4.7 Article

Anticorrosion properties of silica-based sol-gel coatings on steel - The influence of hydrolysis and condensation conditions

Related references

Note: Only part of the references are listed.
Article Chemistry, Physical

Shell-thickness control of hollow SiO2 nanoparticles through post-treatment using sol-gel technique toward efficient water confinement

Naoki Tarutani et al.

Summary: The study focused on the confinement of water in hollow SiO2 nanoparticles, with water introduced into the hollow spaces passing through the mesopores of the shells and then confined by thickening the shell. It was found that the amount of water retained increased with shell thickness, and the resulting water-HSNP nanocomposites exhibited effective far-infrared absorption capabilities. The easy confinement approach reported in this study may lead to highly functional complex nanocomposites.

COLLOIDS AND SURFACES A-PHYSICOCHEMICAL AND ENGINEERING ASPECTS (2021)

Article Chemistry, Physical

In-situ EIS study on the initial corrosion evolution behavior of SAC305 solder alloy covered with NaCl solution

Chuang Qiao et al.

Summary: This study reveals the initial corrosion evolution behavior of SAC305 solder joints, including four stages in the corrosion process. The acidified NaCl electrolyte can slightly dissolve the formed SnO2 and facilitate the formation of SnCl4 center dot 4H(2)O crystals.

JOURNAL OF ALLOYS AND COMPOUNDS (2021)

Article Engineering, Chemical

Solvent effects on diffusion channel construction of organosilica membrane with excellent CO2 separation properties

Jing-Yi Li et al.

Summary: BTESE-derived organosilica membranes were prepared using sol-gel method with tailored network through different solvents and membrane thickness, showing high ideal selectivity for gas separation due to controlled mechanism by molecular sieving and selective surface diffusion.

JOURNAL OF MEMBRANE SCIENCE (2021)

Article Materials Science, Multidisciplinary

Influence of fluoroalkyl chains on structural, morphological, and optical properties of silica-based coatings on flexible substrate

Kamila Startek et al.

Summary: This study investigated the influence of fluoroalkyl precursors on the structural and optical properties of coatings deposited on polyethylene terephthalate foil during the sol-gel synthesis of silica-based materials. It was found that the coatings had smooth surfaces, high transparency, low refractive indices, and improved hydrophobic character, showing great potential for flexible photonic structures.

OPTICAL MATERIALS (2021)

Article Materials Science, Coatings & Films

Hybrid sol-gel coatings applied on anodized AA2024-T3 for active corrosion protection

R. del Olmo et al.

Summary: The study evaluated the synergistic effect of anodic film and hybrid sol-gel coating with corrosion inhibitors on enhancing barrier and active corrosion protection of aluminium alloy 2024-T3. The addition of Li- and Ce-based salts into the hybrid sol-gel formulation has shown to provide active corrosion protection. Ce-doped sol-gel coating exhibited less visual corrosion and higher active corrosion protection compared to the Li-containing one during the long-term immersion test in a 0.5 mol.L-1 NaCl solution.

SURFACE & COATINGS TECHNOLOGY (2021)

Article Materials Science, Coatings & Films

Improvement of wear and corrosion protection of PEO on AA2024 via sol-gel sealing

Luciane Sopchenski et al.

Summary: In this study, a hybrid sol-gel was successfully used to seal the porosity of PEO coatings, improving corrosion resistance and reducing wear rate. The sol-gel filling effectively changed the wettability of the coatings, showing promising results in enhancing the protective properties of light metals.

SURFACE & COATINGS TECHNOLOGY (2021)

Article Chemistry, Physical

Influence of the Nb and V Addition on the Microstructure and Corrosion Resistance of the Fe-B-Co-Si Alloy

Rafal Mech et al.

Summary: The paper compares the corrosion resistance of three newly developed Fe-B-Co-Si-based alloys with the addition of Nb and V, finding that each alloying addition increases the corrosion resistance. The choice of additions significantly influences the final performance of the alloy, allowing for tailored materials for specific applications.

MATERIALS (2021)

Article Chemistry, Physical

Sol-gel based hybrid silane coatings for enhanced corrosion protection of copper in aqueous sodium chloride

Jaganathan Balaji et al.

JOURNAL OF MOLECULAR LIQUIDS (2020)

Article Materials Science, Ceramics

Characterization and corrosion protection of nano-titanium dioxide doped BTSE-GPTMS sol-gel coating on cast Al-Si alloy

Xuelin Huang et al.

