Related references
Note: Only part of the references are listed.Impact of the thermomechanical load on subsurface phase transformations during cryogenic turning of metastable austenitic steels
Hendrik Hotz et al.
JOURNAL OF INTELLIGENT MANUFACTURING (2021)
Eddy Current Detection of the Martensitic Transformation in AISI304 Induced upon Cryogenic Cutting
Lara V. Fricke et al.
STEEL RESEARCH INTERNATIONAL (2021)
Deformation-induced martensitic transformation in AISI304 by cryogenic machining
Lara Vivian Fricke et al.
MATERIALS LETTERS (2021)
Quantitative Evaluation of Deformation Induced Martensite in Austenitic Stainless Steel Using Magnetic NDE Techniques
Esmaeel Ahmadzade-Beiraki et al.
JOURNAL OF NONDESTRUCTIVE EVALUATION (2020)
Influence of tool properties on thermomechanical load and surface morphology when cryogenically turning metastable austenitic steel AISI 347
Hendrik Hotz et al.
JOURNAL OF MANUFACTURING PROCESSES (2020)
Surface layer hardening of metastable austenitic steel - Comparison of shot peening and cryogenic turning
Hendrik Hotz et al.
JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T (2020)
Nondestructive Testing with 3MAAn Overview of Principles and Applications
Bernd Wolter et al.
APPLIED SCIENCES-BASEL (2019)
In-situ Characterization by Eddy Current Testing of Graded Microstructural Evolution in the Core and Peripheral Zone during Material Conversion during Case Hardening
L. V. Fricke et al.
HTM-JOURNAL OF HEAT TREATMENT AND MATERIALS (2019)
Change of magnetic properties in austenitic stainless steels due to plastic deformation
Tatiana Orsulova et al.
ECF22 - LOADING AND ENVIRONMENTAL EFFECTS ON STRUCTURAL INTEGRITY (2018)
Deformation induced hardening when cryogenic turning
Patrick Mayer et al.
CIRP JOURNAL OF MANUFACTURING SCIENCE AND TECHNOLOGY (2018)
An Experimental Study on Strain Rate Sensitivity of Strain-induced Martensitic Transformation in SUS304 by Real-time Measurement of Relative Magnetic Permeability
Bo Cao et al.
STEEL RESEARCH INTERNATIONAL (2017)
In-Situ Investigation of Strain-Induced Martensitic Transformation Kinetics in an Austenitic Stainless Steel by Inductive Measurements
Carola Celada-Casero et al.
METALS (2017)
Contributions of ε and α' TRIP Effects to the Strength and Ductility of AISI 304 (X5CrNi18-10) Austenitic Stainless Steel
Andreas Weiss et al.
METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2016)
Sensor-controlled bainitic transformation and microstructure formation of forgings during the cooling process
O. Bruchwald et al.
MATERIALWISSENSCHAFT UND WERKSTOFFTECHNIK (2016)
Influence of cutting edge geometry on deformation induced hardening when cryogenic turning of metastable austenitic stainless steel AISI 347
Patrick Mayer et al.
3RD CIRP CONFERENCE ON SURFACE INTEGRITY (2016)
Investigation of wear resistance of dry and cryogenic turned metastable austenitic steel shafts and dry turned and ground carburized steel shafts in the radial shaft seal ring system
D. Froelich et al.
WEAR (2015)
Quantification of deformation induced α′-martensite in Fe-19Cr-3Mn-4Ni-0.15C-0.15N austenitic steel by in situ magnetic measurements
M. Hauser et al.
MATERIALS SCIENCE AND TECHNOLOGY (2015)
Deformation induced surface hardening when turning metastable austenitic steel AISI 347 with different cryogenic cooling strategies
Patrick Mayer et al.
6TH CIRP INTERNATIONAL CONFERENCE ON HIGH PERFORMANCE CUTTING (HPC2014) (2014)
Identification of the Direction-Dependency of the Martensitic Transformation in Stainless Steel Using In Situ Magnetic Permeability Measurements
A. M. Beese et al.
EXPERIMENTAL MECHANICS (2011)
Characterization of strain-induced martensitic transformation in a metastable austenitic stainless steel
P. Hausild et al.
MATERIALS & DESIGN (2010)
Eddy current detection of changes in stainless steel after cold reduction
S. H. Khan et al.
COMPUTATIONAL MATERIALS SCIENCE (2008)
Grain Size Effect on the Structural Parameters of the Stress Induced epsilon(hcp) - Martensite in Iron-Based Shape Memory Alloy
Fabiana Cristina Nascimento et al.
MATERIALS RESEARCH-IBERO-AMERICAN JOURNAL OF MATERIALS (2008)
Eddy currents and hardness testing for evaluation of steel decarburizing
D. Mercier et al.
NDT & E INTERNATIONAL (2006)
Comparison of different methods for measuring strain induced alpha '-martensite content in austenitic steels
J Talonen et al.
MATERIALS SCIENCE AND TECHNOLOGY (2004)
Microstructural evolution of ultrafine grained structure in plain carbon steels through single pass rolling
H Beladi et al.
MATERIALS SCIENCE AND TECHNOLOGY (2004)
Athena MIMOS II Mossbauer spectrometer investigation -: art. no. 8067
G Klingelhöfer et al.
JOURNAL OF GEOPHYSICAL RESEARCH-PLANETS (2003)
Mossbauer and SEM characterisation of the scale on type 304 stainless steel
FB Waanders et al.
SCRIPTA MATERIALIA (2000)
Share Paper
