Thermo-responsive Fluorinated Organogels Showing Anti-fouling and Long-Lasting/Repeatable Icephobic Properties

Accumulations of ice on modern infrastructures often cause severe consequences. As such, there is significant interest in developing functional coatings/surfaces that can prevent this. One such approach has been demonstrated with slippery liquid-infused porous surfaces (SLIPS) and organogels where the ice adhesion strength is reduced to the critical point (less than 10 kPa) where it can be removed by natural forces such as gravity, wind, vibrations, and so forth. However, both designs are limited by lubricant depletion. If lubricant release and reabsorption (syneresis) of organogels can be arbitrarily controlled by the surrounding temperature, the loss due to unfavorable evaporation and drainage of infused lubricants can be minimized and its durability can be extended. This study demonstrates the tunable thermo-responsive syneresis of transparent fluorinated organogels (F-ORGs) prepared from a commercial silicone elastomer and a lubricant mixture of fluorinated silicone oil and either poly(dimethylsiloxane) or poly(methylphenylsiloxane). By carefully tuning the ratio of the two lubricants in the mixture, the corresponding F-ORGs demonstrated arbitrarily tunable critical syneresis temperatures from -15 to 40 degrees C, below which the lubricant is released on the surface and above which the lubricant is re-absorbed. The resulting surfaces showed not only exceptionally long-lasting/repeatable low ice adhesion strengths (<= 10 kPa over 50 icing/de-icing cycles) but also significant improvements in their repellency toward a variety of organic liquids. Compared to non-fluorinated organogels, F-ORGs could offer improved protection against outdoor pollutants to further enhance their practicality.

Automated summary

This study demonstrates the tunable thermo-responsive syneresis of transparent fluorinated organogels, which can release and reabsorb lubricants based on surrounding temperatures, leading to improved durability and repellency of coatings.