4.7 Article

Nucleation of recrystallization in magnesium alloy grains of varied orientation and the impacts on texture evolution

Related references

Note: Only part of the references are listed.
Article Metallurgy & Metallurgical Engineering

The evolution of coarse grains and its effects on weakened basal texture during annealing of a cold-rolled magnesium AZ31B alloy

Xin Wang et al.

Summary: The nucleation and grain growth of 34 coarse grains were tracked using a quasi-in-situ EBSD method. Most grains did not have a basal orientation, and no preferential grain growth or special types of grain boundaries were observed. Nine coarse grains nucleated from deformed grain boundaries, mainly within dislocation cells or subgrains in deformed grain interiors. The growth behavior of these grains can be explained by abnormal subgrain growth rarely reported in Mg alloys. The coarse basal grains did not show any growth advantage compared to other non-basal grains, resulting in a weak basal texture in the AZ31B alloy.

JOURNAL OF MAGNESIUM AND ALLOYS (2022)

Article Materials Science, Multidisciplinary

Atomistic Insights into the Competition between Damage and Dynamic Recrystallization Stimulated by the Precipitate Mg17Al12 in Magnesium Alloys

Yan Tang et al.

Summary: This study investigates the effects of precipitates on ductile damage and dynamic recrystallization in magnesium alloys using molecular dynamics simulation and the embedded atomic method. The results show that the distribution and dimensions of precipitates have a quantitative influence on void nucleation, dislocation emission, void growth, and DRX in magnesium alloys. Additionally, it is found that refining and densifying the precipitates can increase the deformation compatibility of the system, hinder void nucleation, and enhance toughness.

METALS (2022)

Review Metallurgy & Metallurgical Engineering

Alloying design and microstructural control strategies towards developing Mg alloys with enhanced ductility

Zhong-Zheng Jin et al.

Summary: Magnesium alloys show promising potential as lightweight structural materials in transportation and aerospace fields due to their low density and high specific strength. However, most high-strength magnesium alloys exhibit poor formability and ductility at room temperature, limiting their applications. Recent research has focused on enhancing the ductility of magnesium alloys through alloying design strategies and microstructural control using advanced processing technologies.

JOURNAL OF MAGNESIUM AND ALLOYS (2022)

Review Metallurgy & Metallurgical Engineering

Anisotropy of wrought magnesium alloys: A focused overview

Baodong Shi et al.

Summary: This paper critically reviews the relationship between anisotropic mechanical properties and microstructure evolution of wrought magnesium alloys, discussing strong anisotropy induced by texture and twinning under various loading conditions. It comprehensively reviews macro- and meso-scale constitutive modeling approaches to clarify the origin of anisotropic behavior.

JOURNAL OF MAGNESIUM AND ALLOYS (2022)

Article Materials Science, Multidisciplinary

Synergistic effect of Y and Ca addition on the texture modification in AZ31B magnesium alloy

Risheng Pei et al.

Summary: This study investigates the synergistic effect of various alloying elements on the texture and microstructure evolution in magnesium alloys. The results demonstrate that adjusting the precipitation and solute segregation can lead to desired texture modifications.

ACTA MATERIALIA (2022)

Article Metallurgy & Metallurgical Engineering

Quasi-in-situ observing the rare earth texture evolution in an extruded Mg-Zn-Gd alloy with bimodal microstructure

M. G. Jiang et al.

Summary: This study investigated the static recrystallization and texture evolution in an extruded Mg-Zn-Gd alloy, providing direct evidence of rare earth (RE) texture evolution during grain growth. The research findings contribute to understanding the mechanisms involved in forming RE texture during extrusion and developing wrought Mg alloys with improved formability.

JOURNAL OF MAGNESIUM AND ALLOYS (2021)

Article Materials Science, Multidisciplinary

Modeling discontinuous dynamic recrystallization containing second phase particles in magnesium alloys utilizing phase field method

N. Y. Zhu et al.

Summary: The study investigates the influence of pre-existing second phase particles on microstructure evolution during the DRX process of magnesium alloys, and the interaction with PSN and SIBM mechanisms. A phase field model is developed to quantitatively study these interactions, showing that the pinning effect of second phase particles suppresses nucleation at grain boundaries.

