Related references
Note: Only part of the references are listed.Microstructure and mechanical properties of SiCnp/Al6082 aluminum matrix composites prepared by squeeze casting combined with stir casting
Junwen Zhu et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2020)
Effect of Mn/Fe ratio on the microstructure and properties of 6061 sheets obtained by twin-roll cast
Zhen Xu et al.
MATERIALS CHARACTERIZATION (2020)
Microstructure and mechanical properties of high-manganese-containing high-speed twin-roll cast Al-Mn-Si alloy strips and their cold-rolled sheets
T. Ha Nguyen et al.
17TH INTERNATIONAL CONFERENCE ON ALUMINIUM ALLOYS 2020 (ICAA17) (2020)
Study on hot deformation behavior and intrinsic workability of 6063 aluminum alloys using 3D processing map
Yang Liu et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2017)
Predicting the Formation of Intermetallic Phases in the Al-Si-Fe System with Mn Additions
Lucas Barcelos Otani et al.
JOURNAL OF PHASE EQUILIBRIA AND DIFFUSION (2017)
The influence of Mg/Si ratio and Cu content on the stretch formability of 6xxx aluminium alloys
Hao Zhong et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2016)
Enhanced Strengthening in Ultrafine-Grained Al-Mg-Si Alloys Produced via ECAP with Parallel Channels
Elena Vladimirovna Bobruk et al.
ADVANCED ENGINEERING MATERIALS (2015)
Twin-roll casting and finishing treatment of thin strips of the hardening aluminum alloy EN AW-6082
M. Stolbchenko et al.
MATERIALS TODAY-PROCEEDINGS (2015)
Effects of homogenization on microstructures and properties of a new type Al-Mg-Mn-Zr-Ti-Er alloy
L. Z. He et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2010)
The effect of erbium on the microstructure and mechanical properties of Al-Mg-Mn-Zr alloy
S. P. Wen et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2009)
Influence of the rare earth content on the electrochemical behaviour of Al-Mg-Er alloys
F Rosalbino et al.
INTERMETALLICS (2003)
Share Paper
