☆ 4.7 Article

Microstructural evolution and tribology of Mo-doped diamond like carbon nanocomposite film

TRIBOLOGY INTERNATIONAL (2022)

Related references

Note: Only part of the references are listed.

Article Materials Science, Multidisciplinary

Improvement the tribological properties of diamond-like carbon film via Mo doping in diesel condition

Yongyao Su et al.

Summary: Molybdenum-doped diamond-like carbon (Mo-DLC) film was prepared to improve the tribological properties in diesel engines. The Mo doping decreased internal stress and increased adhesion of the film. Additionally, the formation of molybdenum carbide led to the improvement of wear resistance under air and diesel conditions.

VACUUM (2022)

Add to Collection

Article Materials Science, Coatings & Films

Influence of Ag doping on the microstructure, mechanical properties, and adhesion stability of diamond-like carbon films

P. P. Jing et al.

Summary: The study showed that silver doping can improve the microstructure of diamond-like carbon films and enhance the adhesion between the film and substrate. As the silver concentration increases, the residual stress in the DLC films decreases, but the hardness decreases when the silver concentration exceeds 3.2 at.%. Silver doping contributes to enhancing the wear resistance of DLC films.

SURFACE & COATINGS TECHNOLOGY (2021)

Add to Collection

Article Materials Science, Ceramics

A comparative study of duty cycle and argon/methane flow ratio effect on the tribological behavior of DLC coatings over nitrided Astaloy Mo-based steel

Mahsa Haji Ghasemi et al.

Summary: The surface properties of Astaloy Mo-based steel were enhanced by using DLC deposition, which significantly improved hardness and wear behavior. Changes in the Argon/Methane ratio and duty cycle had an impact on the wear mechanisms of DLC coatings, with an increase in mass loss with a rise in the duty cycle and a decrease with an increase in the Argon/Methane ratio. Burnishing, pulling out, and adhesive wear were identified as dominant mechanisms.

CERAMICS INTERNATIONAL (2021)

Add to Collection

Article Chemistry, Physical

Tribochemical mechanism of superlubricity in graphene quantum dots modified DLC films under high contact pressure

Xuan Yin et al.

Summary: By designing three series of tribo-couples based on amorphous carbon films modified by graphene quantum dots and conducting tests under harsh conditions, it was found that the lubrication mechanism of GQDs can achieve a superlubricity state; additionally, the formation of a nanostructured sliding interface is crucial in this process.

CARBON (2021)

Add to Collection

Article Engineering, Mechanical

Double hybrid lubricant additives consisting of a phosphonium ionic liquid and graphene nanoplatelets/hexagonal boron nitride nanoparticles

Khodor I. Nasser et al.

Summary: The tribological performance of polyalphaolefin 32 was investigated with the addition of two nanomaterials and an ionic liquid, showing improvements in anti-friction behavior and anti-wear behavior. The best anti-friction behavior was observed in the PAO/IL3/GnP/h-BN system. Additionally, there were positive synergies found between each ionic liquid and the graphene nanoplatelets/hexagonal boron nitride hybrid additives in the PAO.

TRIBOLOGY INTERNATIONAL (2021)

Add to Collection

Article Engineering, Mechanical

Influence of Si- and W- doping on micro-scale reciprocating wear and impact performance of DLC coatings on hardened steel

Ben D. Beake et al.

Summary: The study indicates that Si-doped DLC exhibits the lowest wear resistance in reciprocating sliding, while undoped DLC is most susceptible to fracture. Despite the low wear resistance in reciprocating sliding, W-doped DLC shows higher damage tolerance in repetitive impacting compared to other coatings.

TRIBOLOGY INTERNATIONAL (2021)

Add to Collection

Article Chemistry, Multidisciplinary

Characterization and Modeling of Nano Wear for Molybdenum-Based Lubrication Layer Systems

Bernd-Arno Behrens et al.

Summary: The research aims to develop a solid lubricant system with regenerative properties, utilizing molybdenum reservoirs and molybdenum trioxide top layers to decrease the use of environmentally harmful greases and oils. Nano testing is used to determine the wear volume of single coatings, and a wear model is developed and validated through wear tests on the mono layers.

NANOMATERIALS (2021)

Add to Collection

Article Materials Science, Multidisciplinary

Raman and EPR spectroscopic studies of chromium-doped diamond-like carbon films

Dariya Savchenko et al.

DIAMOND AND RELATED MATERIALS (2018)

Add to Collection

Article Materials Science, Multidisciplinary

Structural properties of hydrogenated Al-doped diamond-like carbon films fabricated by a hybrid plasma system

Wei Xu et al.

DIAMOND AND RELATED MATERIALS (2018)

Add to Collection

Article Chemistry, Physical

Isothermal and dynamic oxidation behaviour of Mo-W doped carbon-based coating

Paranjayee Mandal et al.

