Related references
Note: Only part of the references are listed.FeAl-B composites with nanocrystalline matrix produced by consolidation of mechanically alloyed powders
Marek Krasnowski et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2019)
Nanocrystalline Al5Fe2 intermetallic and Al5Fe2-Al composites manufactured by high-pressure consolidation of milled powders
Marek Krasnowski et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2016)
The Al-Rich Part of the Fe-Al Phase Diagram
Xiaolin Li et al.
JOURNAL OF PHASE EQUILIBRIA AND DIFFUSION (2016)
TiC-Al composites with nanocrystalline matrix produced by consolidation of milled powders
M. Krasnowski et al.
ADVANCED POWDER TECHNOLOGY (2015)
Grain-size dependent mechanical behavior of nanocrystalline metals
Eric N. Hahn et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2015)
Nanocrystalline matrix TiC-Al3Ti and TiC-Al3Ti-Al composites produced by reactive hot-pressing of milled powders
M. Krasnowski et al.
ADVANCED POWDER TECHNOLOGY (2014)
Al3Ni2-Al composites with nanocrystalline intermetallic matrix produced by consolidation of milled powders
Marek Krasnowski et al.
ADVANCED POWDER TECHNOLOGY (2014)
Nanocrystalline matrix Al3Ni2-Al-Al3Ni composites produced by reactive hot-pressing of milled powders
Marek Krasnowski et al.
INTERMETALLICS (2014)
Microstructure and mechanical properties of in-situ Al13Fe4/Al composites prepared by mechanical alloying and spark plasma sintering
Jian Gu et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2012)
SPECIAL ISSUE FEAL 2009-5th Discussion Meeting on the Development of Innovative Iron Aluminium Alloys Preface
P. Kratochvil et al.
INTERMETALLICS (2010)
The melting curve of ten metals up to 12 GPa and 1600 K
Daniel Errandonea
JOURNAL OF APPLIED PHYSICS (2010)
Nanocrystalline and amorphous Al-Fe alloys containing 60-85% of Al synthesised by mechanical alloying and phase transformations induced by heating of milling products
M. Krasnowski et al.
MATERIALS CHEMISTRY AND PHYSICS (2009)
Nanocrystalline FeAl matrix composites reinforced with TiC obtained by hot-pressing consolidation of mechanically alloyed powders
M. Krasnowski et al.
INTERMETALLICS (2007)
Phase transformations during mechanical alloying of Fe-50% Al and subsequent heating of the milling product
M. Krasnowski et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2006)
Plastic deformation and fracture of ultrafine-grained Al-Mg alloys with a bimodal grain size distribution
GJ Fan et al.
ACTA MATERIALIA (2006)
Al-Mg alloy engineered with bimodal grain size for high strength and increased ductility
D Witkin et al.
SCRIPTA MATERIALIA (2003)
Share Paper
