4.7 Article

Study of impact damage on composite laminates induced by strip impactor using DIC and infrared thermography

Related references

Note: Only part of the references are listed.
Article Engineering, Civil

An experimental investigation on the effect of incorporating graphene nanoplatelets on the low-velocity impact behavior of fiber metal laminates

Azadeh Fathi et al.

Summary: This study demonstrates that incorporating 0.2 wt% of graphene nanoplatelets significantly improves the impact resistance of fiber metal laminates, enhancing adhesion between resin/fibers and composite plies, reducing damage area, and increasing penetration threshold. Additionally, reinforcing composite panels considerably enhances impact behavior compared to unmodified composites.

THIN-WALLED STRUCTURES (2021)

Article Engineering, Civil

Influence of oblique low velocity impact on damage behavior of 2D and 3D woven composites: Experimental and numerical methods

Behzad Kazemianfar et al.

Summary: The study aimed to compare the mechanical performance of 3D woven composites and 2D composites under oblique low velocity impact. Experimental and simulation results showed that the mechanical superiority of 3D composites decreases as impact angle increases, with changes in factors such as absorbed energy and damage parameters.

THIN-WALLED STRUCTURES (2021)

Article Engineering, Civil

Numerical study on the dynamic progressive failure due to low-velocity repeated impacts in thin CFRP laminated composite plates

M. Rezasefat et al.

Summary: This paper numerically investigates the mechanical response of Carbon Fibre Reinforced Polymer (CFRP) plates subjected to repeated low-velocity impacts. The numerical models are validated using experimental data obtained from impact tests on CFRP plates, showing that most of the intra-laminar and interlaminar damage is limited to a few initial impacts.

THIN-WALLED STRUCTURES (2021)

Article Engineering, Civil

Low-velocity impact damage research on 2-dimentional UHMWPE/CF hybrid woven laminates under preloading

Yuan Hu et al.

Summary: This paper provides a comprehensive understanding of the influence mechanism of preloading on low-velocity impact resistance of CFRP laminates toughened with UHMWPE fiber. An innovative preloading apparatus was developed to apply two kinds of preloading, and high-resolution imaging techniques were employed to analyze internal damage and failure patterns. The experimental findings and relevant failure mechanisms were explained using SEM analysis.

THIN-WALLED STRUCTURES (2021)

Article Engineering, Multidisciplinary

On the structural parameters of honeycomb-core sandwich panels against low-velocity impact

Guangyong Sun et al.

Summary: This study investigated the low-velocity impact behavior of honeycomb-core sandwich panels through experimental and numerical analysis, identifying two distinct failure modes. Structural parameters such as facesheet thickness, core height, honeycomb cell size, and cell wall thickness were found to significantly influence the impact performance of the sandwich panels. Optimizing the structural design by controlling these parameters can enhance perforation resistance and energy absorption capacity.

COMPOSITES PART B-ENGINEERING (2021)

Article Engineering, Multidisciplinary

Numerical investigation on the repeated low-velocity impact behavior of composite laminates

Junjie Zhou et al.

COMPOSITES PART B-ENGINEERING (2020)

Article Mechanics

Simulation of edge impact and compression after edge impact in CFRP laminates

A. Arteiro et al.

COMPOSITE STRUCTURES (2020)

Article Engineering, Manufacturing

Effect of double impact positions on the low velocity impact behaviors and damage interference mechanism for composite laminates

Binbin Liao et al.

COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING (2020)

Article Engineering, Mechanical

Damage accumulation mechanism of composite laminates subjected to repeated low velocity impacts

Binbin Liao et al.

INTERNATIONAL JOURNAL OF MECHANICAL SCIENCES (2020)

Article Mechanics

Low-velocity impact damage research on CFRPs with Kevlar-fiber toughening

Yuan Hu et al.

COMPOSITE STRUCTURES (2019)

Article Engineering, Multidisciplinary

CFRP barely visible impact damage inspection based on an ultrasound wave distortion indicator

Xiaofei Zhang et al.

COMPOSITES PART B-ENGINEERING (2019)

Article Engineering, Manufacturing

Failure mechanisms and damage evolution of laminated composites under compression after impact (CAI): Experimental and numerical study

X. C. Sun et al.

COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING (2018)

Article Engineering, Manufacturing

Predicting the Compression-After-Impact (CAI) strength of damage-tolerant hybrid unidirectional/woven carbon-fibre reinforced composite laminates

Haibao Liu et al.

COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING (2018)

Review Engineering, Mechanical

Review and benchmark study on the analysis of low-velocity impact on composite laminates

Raffael Bogenfeld et al.

ENGINEERING FAILURE ANALYSIS (2018)

Article Engineering, Mechanical

Barely visible impact damage in scaled composite laminates: Experiments and numerical simulations

X. C. Sun et al.

INTERNATIONAL JOURNAL OF IMPACT ENGINEERING (2017)

Article Materials Science, Characterization & Testing

Impact damaging of composites through online monitoring and non-destructive evaluation with infrared thermography

C. Meola et al.

NDT & E INTERNATIONAL (2017)

Article Materials Science, Composites

The quantification of impact damage distribution in composite laminates by analysis of X-ray computed tomograms

F. Leonard et al.

COMPOSITES SCIENCE AND TECHNOLOGY (2017)

Article Instruments & Instrumentation

Low-velocity impact damage characterization of carbon fiber reinforced polymer (CFRP) using infrared thermography

Yin Li et al.

INFRARED PHYSICS & TECHNOLOGY (2016)

Article Mechanics

Infrared thermography to evaluate thermoplastic composites under bending load

Simone Boccardi et al.

COMPOSITE STRUCTURES (2015)

Article Engineering, Manufacturing

Predicting low velocity impact damage and Compression-After-Impact (CAI) behaviour of composite laminates

Wei Tan et al.

COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING (2015)

Article Materials Science, Composites

Measure of fracture toughness of compressive fiber failure in composite structures using infrared thermography

Teddy Lisle et al.

COMPOSITES SCIENCE AND TECHNOLOGY (2015)

Article Materials Science, Composites

Observations of damage development from compression-after-impact experiments using ex situ micro-focus computed tomography

D. J. Bull et al.

COMPOSITES SCIENCE AND TECHNOLOGY (2014)

Article Engineering, Manufacturing

Damage analysis and fracture toughness evaluation in a thin woven composite laminate under static tension using infrared thermography

T. Lisle et al.

COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING (2013)

Article Materials Science, Composites

Low velocity impact modeling in composite laminates capturing permanent indentation

C. Bouvet et al.

COMPOSITES SCIENCE AND TECHNOLOGY (2012)

Article Materials Science, Composites

A progressive failure model for mesh-size-independent FE analysis of composite laminates subject to low-velocity impact damage

L. Raimondo et al.

COMPOSITES SCIENCE AND TECHNOLOGY (2012)

Article Engineering, Multidisciplinary

Low velocity impact and compression after impact tests on thin carbon/epoxy laminates

Daniele Ghelli et al.

COMPOSITES PART B-ENGINEERING (2011)

Article Materials Science, Composites

Compression-after-impact response of woven fiber-reinforced composites

Hao Yan et al.

COMPOSITES SCIENCE AND TECHNOLOGY (2010)

Article Engineering, Manufacturing

Compression after impact assessment of self-healing CFRP

G. J. Williams et al.

COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING (2009)

Article Materials Science, Composites

Low-velocity impact damage on dispersed stacking sequence laminates. Part I: Experiments

C. S. Lopes et al.

COMPOSITES SCIENCE AND TECHNOLOGY (2009)

Article Materials Science, Composites

Low-velocity impact damage on dispersed stacking sequence laminates. Part II: Numerical simulations

C. S. Lopes et al.

COMPOSITES SCIENCE AND TECHNOLOGY (2009)

Article Mechanics

Low velocity impact modelling in laminate composite panels with discrete interface elements

Christophe Bouvet et al.

INTERNATIONAL JOURNAL OF SOLIDS AND STRUCTURES (2009)

Article Mechanics

Low-velocity impacts on preloaded GFRP specimens with various impactor shapes

T. Mitrevski et al.

COMPOSITE STRUCTURES (2006)

Article Materials Science, Composites

A 3D damage analysis of low-velocity impacts on laminated composites

S Guinard et al.

COMPOSITES SCIENCE AND TECHNOLOGY (2002)