Related references
Note: Only part of the references are listed.Stability and load-displacement behaviour of axially cyclic loaded displacement piles in sands
Siya Rimoy et al.
CANADIAN GEOTECHNICAL JOURNAL (2022)
Multiscale modelling and analysis of footing resting on an anisotropic sand
N. Guo et al.
GEOTECHNIQUE (2022)
MPM Modeling of Cone Penetrometer Testing for Multiple Thin-Layer Effects in Complex Soil Stratigraphy
Kaleigh M. Yost et al.
JOURNAL OF GEOTECHNICAL AND GEOENVIRONMENTAL ENGINEERING (2022)
A coupled SPFEM/DEM approach for multiscale modeling of large-deformation geomechanical problems
Ning Guo et al.
INTERNATIONAL JOURNAL FOR NUMERICAL AND ANALYTICAL METHODS IN GEOMECHANICS (2021)
Investigation of the Material Point Method in the simulation of Cone Penetration Tests in dry sand
Mario Martinelli et al.
COMPUTERS AND GEOTECHNICS (2021)
Large-deformation geomechanical problems studied by a shear-transformation-zone model using the material point method
W. L. Li et al.
COMPUTERS AND GEOTECHNICS (2021)
Geotechnics, energy and climate change: the 56th Rankine Lecture
Richard J. Jardine
GEOTECHNIQUE (2020)
PISA design model for monopiles for offshore wind turbines: application to a stiff glacial clay till
Byron W. Byrne et al.
GEOTECHNIQUE (2020)
Large Deformation Finite-Element Simulation of Displacement-Pile Installation Experiments in Sand
Z. X. Yang et al.
JOURNAL OF GEOTECHNICAL AND GEOENVIRONMENTAL ENGINEERING (2020)
ILS-MPM: An implicit level-set-based material point method for frictional particulate contact mechanics of deformable particles
Chuanqi Liu et al.
COMPUTER METHODS IN APPLIED MECHANICS AND ENGINEERING (2020)
Numerical simulation of a free fall penetrometer deployment using the material point method
Luis Zambrano-Cruzatty et al.
SOILS AND FOUNDATIONS (2020)
Generalized Interpolation Material Point Method modelling of large deformation problems including strain-rate effects - Application to penetration and progressive failure problems
Quoc-Anh Tran et al.
COMPUTERS AND GEOTECHNICS (2019)
Development of an explicit smoothed particle finite element method for geotechnical applications
Wei-Hai Yuan et al.
COMPUTERS AND GEOTECHNICS (2019)
Multiscale modeling of large deformation in geomechanics
Weijian Liang et al.
INTERNATIONAL JOURNAL FOR NUMERICAL AND ANALYTICAL METHODS IN GEOMECHANICS (2019)
DEM analysis of the sand plug behavior during the installation process of open-ended pile
Lichen Li et al.
COMPUTERS AND GEOTECHNICS (2019)
Generalized contact and improved frictional heating in the material point method
J. A. Nairn et al.
COMPUTATIONAL PARTICLE MECHANICS (2018)
Numerical simulation of installation of jacked piles in sand using material point method
R. Lorenzo et al.
CANADIAN GEOTECHNICAL JOURNAL (2018)
Effects of particle breakage and stress reversal on the behaviour of sand around displacement piles
F. N. Altuhafi et al.
GEOTECHNIQUE (2018)
Effect of Surface Roughness on the Shaft Resistance of Displacement Model Piles in Sand
Ruben D. Tovar-Valencia et al.
JOURNAL OF GEOTECHNICAL AND GEOENVIRONMENTAL ENGINEERING (2018)
Modeling nanoindentation using the Material Point Method
Chad C. Hammerquist et al.
JOURNAL OF MATERIALS RESEARCH (2018)
Smoothed Particle Finite-Element Method for Large-Deformation Problems in Geomechanics
Wei Zhang et al.
INTERNATIONAL JOURNAL OF GEOMECHANICS (2018)
Continuum modeling of projectile impact and penetration in dry granular media
Sachith Dunatunga et al.
JOURNAL OF THE MECHANICS AND PHYSICS OF SOLIDS (2017)
Adhesive contact algorithm for MPM and its application to the simulation of cone penetration in clay
Francesca Ceccato et al.
PROCEEDINGS OF THE 1ST INTERNATIONAL CONFERENCE ON THE MATERIAL POINT METHOD (MPM 2017) (2017)
Numerical simulation of undrained insertion problems in geotechnical engineering with the Particle Finite Element Method (PFEM)
Lluis Monforte et al.
COMPUTERS AND GEOTECHNICS (2017)
Multiscale insights into classical geomechanics problems
Ning Guo et al.