APPLIED SURFACE SCIENCE (2015)

Add to Collection

Article Materials Science, Coatings & Films

Effect of ion bombardment on structural, mechanical, erosion and corrosion properties of Ti-Si-C-N nanocomposite coatings

A. M. Abd El-Rahman et al.

SURFACE & COATINGS TECHNOLOGY (2014)

Add to Collection

Article Materials Science, Coatings & Films

Novel carbon-based nc-MoC/a-C(Al) nanocomposite coating towards low internal stress and low-friction

Shengguo Zhou et al.

SURFACE & COATINGS TECHNOLOGY (2014)

Add to Collection

Article Materials Science, Multidisciplinary

Characterization of AISI 4340 corrosion products using Raman spectroscopy

E. Hazan et al.

CORROSION SCIENCE (2013)

Add to Collection

Article Materials Science, Multidisciplinary

Wear and Corrosion Behavior of Zr-Doped DLC on Ti-13Zr-13Nb Biomedical Alloy

Prateek Kumar et al.

JOURNAL OF MATERIALS ENGINEERING AND PERFORMANCE (2013)

Add to Collection

Article Chemistry, Physical

Mechanical and tribological properties of Ti-DLC films with different Ti content by magnetron sputtering technique

Jinfeng Cui et al.

APPLIED SURFACE SCIENCE (2012)

Add to Collection

Article Materials Science, Multidisciplinary

First principles investigation of interaction between impurity atom (Si, Ge, Sn) and carbon atom in diamond-like carbon system

Xiaowei Li et al.

THIN SOLID FILMS (2012)

Add to Collection

Article Chemistry, Physical

Toluene hydrogenation at low temperature using a molybdenum carbide catalyst

Maria-Laura Frauwallner et al.

APPLIED CATALYSIS A-GENERAL (2011)

Add to Collection

Article Physics, Fluids & Plasmas

The Effect of a TiN Interlayer on the Tribological Properties of Diamond-like Carbon Films Deposited on 7A04 Aluminum Alloy

Yongyao Su et al.

IEEE TRANSACTIONS ON PLASMA SCIENCE (2011)

Add to Collection

Article Materials Science, Multidisciplinary

Micro-Raman study of the m-MoO2 to alpha-MoO3 transformation induced by cw-laser irradiation

M. A. Camacho-Lopez et al.

OPTICAL MATERIALS (2011)

Add to Collection

Article Materials Science, Multidisciplinary

Enhancement of adhesion strength and corrosion resistance of nitrogen or platinum/ruthenium/nitrogen doped diamond-like carbon thin films by platinum/ruthenium underlayer

N. W. Khun et al.

DIAMOND AND RELATED MATERIALS (2010)

Add to Collection

Article Engineering, Mechanical

Thermal dependence of the wear of molybdenum disulphide coatings

Rachel S. Colbert et al.

WEAR (2010)

Add to Collection

Article Materials Science, Coatings & Films

Metal carbide/amorphous C-based nanocomposite coatings for tribological applications

J. C. Sanchez-Lopez et al.

SURFACE & COATINGS TECHNOLOGY (2009)

Add to Collection

Article Materials Science, Multidisciplinary

Microstructural control of TiC/a-C nanocomposite coatings with pulsed magnetron sputtering

Y. T. Pei et al.

ACTA MATERIALIA (2008)

Add to Collection

Article Materials Science, Multidisciplinary

Microstructure and mechanical properties of Mo/DLC nanocomposite films

Li Ji et al.

DIAMOND AND RELATED MATERIALS (2008)

Add to Collection

Article Materials Science, Multidisciplinary

Microstructural response of TiN monolithic and multilayer coatings during microscratch testing

Z. H. Xie et al.

JOURNAL OF MATERIALS RESEARCH (2007)

Add to Collection

Article Chemistry, Physical

In situ Raman spectroscopy of annealed diamondlike carbon-metal composite films

C. Jin et al.

APPLIED SURFACE SCIENCE (2007)

Add to Collection

Article Chemistry, Physical

Structure and mechanical properties of W incorporated diamond-like carbon films prepared by a hybrid ion beam deposition technique

Ai-Ying Wang et al.

CARBON (2006)

Add to Collection

Article Engineering, Mechanical

The study of the adhesion of a TiN coating on steel and titanium alloy substrates using a multi-mode scratch tester

J Stallard et al.

TRIBOLOGY INTERNATIONAL (2006)

Add to Collection

Article Materials Science, Coatings & Films

Toughness measurement of thin films: a critical review

S Zhang et al.

SURFACE & COATINGS TECHNOLOGY (2005)

Add to Collection

Article Materials Science, Multidisciplinary

DLC based coatings prepared by reactive d.c. magnetron sputtering

K Bewilogua et al.

THIN SOLID FILMS (2004)

Add to Collection

Article Engineering, Mechanical

On the significance of the H/E ratio in wear control:: a nanocomposite coating approach to optimised tribological behaviour

A Leyland et al.

WEAR (2000)

Add to Collection

Article Materials Science, Multidisciplinary

Supertough wear-resistant coatings with 'chameleon' surface adaptation

AA Voevodin et al.

THIN SOLID FILMS (2000)

Add to Collection

© Peeref 2019-2024. All rights reserved.