Related references
Note: Only part of the references are listed.Effect of Martensite Volume Fraction on Forming Limit Diagrams of Dual-Phase Steel
Mohammad Zaeimi et al.
JOURNAL OF MATERIALS ENGINEERING AND PERFORMANCE (2015)
Numerical and experimental investigations of hydro-mechanical deep drawing process of laminated aluminum/steel sheets
S. Bagherzadeh et al.
JOURNAL OF MANUFACTURING PROCESSES (2015)
Failure analysis at deep drawing of low carbon steels
Matjaz Torkar et al.
ENGINEERING FAILURE ANALYSIS (2014)
Experimental and numerical investigation of anisotropic yield criteria for warm deep drawing of Ti-6Al-4V alloy
Nitin Kotkunde et al.
MATERIALS & DESIGN (2014)
Deep drawability and deformation behavior of AZ31 magnesium alloy sheets at 473 K
Hua Zhang et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2014)
Formability of austenitic and ferritic stainless steels at warm forming temperature
Hyuk Jong Bong et al.
INTERNATIONAL JOURNAL OF MECHANICAL SCIENCES (2013)
Experimental studies of deep drawing of AZ31B magnesium alloy sheet under various thermal conditions
D. Ghaffari Tari et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2013)
Comparing the Formability of AISI 304 and AISI 202 Stainless Steels
M. du Toit et al.
JOURNAL OF MATERIALS ENGINEERING AND PERFORMANCE (2012)
Understanding formability of extra-deep drawing steel at elevated temperature using finite element simulation
Swadesh Kumar Singh et al.
MATERIALS & DESIGN (2010)
A study on the extent of ironing of EDD steel at elevated temperature
Swadesh Kumar Singh et al.
CIRP JOURNAL OF MANUFACTURING SCIENCE AND TECHNOLOGY (2010)
Development of an analytical model for warm deep drawing of aluminum alloys
Hong Seok Kim et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2008)
Effect of process parameters on product surface finish and thickness variation in hydro-mechanical deep drawing
Swadesh Kumar Singh et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2008)
Effect of hot rolling conditions to produce deep drawing quality steels for continuous annealing process
G Erdem et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2005)
Finite element simulation of magnesium alloy sheet forming at elevated temperatures
H Palaniswamy et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2004)
Optimization of annealing parameters for improvement in formability of extra deep drawing quality steel
B Sarkar et al.
JOURNAL OF MATERIALS ENGINEERING AND PERFORMANCE (2004)
Finite element simulation of warm deep drawing of aluminium alloy sheet when accounting for heat conduction
H Takuda et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2002)
Feasibility of warm drawing of aluminium products
PJ Bolt et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2001)
Share Paper