COMPUTATIONAL MATERIALS SCIENCE (2021)

Article Materials Science, Multidisciplinary

Texture Selection Mechanisms during Recrystallization and Grain Growth of a Magnesium-Erbium-Zinc Alloy

Fatim-Zahra Mouhib et al.

Summary: Binary and ternary Mg-1%Er/Mg-1%Er-1%Zn alloys were studied for texture selection during recrystallization and grain growth. The ternary alloy showed a unique TD recrystallization texture and selective growth behavior attributed to solute drag effect. Mg-1%Er-1%Zn alloy demonstrated remarkable enhancement in mechanical properties due to synergic alloying effects.

METALS (2021)

Article Chemistry, Physical

Role of second phases and grain boundaries on dynamic recrystallization behavior in ZK60 magnesium alloy

Peng Peng et al.

Summary: This study investigates the influence of initial grain boundaries, primary particles, and precipitates on dynamic recrystallization behavior and microstructure in Mg-6.0Zn-0.5Zr (ZK60) alloy. The findings demonstrate that initial grain boundaries and particles can promote DRX nucleation, while precipitates can hinder grain boundary migration, affecting grain growth.

JOURNAL OF ALLOYS AND COMPOUNDS (2021)

Article Chemistry, Physical

Effect of Zn addition on the microstructure and mechanical properties of Mg-0.5Ca-0.5RE magnesium alloy

Mahbod Golrang et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2020)

Article Nanoscience & Nanotechnology

Tailoring the mechanical properties of Mg-Zn magnesium alloy by calcium addition and hot extrusion process

Z. Zareian et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2020)

Article Materials Science, Multidisciplinary

On the Direct Extrusion of Magnesium Wires from Mg-Al-Zn Series Alloys

Maria Nienaber et al.

METALS (2020)

Review Materials Science, Multidisciplinary

Review: Achieving enhanced plasticity of magnesium alloys below recrystallization temperature through various texture control methods

Lifei Wang et al.

JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T (2020)

Review Materials Science, Multidisciplinary

A review on the effect of rare-earth elements on texture evolution during processing of magnesium alloys

A. Imandoust et al.

JOURNAL OF MATERIALS SCIENCE (2017)

Article Materials Science, Multidisciplinary

Dynamic Recrystallization Behavior of a Coarse-Grained Mg-2Zn-2Nd Magnesium Alloy

Tong Wang et al.

METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2017)

Article Materials Science, Multidisciplinary

Orientation dependent recrystallization mechanism during static annealing of pure magnesium

R. K. Sabat et al.

MATERIALS CHARACTERIZATION (2017)

Article Materials Science, Multidisciplinary

Microstructure and Texture Through Thixomolding and Thermomechanical Processing and the Role of Mg17Al12 Particles

Tracy D. Berman et al.

METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2016)

Article Materials Science, Multidisciplinary

Texture Modification in a Magnesium-Aluminum-Calcium Alloy During Uniaxial Compression

Victoria M. Miller et al.

METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2016)

Article Materials Science, Multidisciplinary

Structure of grain boundaries with 30°[0001] misorientation in dynamically recrystallized magnesium alloys

B. Li et al.

COMPUTATIONAL MATERIALS SCIENCE (2015)

Article Materials Science, Multidisciplinary

Texture, Second-Phase Particles, and the Anisotropy of Deformation Behavior in TTMP AZ61

Tracy D. Berman et al.

METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2015)

Article Nanoscience & Nanotechnology

Shear band-related recrystallization and grain growth in two rolled magnesium-rare earth alloys

I. Basu et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2013)

Article Nanoscience & Nanotechnology

Effect of prior strain on continuous recrystallization in AZ31 magnesium alloy after hot deformation

Xuyue Yang et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2012)

Article Nanoscience & Nanotechnology

Asymmetric and symmetric rolling of magnesium: Evolution of microstructure, texture and mechanical properties

Somjeet Biswas et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2012)

Article Materials Science, Multidisciplinary

Role of Solute in the Texture Modification During Hot Deformation of Mg-Rare Earth Alloys

Jason P. Hadorn et al.

METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2012)

Article Nanoscience & Nanotechnology

Sheet texture modification in magnesium-based alloys by selective rare earth alloying

T. Al-Samman et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2011)

Article Materials Science, Multidisciplinary

Development of novel grain morphology during hot extrusion of magnesium AZ21 alloy

M. A. Azeem et al.

ACTA MATERIALIA (2010)

Article Nanoscience & Nanotechnology

The effect of calcium on the texture, microstructure and mechanical properties of extruded Mg-Mn-Ca alloys

N. Stanford

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2010)

Article Nanoscience & Nanotechnology

Micro-alloying Mg with Y, Ce, Gd and La for texture modification-A comparative study

N. Stanford

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2010)

Article Nanoscience & Nanotechnology

Texture selection mechanisms in uniaxially extruded magnesium alloys

M. R. Barnett et al.

SCRIPTA MATERIALIA (2010)

Article Materials Science, Multidisciplinary

Particle effects on recrystallization in magnesium-manganese alloys: Particle-stimulated nucleation

J. D. Robson et al.

ACTA MATERIALIA (2009)

Article Materials Science, Multidisciplinary

Deformation Mechanisms in Mg Alloys and the Challenge of Extending Room-temperature Plasticity

M. R. Barnett et al.

Article Nanoscience & Nanotechnology

Effect of particles on the formation of deformation twins in a magnesium-based alloy

N. Stanford et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2009)

Article Materials Science, Multidisciplinary

Texture evolution of Mg during high-pressure torsion

B. J. Bonarski et al.

JOURNAL OF MATERIALS SCIENCE (2008)

Article Nanoscience & Nanotechnology

The origin of rare earth texture development in extruded Mg-based alloys and its effect on tensile ductility

N. Stanford et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2008)

Article Nanoscience & Nanotechnology

Effect of composition on the texture and deformation behaviour of wrought Mg alloys

N. Stanford et al.

SCRIPTA MATERIALIA (2008)

Article Nanoscience & Nanotechnology

The recrystallization and texture of magnesium-zinc-cerium alloys

L. W. F. Mackenzie et al.

SCRIPTA MATERIALIA (2008)

Article Materials Science, Multidisciplinary

The deformation, recrystallisation and texture of three magnesium alloy extrusions

L. W. F. Mackenzie et al.

MATERIALS SCIENCE AND TECHNOLOGY (2007)

Article Nanoscience & Nanotechnology

Structure and thermal stability of primary intermetallic particles in an Mg-Zn casting alloy

X. Gao et al.

SCRIPTA MATERIALIA (2007)

Article Materials Science, Multidisciplinary

The texture and anisotropy of magnesium-zinc-rare earth alloy sheets

Jan Bohlen et al.

ACTA MATERIALIA (2007)

Article Nanoscience & Nanotechnology

Microstructure and texture development during hydrostatic extrusion of magnesium alloy AZ31

J Bohlen et al.

SCRIPTA MATERIALIA (2005)

Article Nanoscience & Nanotechnology

Texture effects on plastic deformation of magnesium

R Gehrmann et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2005)

Article Engineering, Mechanical

Plastic anisotropy and the role of non-basal slip in magnesium alloy AZ31B

SR Agnew et al.

INTERNATIONAL JOURNAL OF PLASTICITY (2005)

Article Nanoscience & Nanotechnology

Viewpoint: experimental recovery of geometrically necessary dislocation density in polycrystals

BS El-Dasher et al.

SCRIPTA MATERIALIA (2003)

Article Materials Science, Multidisciplinary

Dynamic evolution of new grains in magnesium alloy AZ31 during hot deformation

XY Yang et al.

MATERIALS TRANSACTIONS (2003)