Journal
JOURNAL OF POLYTECHNIC-POLITEKNIK DERGISI
Volume -, Issue -, Pages -Publisher
GAZI UNIV
DOI: 10.2339/politeknik.1110932
Keywords
Additive manufacturing; PLA; adhesive bonding joint; mechanical strength
Categories
Ask authors/readers for more resources
Plastic materials, especially thermoplastics, are widely used in various industries due to their shaping capabilities. However, the adhesive bonding process faces challenges due to the low surface energy of plastic materials. In this study, PLA sheets were produced using additive manufacturing and joined using different adhesives. The mechanical properties of the joints were examined, and it was found that the strength of the joints is influenced by the adhesive thickness and type.
From the past to the present, plastic materials are used extensively in all areas of the industry, thanks to their shaping capabilities. Especially in the last 10 years, with the proliferation of desktop type 3D printers in the additive manufacturing sector, thermoplastics have become the most widely used plastic material. Therewith, the assembly of materials produced by this method has gained so much importance. Since plastic materials have low surface energy, there are difficulties in performing the adhesive bonding process, which is a popular joining method, and some issues (adhesive type, surface cleaning, etc.) should be carefully considered. In this study; PLA sheets were produced by means of additive manufacturing method and joined with two different adhesives (Loctite 9492 and Terason 9225). For surface preparation, mechanical sanding was performed using 320 and 600 grit size SiC sandpaper. Adhesive bonding joints were created from PLA-PLA material with three different adhesive thicknesses (0.3, 0.18 and 0.1mm). Joints were subjected to tensile test and their mechanical properties were examined. The results showed that high fill ratio in 3D printing increases the strength of parts. In addition, the strength of the adhesively bonded surfaces is affected by the variation of the adhesive thickness and the adhesive type. Whilst an increase in the adhesive thickness increases the strength of Loctite EA 9492 joints; just an opposite effect in Teroson PU 9225 joints was observed.
Authors
I am an author on this paper
Click your name to claim this paper and add it to your profile.
Reviews
Recommended
No Data Available