4.5 Article

Hydrothermal Carbonization of the Wet Fraction from Mixed Municipal Solid Waste: A Fuel and Structural Analysis of Hydrochars

Journal

ENERGIES
Volume 15, Issue 18, Pages -

Publisher

MDPI
DOI: 10.3390/en15186708

Keywords

hydrothermal carbonization; municipal solid waste; TGA; FTIR; SEM-EDS

Categories

Funding

  1. Ministry of Science and Higher Education [AGH UST] [16.16.110.663]

Ask authors/readers for more resources

The study shows that hydrothermal carbonization has a positive effect on the properties of under-sieve fraction of municipal mixed waste, improving its fuel properties. By altering process parameters, the fuel properties of hydrochars can be enhanced, making them more suitable for energy production.
One of the by-products of a mechanical-biological waste treatment plant is the under-sieve fraction, which requires separation prior to further processing of municipal mixed waste. This stream usually follows the fate of landfilling. Instead, it could be introduced to the hydrothermal carbonization (HTC) process to improve its fuel properties and become solid recovered fuel. The organic fraction and high moisture content (approximately 26%) of under-sieve fraction are favorable properties for the HTC process. In this study, hydrochars, the solid product of HTC, were produced at 200 and 220 degrees C with residence times of 1, 4, and 8 h. The main aim of this investigation was to establish the influence of different process parameters on hydrochars' fuel properties. Thermogravimetric analysis (TGA), Fourier-transform infrared spectroscopy (FTIR), and scanning electron microscopy (SEM) were employed in the analyses. The results confirmed the positive effects of hydrothermal carbonization on the under-sieve fraction of municipal mixed waste properties. The ignition temperature increased from 247 degrees C to 288 degrees C and burnout temperature decreased to 443 degrees C from 489 degrees C after hydrothermal carbonization, causing a shorter combustion process. The determined key combustion parameters were: S = 12.4 x 10(-8)%center dot min(-2)center dot degrees C-3, H-f = 1174.9 degrees C and Di = 0.0075%center dot min(-3), which in comparison to USF decreased by 44%, increased by 33%, and decreased by 29%, respectively, and became closer to those of coal. Furthermore, the identified structural changes indicate that hydrochars could be successfully used in energy production. The most promising results were found for hydrochar produced at 220 degrees C for 1 h, leading to a better combustion performance and providing a more stable and a less violent flame.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.5
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available