☆ 4.6 Article

Combustion of lean ammonia-hydrogen fuel blends in a porous media burner

PROCEEDINGS OF THE COMBUSTION INSTITUTE (2023)

Related references

Note: Only part of the references are listed.

Article Thermodynamics

An investigation of ammonia primary flame combustor concepts for emissions reduction with OH , NH2 and NH * chemiluminescence at elevated conditions

Daniel Pugh et al.

Summary: With the increasing interest in NH3 as a potential energy carrier, combustor designs and fuel concepts need to be optimized to reduce NOx emissions. The introduction of staged combustor concepts has been identified as a way to limit NOx production, improve combustor efficiency, and reduce unburned NH3. The efficacy of secondary air staging is sensitive to primary flame behavior, and while low NOx emissions can be achieved at rich conditions, high unburned NH3 can lead to greater global NOx concentrations.

PROCEEDINGS OF THE COMBUSTION INSTITUTE (2021)

Add to Collection

Article Thermodynamics

Influence of water addition on MILD ammonia combustion performances and emissions

G. B. Ariemma et al.

Summary: The use of ammonia as an alternative energy carrier poses challenges related to combustion stability and NOx emissions. New combustion modes like MILD Combustion and strategies like water addition to reactants have been explored to address these challenges and improve combustion performance.

PROCEEDINGS OF THE COMBUSTION INSTITUTE (2021)

Add to Collection

Article Thermodynamics

Characteristics of NH3/H2/air flames in a combustor fired by a swirl and bluff-body stabilized burner

Miguel C. Franco et al.

Summary: A novel combustor design utilizing swirl and bluff-body stabilized burner was tested for combustion of NH3. Mathematical modeling and experimental results showed that adding small amounts of H-2 to NH3/H-2/air mixtures can enhance flame stability and reduce NOx and NH3 emissions.

PROCEEDINGS OF THE COMBUSTION INSTITUTE (2021)

Add to Collection

Article Thermodynamics

NO and OH* emission characteristics of very-lean to stoichiometric ammonia-hydrogen-air swirl flames

Xuren Zhu et al.

Summary: The experimental investigation showed that using ammonia-hydrogen mixtures as fuel under lean conditions can lead to low NO emissions. The intensity of OH* chemiluminescence can serve as a proxy for the NO mole fraction, providing a low-cost technique to evaluate NO emissions from flames fueled with hydrogen-enriched ammonia blends.

PROCEEDINGS OF THE COMBUSTION INSTITUTE (2021)

Add to Collection

Article Thermodynamics

Humidified ammonia/hydrogen RQL combustion in a trigeneration gas turbine cycle

M. Gutesa Bozo et al.

Summary: The study examines the implementation of a high-efficiency gas turbine cycle using ammonia as a fuel, which can increase efficiency, reduce emissions, and shows significant potential for development.

ENERGY CONVERSION AND MANAGEMENT (2021)

Add to Collection

Article Chemistry, Physical

Rich-Quench-Lean model comparison for the clean use of humidified ammonia/hydrogen combustion systems

S. Mashruk et al.

Summary: Ammonia and hydrogen are zero-carbon fuels with high potential for gas turbine technologies, but nitrogen oxide emissions pose a major challenge. Rich-Quench-Lean systems with humidified atmospheres are promising solutions for reducing emissions through recombination of species and lower combustion temperatures.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2021)

Add to Collection

Review Energy & Fuels

Applications of porous materials in combustion systems: A comprehensive and state-of-the-art review

Ayat Gharehghani et al.

Summary: Porous materials offer advantages in combustion systems such as extending lean-burn limits and reducing pollutant emissions. Studies over the past two decades have evaluated the practicality and performance of porous media combustion.

FUEL (2021)

Add to Collection

Article Thermodynamics

Fully explicit formulae for flame speed in infinite and finite porous media

Pierre-Alexandre Masset et al.

Summary: This study introduces new analytical expressions for gaseous flames in inert porous media, focusing on the negligible impact of interphase heat transfer on flame structure. By solving gas and solid equations separately, the preheating of fresh gases ahead of the flame front is calculated, and multiple formulas for flame speed in porous media are provided. The explicit and ready-to-use nature of this theory is practical for designs, and the work aligns with previous theoretical, numerical, and experimental trends in the literature.

COMBUSTION THEORY AND MODELLING (2021)

Add to Collection

Article Thermodynamics

Pore-resolved simulations of porous media combustion with conjugate heat transfer

Joseph C. Ferguson et al.

Summary: This paper investigates the influence of conjugate heat transfer on flame stability and propagation behavior in porous media combustion, showing that the flame stability regime shifts to higher velocities as the conductivity of the solid material increases.

PROCEEDINGS OF THE COMBUSTION INSTITUTE (2021)

Add to Collection

Article Energy & Fuels

An updated short chemical-kinetic nitrogen mechanism for carbon-free combustion applications

Yuanjie Jiang et al.

