulus of CGBM are related to the PSD fractal dimension and confining pressure. A reasonable PSD fractal dimension can optimize the microstructure of CGBM and ensure its load-bearing capacity.

ADVANCED POWDER TECHNOLOGY (2022)

Add to Collection

Article Construction & Building Technology

Research on reuse of silty fine sand in backfill grouting material and optimization of backfill grouting material proportions

Jian Zhang et al.

Summary: This study analyzed a shield tunneling section in Nanjing Metro Line 7 that was formed with silty fine sand. By combining SPSS multiple regression analysis and MATLAB multi-objective planning tools, the ratio of muck grouting liquid was optimized using X-ray diffraction technology and laboratory tests. The feasibility of using silty fine sand as a substitute for backfill grouting liquid was discussed. The effects of grout performance and grouting parameters on the diffusion of the grouting liquid were studied. The results showed that silty fine sand can be used as a sand source for grouting liquid that meets construction requirements through the addition of a water-reducing agent and optimizing the ratio. The cost-optimized ratio grouting liquid has advantages in terms of strength and economic benefit, but the stability is poor.

TUNNELLING AND UNDERGROUND SPACE TECHNOLOGY (2022)

Add to Collection

Article Construction & Building Technology

Hybrid 1D-CNN and attention-based Bi-GRU neural networks for predicting moisture content of sand gravel using NIR spectroscopy

Quan Yuan et al.

Summary: A neural network-based method was proposed to detect moisture content in sand gravel materials. The method combines 1D-CNN and attention-based Bi-GRU to extract abstract and positional information from the spectral data. Compared to other methods, this approach achieves better prediction performance on different datasets and can identify characteristic wavelength points in sand gravel.

CONSTRUCTION AND BUILDING MATERIALS (2022)

Add to Collection

Article Construction & Building Technology

Feasibility of using copper slag as natural aggregate replacement in microsurfacing for quality enhancement: Microscopic and mechanical analysis

Ali Zalnezhad et al.

Summary: Copper slag, as an industrial waste, can be used as a partial replacement of aggregate in pavement construction to improve performance and reduce environmental issues. The laboratory study showed that the use of copper slag in microsurfacing mixtures has good potential, especially at a 30% replacement level, to enhance asphalt performance.

CONSTRUCTION AND BUILDING MATERIALS (2022)

Add to Collection

Article Green & Sustainable Science & Technology

Effects of recycled aggregate combinations and recycled powder contents on fracture behavior of fully recycled aggregate concrete

Jianzhuang Xiao et al.

Summary: This paper studied the fracture behavior of fully recycled aggregate concrete (FRAC), and found that the use of recycled coarse and fine aggregates (RCA and RFA) resulted in different fracture mechanisms. The substitution of RCA had little effect on critical crack opening displacements, while the substitution of RFA and RP increased and decreased them, respectively. The use of recycled aggregates reduced the fracture energy and toughness, while the use of recycled powder had limited impact.

JOURNAL OF CLEANER PRODUCTION (2022)

Add to Collection

Article Construction & Building Technology

Industrial graphene oxide-fly ash hybrid for high-performance cemented waste rock backfill

Yuan Gao et al.

Summary: The study used an industrial graphene oxide-fly ash hybrid as mine backfill material to enhance the mechanical and impermeability properties of the waste rock backfills. Only a small amount of graphene oxide is needed to reduce cement consumption by up to 20%.

CONSTRUCTION AND BUILDING MATERIALS (2022)

Add to Collection

Article Construction & Building Technology

Effects of combined accelerating admixtures on mechanical strength and microstructure of cement mortar

Guosheng Ren et al.

Summary: The study showed that adding calcium formate and methacrylic acid combined with cement paste powder to cement mortar significantly increased compressive strength, while being influenced by curing temperature and water-cement ratio. The double-component early strength agents can accelerate cement hydration and reduce porosity of cement mortar.

CONSTRUCTION AND BUILDING MATERIALS (2021)

Add to Collection

Article Engineering, Multidisciplinary

Electrical resistivity method to appraise static segregation of gangue-cemented paste backfill in the pipeline

Zehua Wang et al.

Summary: The use of horizontal electrical resistivity can effectively monitor the segregation characteristics in pipes, with decreasing differences in resistivity between layers as mass concentration increases. Diametrical electrical resistivity is less sensitive to segregation and can only distinguish the stability differences in GCPBs with lower mass concentrations.

INTERNATIONAL JOURNAL OF PRESSURE VESSELS AND PIPING (2021)

Add to Collection

Article Construction & Building Technology

Mechanical properties and fracturing of rock-backfill composite specimens under triaxial compression

Xin Yu et al.

Summary: Backfill is widely used in the mining industry to stabilize underground excavations; backfill made from mine tailings is sustainable and eliminates the hazards of storing tailings on the surface. Experimental studies have shown that in rock-backfill systems, the backfill has a significant effect on the strength and elastic properties of the combined specimens.

