Journal
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
Volume 857, Issue -, Pages -Publisher
ELSEVIER SCIENCE SA
DOI: 10.1016/j.msea.2022.144084
Keywords
Additive manufacturing; Directed energy deposition; Heat treatment; Super duplex stainless steel; Microstructure; Mechanical properties
Categories
Funding
- Ministry of Industry and Trade of the Czech Republic [3/2018]
- MEYS CR [A1_FCHT_2022_007]
- [LM2018110]
Ask authors/readers for more resources
This study investigates the properties of SAF2507 steel prepared by the directed energy deposition (DED) method. The results show that the material produced by DED has a higher content of austenite compared to other additive manufacturing methods, and the microstructure and mechanical properties of the material undergo changes during solution annealing.
Super duplex stainless steel SAF2507 is characterized by good mechanical properties and corrosion resistance. However, the combination of high strength and corrosion resistance requires the balanced ratio of austenite and ferrite in microstructure. At the same time, the presence of other secondary phases such as intermetallic phases (sigma, chi), carbides (M7C3, M23C6) and nitrides (pi, CrN, Cr2N) is strongly undesirable. Additive manufacturing of duplex stainless steel has not been described in detail yet and the existing studies deal with the duplex stainless steels deposited by powder bed methods primarily. This study investigates the properties of steel SAF2507 prepared by the directed energy deposition (DED) method in the as-built state and after post-manufacturing solution annealing at 1100 degrees C for 60 min followed by water quenching and compares them with the duplex stainless steel additively manufactured by powder methods and conventional ways of preparation. Microstruc-ture, phase composition and mechanical properties of both materials were studied in detail. The material after DED contains of about 28 wt% austenite, which is much more compared to additively manufactured duplex stainless steels by powder bed. The as-built state contained allotriomorphic grain boundary austenite (GBA), Widmansta center dot tten austenite (WA) and intragranular austenite (IGA). Coarsening of austenite occurred during so-lution annealing, while ferrite's grains size decreased. The solution annealed material achieves approximately the desired ratio of austenite-ferrite 50:50. Yield strength decreased slightly during solution annealing from 680 MPa to 540 MPa, whereas elongation and notch toughness increase. The ductile to brittle transition temperature (about-100 degrees C) did not change significantly during solution annealing.
Authors
I am an author on this paper
Click your name to claim this paper and add it to your profile.
Reviews
Recommended
No Data Available