INTERNATIONAL JOURNAL FOR NUMERICAL AND ANALYTICAL METHODS IN GEOMECHANICS (2016)
Numerical investigation of pile installation effects in sand using material point method
N. T. V. Phuong et al.
COMPUTERS AND GEOTECHNICS (2016)
Formulation of the axisymmetric CPDI with application to pile driving in sand
Fursan Hamad
COMPUTERS AND GEOTECHNICS (2016)
Trends in large-deformation analysis of landslide mass movements with particular emphasis on the material point method
K. Soga et al.
GEOTECHNIQUE (2016)
Analysis of Piezocone Penetration under Different Drainage Conditions with the Two-Phase Material Point Method
Francesca Ceccato et al.
JOURNAL OF GEOTECHNICAL AND GEOENVIRONMENTAL ENGINEERING (2016)
Discussion of Field investigation of the axial resistance of helical piles in dense sand
Zorany S. Z. Mosquera et al.
CANADIAN GEOTECHNICAL JOURNAL (2015)
Coupling of soil deformation and pore fluid flow using material point method
Samila Bandara et al.
COMPUTERS AND GEOTECHNICS (2015)
Large deformation finite element analyses in geotechnical engineering
Dong Wang et al.
COMPUTERS AND GEOTECHNICS (2015)
Numerical simulation of orthogonal cutting using the material point method
John A. Nairn
ENGINEERING FRACTURE MECHANICS (2015)
Field and model investigations into the influence of age on axial capacity of displacement piles in silica sands
S. Rimoy et al.
GEOTECHNIQUE (2015)
Continuum modelling and simulation of granular flows through their many phases
Sachith Dunatunga et al.
JOURNAL OF FLUID MECHANICS (2015)
Axisymmetric form of the generalized interpolation material point method
John A. Nairn et al.
INTERNATIONAL JOURNAL FOR NUMERICAL METHODS IN ENGINEERING (2015)
Experimental study of cone penetration in silica sand using digital image correlation
M. I. Arshad et al.
GEOTECHNIQUE (2014)
A new contact algorithm in the material point method for geotechnical simulations
J. Ma et al.
INTERNATIONAL JOURNAL FOR NUMERICAL AND ANALYTICAL METHODS IN GEOMECHANICS (2014)
Theoretical breakage mechanics and experimental assessment of stresses surrounding piles penetrating into dense silica sand
C. Zhang et al.
GEOTECHNIQUE LETTERS (2014)
Advanced laboratory testing in research and practice: the 2nd Bishop Lecture
Richard James Jardine
GEOTECHNICAL RESEARCH (2014)
A material point method for snow simulation
Alexey Stomakhin et al.
ACM TRANSACTIONS ON GRAPHICS (2013)
Interpretation of stress measurements made around closed-ended displacement piles in sand
R. J. Jardine et al.
GEOTECHNIQUE (2013)
Measurement of stresses around closed-ended displacement piles in sand
R. J. Jardine et al.
GEOTECHNIQUE (2013)
A convected particle domain interpolation technique to extend applicability of the material point method for problems involving massive deformations
A. Sadeghirad et al.
INTERNATIONAL JOURNAL FOR NUMERICAL METHODS IN ENGINEERING (2011)
Material point method enhanced by modified gradient of shape function
Duan Z. Zhang et al.
JOURNAL OF COMPUTATIONAL PHYSICS (2011)
Sand grain crushing and interface shearing during displacement pile installation in sand
Z. X. Yang et al.
GEOTECHNIQUE (2010)
Material point method for dynamic analysis of saturated porous media under external contact/impact of solid bodies
H. W. Zhang et al.
COMPUTER METHODS IN APPLIED MECHANICS AND ENGINEERING (2009)
Analysis and reduction of quadrature errors in the material point method (MPM)
Michael Steffen et al.
INTERNATIONAL JOURNAL FOR NUMERICAL METHODS IN ENGINEERING (2008)
An evaluation of explicit time integration schemes for use with the generalized interpolation material point method
P. C. Wallstedt et al.
JOURNAL OF COMPUTATIONAL PHYSICS (2008)
Some observations of the effects of time on the capacity of piles driven in sand
R. J. Jardine et al.
GEOTECHNIQUE (2006)
DEM analysis of crushing around driven piles in granular materials
S Lobo-Guerrero et al.
GEOTECHNIQUE (2005)
Engineering properties of grouted sands
C Dano et al.
JOURNAL OF GEOTECHNICAL AND GEOENVIRONMENTAL ENGINEERING (2004)
The particle finite element method:: a powerful tool to solve incompressible flows with free-surfaces and breaking waves
SR Idelsohn et al.
INTERNATIONAL JOURNAL FOR NUMERICAL METHODS IN ENGINEERING (2004)
Determination of bearing capacity of open-ended piles in sand
K Paik et al.
JOURNAL OF GEOTECHNICAL AND GEOENVIRONMENTAL ENGINEERING (2003)
Energy conservation error in the material point method for solid mechanics
SG Bardenhagen
JOURNAL OF COMPUTATIONAL PHYSICS (2002)
The material-point method for granular materials
SG Bardenhagen et al.
COMPUTER METHODS IN APPLIED MECHANICS AND ENGINEERING (2000)
Share Paper