JOURNAL OF SOL-GEL SCIENCE AND TECHNOLOGY (2020)

Article Materials Science, Multidisciplinary

The microstructure and magnetic properties of yttrium iron garnet film prepared using water-alcohol solvents

N. B. Ibrahim et al.

JOURNAL OF MAGNETISM AND MAGNETIC MATERIALS (2020)

Article Materials Science, Multidisciplinary

Comparison on the TiO2 crystalline phases deposited via dip and spin coating using green sol-gel route

Nur Dalilah Johari et al.

JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T (2019)

Article Materials Science, Multidisciplinary

Self-healing ceria-modified coating for corrosion protection of AZ31 magnesium alloy

Lenia M. Calado et al.

CORROSION SCIENCE (2018)

Article Chemistry, Physical

Structure and properties of epoxy-siloxane-silica nanocomposite coatings for corrosion protection

Ruben F. A. O. Torrico et al.

JOURNAL OF COLLOID AND INTERFACE SCIENCE (2018)

Article Materials Science, Coatings & Films

Corrosion resistance and bioactivity of SiO2-Y2O3 coatings deposited on 316L steel

Anna Mazur et al.

SURFACE & COATINGS TECHNOLOGY (2018)

Article Materials Science, Coatings & Films

Anticorrosive ZrO2 and ZrO2-SiO2 layers on titanium substrates for biomedical applications

E. Dlugon et al.

SURFACE & COATINGS TECHNOLOGY (2017)

Article Nanoscience & Nanotechnology

Adhesion and Long-Term Barrier Restoration of Intrinsic Self-Healing Hybrid Sol-Gel Coatings

Mina Abdolah Zadeh et al.

ACS APPLIED MATERIALS & INTERFACES (2016)

Article Metallurgy & Metallurgical Engineering

Evaluation of self-healing ability of Ce-V conversion coating on AZ31 magnesium alloy

Xiao Jiang et al.

JOURNAL OF MAGNESIUM AND ALLOYS (2016)

Article Chemistry, Multidisciplinary

Graphene based anticorrosive coatings for Cr(VI) replacement

Karanveer. S. Aneja et al.

NANOSCALE (2015)

Article Materials Science, Coatings & Films

Influence of sol-gel process parameters on the protection properties of sol-gel coatings applied on AA2024

K. A. Yasakau et al.

SURFACE & COATINGS TECHNOLOGY (2014)

Article Chemistry, Multidisciplinary

The effect of solvents and the thickness on structural, optical and electrical properties of ITO thin films prepared by a sol-gel spin-coating process

Mohsen Moradi-Haji Jafan et al.

JOURNAL OF NANOSTRUCTURE IN CHEMISTRY (2014)

Article Chemistry, Physical

The development and characterisation of novel hybrid sol-gel-derived films for optical pH sensing

Dorota Wencel et al.

JOURNAL OF MATERIALS CHEMISTRY (2012)

Proceedings Paper Materials Science, Multidisciplinary

Characterization of Titanium Dioxide Nanopowder Synthesized by Sol Gel Grinding Method

N. N. Hafizah et al.

ADVANCED MATERIALS ENGINEERING AND TECHNOLOGY (2012)

Article Spectroscopy

DFT study of molecular structure and vibrations of 3-glycidoxypropyltrimethoxysilane

Iva Movre Sapic et al.

SPECTROCHIMICA ACTA PART A-MOLECULAR AND BIOMOLECULAR SPECTROSCOPY (2009)

Article Optics

Influence of solvent on the physical and lasing properties of dye-doped sol-gel host

Md. Naziruddin Khan et al.

JOURNAL OF LUMINESCENCE (2008)

Article Materials Science, Ceramics

Spectroscopic characterization of GPTMS/DETA and GPTMS/EDA hybrid polymers

Marija R. Gizdavic-Nikolaidis et al.

JOURNAL OF NON-CRYSTALLINE SOLIDS (2007)

Article Spectroscopy

Conformational stability and vibrations of aminopropylsilanol molecule

Lahorija Bistricic et al.

SPECTROCHIMICA ACTA PART A-MOLECULAR AND BIOMOLECULAR SPECTROSCOPY (2006)

Review Chemistry, Physical

Sol-gel coatings for corrosion protection of metals

ML Zheludkevich et al.

JOURNAL OF MATERIALS CHEMISTRY (2005)

Article Materials Science, Ceramics

Formation of silica/epoxy hybrid network polymers

SR Davis et al.

JOURNAL OF NON-CRYSTALLINE SOLIDS (2003)

Review Materials Science, Multidisciplinary

The effect of friction on scratch adhesion testing: application to a sol-gel coating on polypropylene

MH Blees et al.

THIN SOLID FILMS (2000)