4.6 Article

Motion and swelling of single coal particles during volatile combustion in a laminar flow reactor

Journal

PROCEEDINGS OF THE COMBUSTION INSTITUTE
Volume 39, Issue 3, Pages 3333-3341

Publisher

ELSEVIER SCIENCE INC
DOI: 10.1016/j.proci.2022.07.111

Keywords

Swelling; Motion; Heating rates; Bituminous coal; Particle Reynolds number

Ask authors/readers for more resources

Motion and swelling behavior of single bituminous coal particles during volatile combustion were investigated using a combined experimental and numerical approach. Measurements with high temporal and spatial resolutions provided insights into the interactions of particles with flow and flame. The behavior of particles, including acceleration and rotation speed, was found to be dependent on particle size and devolatilization process.
Motion and swelling behavior of single bituminous coal particles during volatile combustion are investigated in a laminar flow reactor using a joint experimental and numerical approach. Three different particle samples with mean diameters of 90, 120, and 160 mu m are studied in a conventional N-2/O-2 atmosphere with 20 vol% O-2 mole fraction. Diffuse backlight-illumination (DBI) measurements with high temporal (10 kHz) and spatial ( > 19 lp/mm) resolutions, combined with detailed parameter evaluation methods, provide fundamental insights into interactions of particle with flow and flame. The acceleration behavior of different particles is assessed based on the response time following the viscosity drag law. Rotation speed is determined by tempo-rally tracking the orientation angle and shown to strongly correlate with the particle size and the devolatilization process. Simultaneously measured slip velocity and particle diameter enable evaluating time-dependent particle Reynolds numbers Re-p. The swelling behavior is temporally synchronized with the devolatilization process and reveals a strong dependency on particle diameters. To better understand experimental observations, detailed simulations are first quantitatively validated against experimental ignition delay times and then applied to predict particle temperature histories. Further, the reduction of particle heating rates with increasing diameters is numerically quantified. The maximum swelling ratio decreases from 1.22 to 1.07 as the heating rate increases from approximately 3 x 10(4) to 8 x 10(4) K/s. (c) 2022 The Combustion Institute. Published by Elsevier Inc. All rights reserved.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.6
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available