4.7 Article

Type-II band alignment in CNT-modified SrTiO3-Fe2TiO5 heterostructure nanocomposite for photocatalytic degradation of organic dyes

Journal

APPLIED SURFACE SCIENCE
Volume 598, Issue -, Pages -

Publisher

ELSEVIER
DOI: 10.1016/j.apsusc.2022.153816

Keywords

Type-II heterostructure; Photocatalyst; SrTiO3; Fe2TiO5; CNT; Response surface methodology

Funding

  1. University of Tehran
  2. Iran Nanotechnology Initiative Council

Ask authors/readers for more resources

In this study, a carbon nanotube-modified SrTiO3/Fe2TiO5 nanocomposite was synthesized using a co-precipitation method, and its photocatalytic performance was evaluated. The results showed that the composite had smaller particle size, lower band gap energy, and larger surface area, and effectively formed a charge transfer mechanism. Additionally, compared to pure SrTiO3 and binary SrTiO3/Fe2TiO5 nanocomposite, the ternary SrTiO3/Fe2TiO5/CNT nanocomposite exhibited higher charge transfer efficiency and excellent photocatalytic activity.
Carbon nanotube (CNT)-modified SrTiO3/Fe2TiO5 nanocomposite was synthesized as a novel heterojunction photocatalyst by a co-precipitation method. The composition of SrTiO3 with Fe2TiO5 and incorporation of CNT in the composite decreased the mean particle size from 70 to 45 nm, reduced the band gap energy from 3.2 to 2.82 eV, and increased the surface area about 3 times greater than the pure SrTiO3. The valence band X-ray photoelectron spectroscopy (VB-XPS) and UV-visible diffuse reflectance spectroscopy (DRS) results demonstrate that SrTiO3 and Fe2TiO5 phases effectively formed a charge transfer mechanism of type-II heterostructure. The lower intensity of photoluminescence (PL) spectroscopy peak, augmented photocurrent density, and less resistance of charge transfer indicated that the ternary SrTiO3/Fe2TiO5/CNT nanocomposite has a more significant charge transfer efficiency in comparison with pure SrTiO3 phase and binary SrTiO3/Fe2TiO5 nanocomposite. The prepared composite exhibited excellent photocatalytic activity and degraded the methylene blue dye completely. Using response surface methodology (RSM) method for experimental design, the optimum amounts of irradiation time, initial dye concentration and catalyst dosage of 71 min, 13.2 mg/L and 1.32 g/L were obtained, respectively. After four cycles, the photocatalyst showed high reusability and stability. The synthesized nanocomposite exhibited lower degradation efficiencies for Rhodamine-B and methyl orange dyes.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.7
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available