Related references
Note: Only part of the references are listed.The formation mechanism of {11(2)over-bar1}<(11)over-bar26>, primary paired {10(1)over-bar2} <(1)over-bar011> and secondary twins in Zircaloy-4 alloy with coarse α lamellae
Yingdong Zhang et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2021)
Investigation on micromechanism of ferrite hardening after pre-straining with different strain rates of dual-phase steel
Yongnan Chen et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2021)
Effect of Si element on improving the oxidation resistance of hybrid (Ti5Si3 + TiC) particles reinforced Ti6Al4V matrix composites
Xiaoyu Huang et al.
CORROSION SCIENCE (2021)
Enhanced corrosion resistance of the surface modified Ti-13Nb-13Zr alloy by ultrasonic shot peening
Pramod Kumar et al.
CORROSION SCIENCE (2021)
Three-dimensional microstructure and texture evolution of Ti35 alloy applied in nuclear industry during plastic deformation at various temperatures
Jianping Xu et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2021)
Microstructure and corrosion behavior of as-extruded Mg-xLi-3Al-2Zn-0.2Zr alloys (x=5, 8, 11 wt.%)
Yuehua Sun et al.
CORROSION SCIENCE (2020)
Role of nano second laser wavelength embedded recast layer and residual stress on electrochemical corrosion of titanium alloy
G. Ranjith Kumar et al.
MATERIALS RESEARCH EXPRESS (2019)
Correlation of ferrite and martensite micromechanical behavior with mechanical properties of ultrafine grained dual phase steels
Amir Hossein Jahanara et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2019)
Negative capacitance or inductive loop? - A general assessment of a common low frequency impedance feature
Dino Klotz
ELECTROCHEMISTRY COMMUNICATIONS (2019)
Effect of residual stress relaxation by means of local rapid induction heating on stress corrosion cracking behavior and electrochemical characterization of welded Ti-6Al-4V alloy under slow strain rate test
Yan Liu et al.
METALS AND MATERIALS INTERNATIONAL (2017)
Comparison of the corrosion behavior of pure titanium and its alloys in fluoride-containing sulfuric acid
Z. B. Wang et al.
CORROSION SCIENCE (2016)
Effect of machining-induced surface residual stress on initiation of stress corrosion cracking in 316 austenitic stainless steel
Wenqian Zhang et al.
CORROSION SCIENCE (2016)
Effect of surface nanostructuring on corrosion behavior of Ti-6Al-4V alloy
Sanjeev Kumar et al.
MATERIALS CHARACTERIZATION (2016)
The effect of residual stress on the electrochemical corrosion behavior of Fe-based amorphous coatings in chloride-containing solutions
Y. Wang et al.
SURFACE & COATINGS TECHNOLOGY (2016)
Effect of acidic fluoride solution on the corrosion resistance of ZrTi alloys for dental implant application
D. Mareci et al.
CORROSION SCIENCE (2014)
Structure of the oxide film on Ti-6Ta alloy after immersion test in 8 mol/L boiling nitric acid medium
Dizi Guo et al.
JOURNAL OF ELECTRON SPECTROSCOPY AND RELATED PHENOMENA (2013)
Influence of residual stress, surface roughness and crystallographic texture induced by machining on the corrosion behaviour of copper in salt-fog atmosphere
J. Gravier et al.
CORROSION SCIENCE (2012)
Effects of strain on the corrosion behaviour of X80 steel
Yongxing Wang et al.
CORROSION SCIENCE (2011)
Influence of surface roughness on the corrosion behaviour of magnesium alloy
R. Walter et al.
MATERIALS & DESIGN (2011)
Effect of surface roughness on leakage current and corrosion resistance of oxide layer on AZ91 Mg alloy prepared by plasma electrolytic oxidation
Bongyoung Yoo et al.
APPLIED SURFACE SCIENCE (2010)
Orientation gradients and geometrically necessary dislocations in ultrafine grained dual-phase steels studied by 2D and 3D EBSD
Marion Calcagnotto et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2010)
Influence of stress-strain field on the dissolution process of polycrystalline nickel in H2SO4 solution:: An original in situ method
D. Large et al.
ELECTROCHIMICA ACTA (2007)
The effects of dislocation patterns on the dissolution process of polycrystalline nickel
M. Sahal et al.
ACTA MATERIALIA (2006)
Effects of compressive stress on corrosion-protective quality and its maintenance under a corrosive environment for TiN films deposited by reactive HCD ion plating
K Miura et al.
MATERIALS TRANSACTIONS (2004)
Consequences of plastic strain on the dissolution process of polycrystalline nickel in H2SO4 solution
M Sahal et al.
SCRIPTA MATERIALIA (2004)
The development of grain-orientation-dependent-residual stressess in a cyclically deformed alloy
YD Wang et al.
NATURE MATERIALS (2003)
Intergranular and interphase microstresses
D Dye et al.
CURRENT OPINION IN SOLID STATE & MATERIALS SCIENCE (2001)