INTERNATIONAL JOURNAL OF ENERGY RESEARCH (2020)

Add to Collection

Article Thermodynamics

Experimental investigation of lean premixed pre-vaporized liquid-fuel combustion in porous media burners at elevated pressures up to 20 bar

Sadaf Sobhani et al.

COMBUSTION AND FLAME (2020)

Add to Collection

Review Chemistry, Multidisciplinary

Progress and Prospective of Nitrogen-Based Alternative Fuels

Oren Elishav et al.

CHEMICAL REVIEWS (2020)

Add to Collection

Article Chemistry, Physical

Stability limits and NO emissions of technically-premixed ammonia-hydrogen-nitrogen-air swirl flames

Abdulrahman A. Khateeb et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2020)

Add to Collection

Article Thermodynamics

Modulation of heat transfer for extended flame stabilization in porous media burners via topology gradation

Sadaf Sobhani et al.

PROCEEDINGS OF THE COMBUSTION INSTITUTE (2019)

Add to Collection

Article Thermodynamics

Towards the development of an efficient low-NOx ammonia combustor for a micro gas turbine

Ekenechukwu C. Okafor et al.

PROCEEDINGS OF THE COMBUSTION INSTITUTE (2019)

Add to Collection

Article Thermodynamics

Influence of steam addition and elevated ambient conditions on NOx reduction in a staged premixed swirling NH3/H2 flame

Daniel Pugh et al.

PROCEEDINGS OF THE COMBUSTION INSTITUTE (2019)

Add to Collection

Review Thermodynamics

Heat recirculating reactors: Fundamental research and applications

Janet L. Ellzey et al.

PROGRESS IN ENERGY AND COMBUSTION SCIENCE (2019)

Add to Collection

Article Energy & Fuels

Combustion of NH3/CH4/Air and NH3/H2/Air Mixtures in a Porous Burner: Experiments and Kinetic Modeling

Rodolfo C. Rocha et al.

ENERGY & FUELS (2019)

Add to Collection

Review Thermodynamics

Ammonia for power

A. Valera-Medina et al.

PROGRESS IN ENERGY AND COMBUSTION SCIENCE (2018)

Add to Collection

Article Computer Science, Software Engineering

PuMA: the Porous Microstructure Analysis software

Joseph C. Ferguson et al.

SOFTWAREX (2018)

Add to Collection

Article Chemistry, Physical

Experimental investigation of stabilization and emission characteristics of ammonia/air premixed flames in a swirl combustor

Akihiro Hayakawa et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2017)

Add to Collection

Article Chemistry, Physical

Preliminary study on lean premixed combustion of ammonia-hydrogen for swirling gas turbine combustors

A. Valera-Medina et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2017)

Add to Collection

Article Chemistry, Physical

Porous medium based burner for efficient and clean combustion of ammonia-hydrogen-air systems

Hadi Nozari et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2017)

Add to Collection

Article Thermodynamics

An investigation of internal flame structure in porous media combustion via X-ray Computed Tomography

Jared Dunnmon et al.

PROCEEDINGS OF THE COMBUSTION INSTITUTE (2017)

Add to Collection

Article Thermodynamics

Experimental study, 1D volume-averaged calculations and 3D direct pore level simulations of the flame stabilization in porous inert media at elevated pressure

C. Bedoya et al.

COMBUSTION AND FLAME (2015)

Add to Collection

Article Thermodynamics

Numerical analysis on the transient measurement of gas temperature in porous material using thermocouples at high temperatures

Xue Chen et al.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2015)

Add to Collection

Article Chemistry, Physical

On a porous medium combustor for hydrogen flame stabilization and operation

Siou-Sheng Su et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2014)

Add to Collection

Article Thermodynamics

Maximum superadiabatic temperature for stabilized flames within porous inert media

Fernando M. Pereira et al.

COMBUSTION AND FLAME (2011)

Add to Collection

Article Energy & Fuels

Adiabatic premixed combustion in a gaseous fuel porous inert media under high pressure and temperature: Novel flame stabilization technique

Ayman Bakry et al.

FUEL (2011)

Add to Collection

Article Thermodynamics

Gas and solid phase temperature measurements of porous media combustion

Chenghang Zheng et al.

PROCEEDINGS OF THE COMBUSTION INSTITUTE (2011)

Add to Collection

Review Thermodynamics

Trends in modeling of porous media combustion

M. Abdul Mujeebu et al.

PROGRESS IN ENERGY AND COMBUSTION SCIENCE (2010)

Add to Collection

Article Engineering, Chemical

Morphological Characterization of Ceramic Sponges for Applications in Chemical Engineering

Julia Grosse et al.

INDUSTRIAL & ENGINEERING CHEMISTRY RESEARCH (2009)

Add to Collection

Review Thermodynamics

Porous burners for lean-burn applications

Susie Wood et al.

PROGRESS IN ENERGY AND COMBUSTION SCIENCE (2008)

Add to Collection

© Peeref 2019-2024. All rights reserved.