4.7 Article

Sustainable dewatering of unconventional gas wells using engineered multiphase flow dynamics

Journal

FUEL
Volume 324, Issue -, Pages -

Publisher

ELSEVIER SCI LTD
DOI: 10.1016/j.fuel.2022.124675

Keywords

Foam assisted gas lift; Foam flow; Particle lifting; Unconventional gas well; Coal seam gas

Funding

  1. Australian Research Council [ARC LP170100659]
  2. Shell Australia
  3. Energi Simulation for the University of Queensland Research Training Stipend and Research Higher Degree Top-Up Scholarships
  4. University of Queensland

Ask authors/readers for more resources

This paper investigates and demonstrates the feasibility of using foam assisted gas lift (FAGL) for dewatering unconventional gas wells. The study shows that foam flow can effectively lift gas, liquid, and solid particulates, while maintaining a low flowing bottom hole pressure (FBHP) for a wide range of gas and water flow rates.
This paper aims to investigate and demonstrate, for the first time, the feasibility of using an artificial lift system, referred to as foam assisted gas lift (FAGL) for dewatering unconventional gas wells to depressurise coal and allow gas to be produced. More specifically, this paper investigates the capability of a three-phase foam flow to lift gas, liquid and solid particulates to the surface to optimise gas production by minimising the flowing bottom hole pressure (FBHP) and minimising downtime, operational costs and production losses caused by downhole pump failures. A laboratory set-up of a 9 m vertical tubing with 80 mm (3.1 in) ID and a 7 m annulus with a casing inner diameter of 170 mm (6.69 in) and tubing outer diameter of 70 mm (2.76 in) are used to investigate the foam flow behaviour in both geometries for a wide range of gas and water flowrates, 40-6500 L/min and 10-80 L/min, respectively. The 80 mm tubing is pressurised up to 6 bar, allowing examining the foam flow characteristics and foam stability at different depths of a gas well, by changing the operating pressure. Foam flow regimes in the tubing and the annulus, which are key in determining the FBHP are characterised by analysing differential pressure signals, collected at 100 Hz frequency. The addition of foamer (sodium dodecylbenzene sulfonate) significantly advanced the transition from churn to the annular flow regime, resulting in a lower required gas flow rate to obtain the least attainable FBHP. A model is developed to evaluate the FBHP of the FAGL, compared against the measured FBHP in 36 gas wells in Australia, equipped with down-hole pumps for dewatering. Our results indicate that FAGL is capable of maintaining a low FBHP for a wide range of gas and water flow rates. The effective particle lifting capacity of foam flow is also demonstrated. Further, the positive impact of water salinity (0.1 M NaCl) in the presence of particles (15-25 g/l) on foam integrity is presented.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.7
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available