4.7 Article

An artificial intelligence-based conductivity prediction and feature analysis of carbon fiber reinforced cementitious composite for non-destructive structural health monitoring

Related references

Note: Only part of the references are listed.
Article Construction & Building Technology

Shear strength and failure criterion of carbon fiber reinforced coral concrete under combined compression-shear stresses

Bing Liu et al.

Summary: With the rapid development of the marine industry, the potential use of coral concrete (CC) in island construction has been recognized. This study investigated the shear strength of carbon fiber reinforced coral concrete (CFRCC) under combined compression-shear stresses. The results showed that the shear strength increased with the increase in normal stress ratio, and the addition of carbon fiber improved the shear strength and reduced spalling of concrete. The optimal carbon fiber dosage was approximately 1.5%.

CONSTRUCTION AND BUILDING MATERIALS (2022)

Article Construction & Building Technology

Thermal and mechanical properties of demolition wastes in geothermal pavements by experimental and machine learning techniques

Behnam Ghorbani et al.

Summary: This study investigated the thermal conductivity and response to combined dynamic loads and temperature of recycled concrete aggregate, crushed brick, waste rock, and reclaimed asphalt pavement. The results showed that RCA and CB had higher thermal conductivity compared to WR and RAP, and different deformation behaviors were observed under different temperatures through repeated loading triaxial tests. An artificial neural network model was developed to provide new insights into the deformation behavior of C&D materials at different temperatures, which were consistent with the experimental results.

CONSTRUCTION AND BUILDING MATERIALS (2021)

Article Construction & Building Technology

A metaheuristic-optimized multi-output model for predicting multiple properties of pervious concrete

Junfei Zhang et al.

CONSTRUCTION AND BUILDING MATERIALS (2020)

Article Construction & Building Technology

The mechanical properties and microstructure of carbon fibers reinforced coral concrete

Bing Liu et al.

CONSTRUCTION AND BUILDING MATERIALS (2020)

Article Construction & Building Technology

Multi-objective optimization of concrete mixture proportions using machine learning and metaheuristic algorithms

Junfei Zhang et al.

CONSTRUCTION AND BUILDING MATERIALS (2020)

Article Construction & Building Technology

XGBoost algorithm-based prediction of concrete electrical resistivity for structural health monitoring

Wei Dong et al.

AUTOMATION IN CONSTRUCTION (2020)

Article Construction & Building Technology

Prediction of surface chloride concentration of marine concrete using ensemble machine learning

Rong Cai et al.

CEMENT AND CONCRETE RESEARCH (2020)

Review Engineering, Multidisciplinary

A state-of-the-art on self-sensing concrete: Materials, fabrication and properties

Zhuang Tian et al.

COMPOSITES PART B-ENGINEERING (2019)

Review Construction & Building Technology

A review on material design, performance, and practical application of electrically conductive cementitious composites

Lining Wang et al.

CONSTRUCTION AND BUILDING MATERIALS (2019)

Article Construction & Building Technology

Multifunctional electrically conductive concrete using different fillers

Amr S. El-Dieb et al.

JOURNAL OF BUILDING ENGINEERING (2018)

Article Construction & Building Technology

Mechanical, electrical and self-sensing properties of cementitious mortars containing short carbon fibers

Jacopo Donnini et al.

JOURNAL OF BUILDING ENGINEERING (2018)

Review Materials Science, Multidisciplinary

Electrical Resistivity of Concrete for Durability Evaluation: A Review

Pejman Azarsa et al.

ADVANCES IN MATERIALS SCIENCE AND ENGINEERING (2017)

Article Materials Science, Ceramics

Dispersion of carbon fibers and conductivity of carbon fiber-reinforced cement-based composites

Wang Chuang et al.

CERAMICS INTERNATIONAL (2017)

Article Computer Science, Interdisciplinary Applications

Deep Learning-Based Crack Damage Detection Using Convolutional Neural Networks

Young-Jin Cha et al.

