A pnCCD-based, fast direct single electron imaging camera for TEM and STEM

We report on a new camera that is based on a pnCCD sensor for applications in scanning transmission electron microscopy. Emerging new microscopy techniques demand improved detectors with regards to readout rate, sensitivity and radiation hardness, especially in scanning mode. The pnCCD is a 2D imaging sensor that meets these requirements. Its intrinsic radiation hardness permits direct detection of electrons. The pnCCD is read out at a rate of 1; 150 frames per second with an image area of 264 x 264 pixel. In binning or windowing modes, the readout rate is increased almost linearly, for example to 4; 000 frames per second at 4x binning (264 x 66 pixel). Single electrons with energies from 300 keV down to 5 keV can be distinguished due to the high sensitivity of the detector. Three applications in scanning transmission electron microscopy are highlighted to demonstrate that the pnCCD satisfies experimental requirements, especially fast recording of 2D images. In the first application, 65; 536 2D diffraction patterns were recorded in 70 s. STEM images corresponding to intensities of various diffraction peaks were reconstructed. For the second application, the microscope was operated in a Lorentz-like mode. Magnetic domains were imaged in an area of 256 x 256 sample points in less than 37 seconds for a total of 65; 536 images each with 264 x 132 pixels. Due to information provided by the two-dimensional images, not only the amplitude but also the direction of the magnetic field could be determined. In the third application, millisecond images of a semiconductor nanostructure were recorded to determine the lattice strain in the sample. A speed-up in measurement time by a factor of 200 could be achieved compared to a previously used camera system.