Humidity-Tolerant Room-Temperature Selective Dual Sensing and Discrimination of NH3 and NO Using a WS2/MWCNT Composite

Continuous detection of toxic and hazardous gases like nitric oxide (NO) and ammonia (NH3) is needed for environmental management and noninvasive diagnosis of various diseases. However, to the best of our knowledge, dual detection of these two gases has not been previously reported. To address the challenge, we demonstrate the design and fabrication of low-cost NH3 and NO dual gas sensors using tungsten disulfide/multiwall carbon nanotube (WS2/MWCNT) nanocomposites as sensing channels which maintained their performance in a humid environment. The composite-based device has shown successful dual detection at temperatures down to 18 & DEG;C and relative humidity of 90%. For 0.1 ppm ammonia, it exhibited a p-type conduction with response and recovery times of 102 and 261 s, respectively; on the other hand, with NO (10 ppb, n-type), these times were 285 and 198 s, respectively. The device with 5 mg MWCNTs possesses a superior selectivity along with a relative response of & AP;7% (5 ppb) and & AP;5% (0.1 ppm) for NO and NH3, respectively, at 18 & DEG;C. The response is less affected by relative humidity, and this is attributed to the presence of MWCNTs that are hydrophobic in nature. Upon simultaneous exposure to NO (5-10 ppb) and NH3 (0.1-5 ppm), the response was dominated by NO, implying clear discrimination to the simultaneous presence of these two gases. We propose a sensing mechanism based on adsorption/desportion and accompanied charge transfer between the adsorbed gas molecules and sensing surface. The results suggest that an optimized weight ratio of WS2 and MWCNTs could govern favorable sensing conditions for a particular gas molecule.

Automated summary

A low-cost NH3 and NO dual gas sensor has been successfully designed and fabricated, which can maintain good performance in a humid environment. The device has excellent selectivity and response characteristics, allowing dual detection of different gases and having minimal influence from humidity. The results suggest that the weight ratio of WS2 and MWCNTs can affect the sensing conditions.