☆ 4.7 Article

Transmission friction measurement and suppression of dual-inertia system based on RBF neural network and nonlinear disturbance observer

MEASUREMENT (2022)

Related references

Note: Only part of the references are listed.

Article Engineering, Multidisciplinary

Nonlinear analysis of cylindrical gear dynamics under varying tooth breakage

Lukasz Jedlinski et al.

Summary: This study conducted linear and nonlinear analyses on a commonly used cylindrical gear to detect the extent of tooth damage. Due to vibrations and disturbances in the test equipment, traditional vibration signal analysis methods failed to provide conclusive and satisfactory results. Therefore, nonlinear recurrence analysis was adopted to address the issue of determining the level of gear tooth damage.

MEASUREMENT (2022)

Add to Collection

Article Engineering, Mechanical

An improved partial similitude method for dynamic characteristic of rotor systems based on Levenberg-Marquardt method

Lei Li et al.

Summary: Similitude theory is widely used in predicting the structural responses of full-size prototypes through scaled models. Partial similitude, more flexible in practical design, needs improvement in accuracy. An improved partial similitude approach is presented in this study to establish scaling laws for rotor systems and to overcome the insufficient accuracy of existing methods in predicting dynamic characteristics. The accuracy and effectiveness of this approach are validated through numerical and experimental case studies, showing higher accuracy than existing methods.

MECHANICAL SYSTEMS AND SIGNAL PROCESSING (2022)

Add to Collection

Article Engineering, Multidisciplinary

Dynamic modeling and fuzzy compensation sliding mode control for flexible manipulator servo system

Dongyang Shang et al.

Summary: This study proposes a model simplification method and an improved control strategy for the complex flexible manipulator servo system. The model simplification method ignores the second-order modal deformation, while the improved control strategy utilizes fuzzy compensation sliding mode control to reduce chattering and angular velocity errors. Simulation experiments and physical control experiments validate the effectiveness of the improved strategy.

APPLIED MATHEMATICAL MODELLING (2022)

Add to Collection

Article Engineering, Aerospace

Dynamic modeling and fuzzy adaptive control strategy for space flexible robotic arm considering joint flexibility based on improved sliding mode controller

Dongyang Shang et al.

Summary: This paper proposes an improved sliding mode control strategy based on fuzzy compensation to enhance the trajectory tracking accuracy of space flexible robotic arms. Numerical simulation and experimental results demonstrate the effectiveness of the strategy in reducing speed fluctuations and significantly decreasing trajectory tracking errors.

ADVANCES IN SPACE RESEARCH (2022)

Add to Collection

Article Engineering, Aerospace

Adaptive fuzzy neural network control for a space manipulator in the presence of output constraints and input nonlinearities

Qijia Yao

Summary: This paper proposes an adaptive fuzzy neural network (FNN) control scheme for trajectory tracking control of an attitude-controlled free-flying space manipulator, which can effectively address parametric uncertainties and external disturbances in the presence of output constraints and input nonlinearities, ensuring position tracking errors converge to small neighborhoods about zero. Rigorous theoretical analysis is provided for the system's ultimate boundedness, and numerical simulations demonstrate the effectiveness and superiority of the proposed control scheme.

ADVANCES IN SPACE RESEARCH (2021)

Add to Collection

Article Automation & Control Systems

PID with a Switching Action Controller for Nonlinear Systems of Second-order Controller Canonical Form

MyoungHo Kim et al.

Summary: The PID with a switching action (PIDSA) controller proposed in the study combines the simplicity of PID and the robustness of sliding mode control (SMC) to enhance the control performance of nonlinear systems. The addition of a double integral sliding surface (DISS) further improves the performance compared to using an integral sliding surface, as demonstrated in experiments on a hydraulic manipulator.

INTERNATIONAL JOURNAL OF CONTROL AUTOMATION AND SYSTEMS (2021)

Add to Collection

Article Automation & Control Systems

Fine Load-Side Acceleration Control Based on Torsion Torque Sensing of Two-Inertia System

Yuki Yokokura et al.

IEEE TRANSACTIONS ON INDUSTRIAL ELECTRONICS (2020)

Add to Collection

Article Computer Science, Artificial Intelligence

Mechanism and Position Tracking Control of a Robotic Manipulator Actuated by the Tendon-Sheath

Meng Yin et al.

JOURNAL OF INTELLIGENT & ROBOTIC SYSTEMS (2020)

Add to Collection

Article Education, Scientific Disciplines

Resonant Suppression Method Based on PI control for Serial Manipulator Servo Drive System

Xiaopeng Li et al.

SCIENCE PROGRESS (2020)

Add to Collection

Article Automation & Control Systems

Analysis of Oscillation Frequency Deviation in Elastic Coupling Digital Drive System and Robust Notch Filter Strategy

Yangyang Chen et al.

IEEE TRANSACTIONS ON INDUSTRIAL ELECTRONICS (2019)

Add to Collection

Article Engineering, Mechanical

Dynamic performance analysis of parallel manipulators based on two-inertia-system

Liping Wang et al.

MECHANISM AND MACHINE THEORY (2019)

Add to Collection

Article Automation & Control Systems

High-Precision Robust Force Control of a Series Elastic Actuator

Sehoon Oh et al.

IEEE-ASME TRANSACTIONS ON MECHATRONICS (2017)

Add to Collection

Article Automation & Control Systems

Design of a Disturbance Observer for a Two-Link Manipulator With Flexible Joints

Jong Nam Yun et al.

IEEE TRANSACTIONS ON CONTROL SYSTEMS TECHNOLOGY (2014)

Add to Collection

Article Engineering, Mechanical

Passivity-based control of single-link flexible manipulators using a linear strain feedback

Vicente Feliu et al.

MECHANISM AND MACHINE THEORY (2014)

Add to Collection

Article Automation & Control Systems

Nonlinear disturbance observer design for robotic manipulators

A. Mohammadi et al.

CONTROL ENGINEERING PRACTICE (2013)

Add to Collection

Article Automation & Control Systems

Revisiting the LuGre Friction Model STICK-SLIP MOTION AND RATE DEPENDENCE

Karl Johan Astrom et al.

IEEE CONTROL SYSTEMS MAGAZINE (2008)

Add to Collection

Article Automation & Control Systems

A nonlinear disturbance observer for robotic manipulators

WH Chen et al.

IEEE TRANSACTIONS ON INDUSTRIAL ELECTRONICS (2000)

Add to Collection

© Peeref 2019-2024. All rights reserved.