COMPUTER-AIDED CIVIL AND INFRASTRUCTURE ENGINEERING (2017)

Review Construction & Building Technology

Machine learning for durability and service-life assessment of reinforced concrete structures: Recent advances and future directions

Woubishet Zewdu Taffese et al.

AUTOMATION IN CONSTRUCTION (2017)

Article Construction & Building Technology

Application of machine learning to construction injury prediction

Antoine J-P. Tixier et al.

AUTOMATION IN CONSTRUCTION (2016)

Article Engineering, Multidisciplinary

Carbon fibre reinforced cement-based composites as smart floor heating materials

Manuel Hambach et al.

COMPOSITES PART B-ENGINEERING (2016)

Article Construction & Building Technology

Reinforcement effect and mechanism of carbon fibers to mechanical and electrically conductive properties of cement-based materials

Baoguo Han et al.

CONSTRUCTION AND BUILDING MATERIALS (2016)

Editorial Material Engineering, Electrical & Electronic

Structural Health Monitoring: Technological Advances to Practical Implementations

Jerome P. Lynch et al.

PROCEEDINGS OF THE IEEE (2016)

Article Construction & Building Technology

Three-phase composite conductive concrete for pavement deicing

Jianmin Wu et al.

CONSTRUCTION AND BUILDING MATERIALS (2015)

Article Construction & Building Technology

The effects of specimen parameters on the resistivity of concrete

Chun-Tao Chen et al.

CONSTRUCTION AND BUILDING MATERIALS (2014)

Article Construction & Building Technology

Use of electrical resistivity as an indicator for durability

Ozkan Sengul

CONSTRUCTION AND BUILDING MATERIALS (2014)

Article Materials Science, Multidisciplinary

Effect of aspect ratio on strain sensing capacity of carbon fiber reinforced cement composites

F. J. Baeza et al.

MATERIALS & DESIGN (2013)

Article Construction & Building Technology

Crack Detection Application for Fiber Reinforced Concrete Using BOCDA-Based Optical Fiber Strain Sensor

Michio Imai et al.

JOURNAL OF STRUCTURAL ENGINEERING (2010)

Article Computer Science, Artificial Intelligence

Fast crack detection method for large-size concrete surface images using percolation-based image processing

Tomoyuki Yamaguchi et al.

MACHINE VISION AND APPLICATIONS (2010)

Article Materials Science, Multidisciplinary

Predicting the compressive strength of steel fiber added lightweight concrete using neural network

Fatih Altun et al.

COMPUTATIONAL MATERIALS SCIENCE (2008)

Review Engineering, Electrical & Electronic

Fibre Bragg gratings in structural health monitoring - Present status and applications

Mousumi Majumder et al.

SENSORS AND ACTUATORS A-PHYSICAL (2008)

Article Materials Science, Multidisciplinary

Electrical conductivity of the Carbon fiber conductive concrete

Hou Zuofu et al.

JOURNAL OF WUHAN UNIVERSITY OF TECHNOLOGY-MATERIALS SCIENCE EDITION (2007)

Article Materials Science, Multidisciplinary

Corrosion of steel reinforcement in structural concrete with carbon material addition

P. Garces et al.

CORROSION SCIENCE (2007)

Article Engineering, Civil

Carbon-fiber-reinforced cement-based sensors

Rose Mary Chacko et al.

CANADIAN JOURNAL OF CIVIL ENGINEERING (2007)

Article Construction & Building Technology

Electrical conductivity of self-monitoring CFRC

M Chiarello et al.

CEMENT & CONCRETE COMPOSITES (2005)

Article Construction & Building Technology

Conductivity of carbon fiber reinforced cement-based composites

B Chen et al.

CEMENT & CONCRETE COMPOSITES (2004)

Article Computer Science, Interdisciplinary Applications

Data division for developing neural networks applied to geotechnical engineering

MA Shabin et al.

JOURNAL OF COMPUTING IN CIVIL ENGINEERING (2004)

Article Materials Science, Multidisciplinary

Piezoresistive cement-based materials for strain sensing

DDL Chung

JOURNAL OF INTELLIGENT MATERIAL SYSTEMS AND STRUCTURES (2002)