CONSTRUCTION AND BUILDING MATERIALS (2021)

Add to Collection

Article Construction & Building Technology

Influence of water/cement ratio, and type and concentration of chemical additives on the static and dynamic yield stresses of Portland cement paste

F. J. Rubio-Hernandez et al.

CONSTRUCTION AND BUILDING MATERIALS (2020)

Add to Collection

Article Construction & Building Technology

Potential use of granite waste sourced from rock processing for the application as coarse aggregate in high-performance self-compacting concrete

Krzysztof Ostrowski et al.

CONSTRUCTION AND BUILDING MATERIALS (2020)

Add to Collection

Article Engineering, Geological

Testing and modelling creep compression of waste rocks for backfill with different lithologies

Meng Li et al.

INTERNATIONAL JOURNAL OF ROCK MECHANICS AND MINING SCIENCES (2020)

Add to Collection

Article Engineering, Multidisciplinary

Evaluation of static segregation of cemented gangue-fly ash backfill material using electrical resistivity method

Zehua Wang et al.

MEASUREMENT (2020)

Add to Collection

Article Construction & Building Technology

Strength and ultrasonic properties of cemented waste rock backfill considering confining pressure, dosage and particle size effects

Jiangyu Wu et al.

CONSTRUCTION AND BUILDING MATERIALS (2020)

Add to Collection

Article Construction & Building Technology

Effects of accelerator-water reducer admixture on performance of cemented paste backfill

Yin Liu et al.

CONSTRUCTION AND BUILDING MATERIALS (2020)

Add to Collection

Article Construction & Building Technology

Effect of aggregate gradation and mortar rheology on static segregation of self-compacting concrete

Weishuo Yan et al.

CONSTRUCTION AND BUILDING MATERIALS (2020)

Add to Collection

Article Engineering, Multidisciplinary

Concrete relative velocity prediction to prevent mortar segregation for safe gravity transportation

Lichun Jiang et al.

ALEXANDRIA ENGINEERING JOURNAL (2020)

Add to Collection

Article Construction & Building Technology

Effect of yield stress development on the foam-stability of aerated geopolymer concrete

K. Dhasindrakrishna et al.

CEMENT AND CONCRETE RESEARCH (2020)

Add to Collection

Article Green & Sustainable Science & Technology

Strength prediction model considering material, ultrasonic and stress of cemented waste rock backfill for recycling gangue

Jiangyu Wu et al.

JOURNAL OF CLEANER PRODUCTION (2020)

Add to Collection

Article Mathematics

Statistical Approach for the Design of Structural Self-Compacting Concrete with Fine Recycled Concrete Aggregate

Victor Revilla-Cuesta et al.

MATHEMATICS (2020)

Add to Collection

Article Environmental Sciences

Effect of particle erosion on mining-induced water inrush hazard of karst collapse pillar

Dan Ma et al.

ENVIRONMENTAL SCIENCE AND POLLUTION RESEARCH (2019)

Add to Collection

Article Mining & Mineral Processing

Roof filling control technology and application to mine roadway damage in small pit goaf

Weiyi Cai et al.

INTERNATIONAL JOURNAL OF MINING SCIENCE AND TECHNOLOGY (2019)

Add to Collection

Article Engineering, Geological

A discrete-fracture-network fault model revealing permeability and aperture evolutions of a fault after earthquakes

Richeng Liu et al.

INTERNATIONAL JOURNAL OF ROCK MECHANICS AND MINING SCIENCES (2018)

Add to Collection

Article Green & Sustainable Science & Technology

Recycling phosphogypsum and construction demolition waste for cemented paste backfill and its environmental impact

Qiusong Chen et al.

JOURNAL OF CLEANER PRODUCTION (2018)

Add to Collection

Article Environmental Sciences

A practice of ultra-fine tailings disposal as filling material in a gold mine

D. Q. Deng et al.

JOURNAL OF ENVIRONMENTAL MANAGEMENT (2017)

Add to Collection

Article Construction & Building Technology

Understanding the relationship between the segregation of concrete and coarse aggregate density and size

Ivan Navarrete et al.

CONSTRUCTION AND BUILDING MATERIALS (2017)

Add to Collection

Article Mining & Mineral Processing

Mechanics criterion and factors affecting overburden stability in solid dense filling mining

Sun Jian

INTERNATIONAL JOURNAL OF MINING SCIENCE AND TECHNOLOGY (2017)

Add to Collection

Article Construction & Building Technology

2D image analysis method for evaluating coarse aggregate characteristic and distribution in concrete

Jianguo Han et al.

CONSTRUCTION AND BUILDING MATERIALS (2016)

Add to Collection

Article Mining & Mineral Processing

Stability analyses of vertically exposed cemented backfill: A revisit to Mitchell's physical model tests

Liu Guangsheng et al.

INTERNATIONAL JOURNAL OF MINING SCIENCE AND TECHNOLOGY (2016)

Add to Collection

Article Construction & Building Technology

Effects of strain rate on mechanical behavior of modeled recycled aggregate concrete under uniaxial compression

Jianzhuang Xiao et al.

CONSTRUCTION AND BUILDING MATERIALS (2015)

Add to Collection

© Peeref 2019-2024. All rights reserved.