Journal
JOURNAL OF NON-CRYSTALLINE SOLIDS
Volume 432, Issue -, Pages 111-119Publisher
ELSEVIER
DOI: 10.1016/j.jnoncrysol.2015.02.025
Keywords
13-93 bioactive glass; Robocasting; Scaffold; Mechanical properties; Polymer impregnation
Funding
- European Union [604036]
- Junta de Extremadura
- FEDER Funds [IB13007]
- Universidad de Extremadura [1105]
Ask authors/readers for more resources
The effect of polymer infiltration on the mechanical properties of 13-93 bioactive glass scaffolds fabricated by robocasting has been investigated. Biodegradable polymers poly (lactic add) (PLA) and poly (c-caprolactone) (PCL)-were infiltrated into selected robocast scaffolds by immersion of the structure in a polymer melt. The mechanical enhancement achieved upon impregnation on robocast 13-93 structures with fully-dense struts was found to be lower than in the currently existing literature due to the absence of microporosity. The modulus increase is negligible and the strengthening achieved is limited (<40% in the most favorable case of PLA impregnation under bending). However, the toughening produced by the polymer infiltrate, while lower than previously reported values in microporous structures, is still large (over one order of magnitude); especially when a ductile polymer infiltrate such as PCL is used. Indeed, the 13-93/PCL co-continuous composites were able to survive large strains with significant load-bearing capacity, even under bending stresses, or a rough, manual milling. On the other hand, the dense 13-93 frames fabricated by robocasting acted as good mechanical reinforcements for both polymers, with the exception of PLA under bending stresses. (C) 2015 Elsevier B.V. All rights reserved.
Authors
I am an author on this paper
Click your name to claim this paper and add it to your profile.
Reviews
Recommended
No Data Available