4.7 Article

An investigation of pine needles fluidization, combustion performance, and fly ash behavior in fluidized bed combustor

Related references

Note: Only part of the references are listed.
Article Energy & Fuels

Effect of different additives on ash fusion characteristic and mineral phase transformation of iron-rich Zhundong coal

Yibin Wang et al.

Summary: Fundamental research on the mineral transformation of iron-rich coal is crucial for its extended utilization at elevated temperatures. The study found that the addition of alumina-rich ash or dolomite can increase the deformation temperature of iron-rich coal, while halloysite or SiO2 can decrease the softening and flow temperatures of coal ash. A composite additive can promote the formation of specific compounds to inhibit the melting of coal ash, but a low proportion of Si-rich additive is not recommended.
Article Thermodynamics

Utilization of biodiesel/Al2O3 nanoparticles for combustion behavior enhancement of a diesel engine operated on dual fuel mode

K. A. Sateesh et al.

Summary: The study investigates the impact of nanofluids using Al2O3 nanoparticles on diesel engine performance, showing an improvement in engine efficiency and a reduction in harmful emissions.

JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY (2022)

Article Thermodynamics

Effect of Sr@ZnO nanoparticles and Ricinus communis biodiesel-diesel fuel blends on modified CRDI diesel engine characteristics

Manzoore Elahi M. Soudagar et al.

Summary: The study evaluated the performance and emission characteristics of a modified CRDI diesel engine fueled by RCME20 biodiesel blended with Sr@ZnO nanoparticles. Results indicated that under certain conditions, the engine performance was enhanced and emissions were reduced compared to RCME20 fuel.

ENERGY (2021)

Article Thermodynamics

Experimental investigation on compression ignition engine powered with pentanol and thevetia peruviana methyl ester under reactivity controlled compression ignition mode of operation

P. A. Harari et al.

Summary: The study showed that adding 10% pentanol in the fuel is beneficial for increasing the brake thermal efficiency of diesel and pentanol fuel combination in RCCI mode, while reducing nitrogen oxide and smoke emissions.

CASE STUDIES IN THERMAL ENGINEERING (2021)

Article Engineering, Chemical

Clean combustion and emissions strategy using reactivity controlled compression ignition (RCCI) mode engine powered with CNG-Karanja biodiesel

S. P. Wategave et al.

Summary: This study focuses on optimizing combustion noise and emissions of diesel engines by using CNG as the primary fuel, combined with diesel and biodiesel as pilot fuels. The research indicates that an optimized energy share of CNG in the RCCI mode is crucial for achieving clean combustion and emission strategies.

JOURNAL OF THE TAIWAN INSTITUTE OF CHEMICAL ENGINEERS (2021)

Article Chemistry, Multidisciplinary

Experimental Analysis of Engine Performance and Exhaust Pollutant on a Single-Cylinder Diesel Engine Operated Using Moringa Oleifera Biodiesel

Manzoore Elahi M. Soudagar et al.

Summary: The experiment showed that using MOB10 in the biodiesel production from Moringa oleifera oil can reduce some emissions, but also increase CO and NOx emissions.

APPLIED SCIENCES-BASEL (2021)

Article Engineering, Multidisciplinary

Effect of injection parameters and producer gas derived from redgram stalk on the performance and emission characteristics of a diesel engine

K. M. Akkoli et al.

Summary: By altering the geometry of the injector nozzle, the study investigated the performance and emission characteristics of a dual-fuel engine under different operating conditions, identifying the optimal parameter combinations. The results showed that a 4-hole nozzle is suitable for Diesel-PG operation, while a 6-hole nozzle is ideal for HOME-PG operation, resulting in improved performance and reduced emissions.

ALEXANDRIA ENGINEERING JOURNAL (2021)

Article Agricultural Engineering

The impact of aluminosilicate-based additives upon the sintering and melting behaviour of biomass ash

Lee J. Roberts et al.

BIOMASS & BIOENERGY (2019)

Article Agricultural Engineering

Fuel property changes of switchgrass during one-year of outdoor storage

C. A. Ogden et al.

BIOMASS & BIOENERGY (2019)

Article Green & Sustainable Science & Technology

Estimation of pine needle availability in the Central Himalayan state of Uttarakhand, India for use as energy feedstock

L. D. Kala et al.

RENEWABLE ENERGY (2018)

Article Thermodynamics

Biomass residue characterization for their potential application as biofuels

Mudasir Akbar Shah et al.

JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY (2018)

Article Engineering, Chemical

Fluidization of palm kernel shell, palm oil fronds, and empty fruit bunches in a swirling fluidized bed gasifier

M. Shahbaz et al.

PARTICULATE SCIENCE AND TECHNOLOGY (2017)

Review Green & Sustainable Science & Technology

Applications of fluidized bed reactors in wastewater treatment - A review of the major design and operational parameters

Mustapha Mohammed Bello et al.

JOURNAL OF CLEANER PRODUCTION (2017)

Article Environmental Sciences

Experimental studies on combustion of composite biomass pellets in fluidized bed

Feihong Guo et al.

SCIENCE OF THE TOTAL ENVIRONMENT (2017)

Review Green & Sustainable Science & Technology

Progress of circulating fluidized bed combustion technology in China: a review

Runxia Cai et al.

CLEAN ENERGY (2017)

Article Energy & Fuels

Profit-based conventional resource scheduling with renewable energy penetration

K. Srikanth Reddy et al.

INTERNATIONAL JOURNAL OF SUSTAINABLE ENERGY (2017)

Article Chemistry, Applied

An investigation in 20 kWth oxygen-enriched bubbling fluidized bed combustor using coal and biomass

Rajesh Kumar et al.

FUEL PROCESSING TECHNOLOGY (2016)

Article Thermodynamics

Thermo-economic analysis of a biomass-fired bubbling fluidised bed thermal power plant

Rajeev Kamal Sharma et al.

INTERNATIONAL JOURNAL OF EXERGY (2016)

Article Engineering, Chemical

Ash characteristics during oxy-fuel fluidized bed combustion of a Victorian brown coal

Bithi Roy et al.

POWDER TECHNOLOGY (2016)

Review Green & Sustainable Science & Technology

Current status and experimental investigation of oxy-fired fluidized bed

Ravi Inder Singh et al.

RENEWABLE & SUSTAINABLE ENERGY REVIEWS (2016)

Article Forestry

Fire Management and Carbon Sequestration in Pine Barren Forests

Kenneth L. Clark et al.

JOURNAL OF SUSTAINABLE FORESTRY (2015)

Article Thermodynamics

Investigation of pollutant reduction by simulation of turbulent non-premixed pulverized coal combustion

Behnam Rahmanian et al.

APPLIED THERMAL ENGINEERING (2014)

Review Green & Sustainable Science & Technology

A comprehensive literature review of bio-fuel performance in internal combustion engine and relevant costs involvement

E. Sadeghinezhad et al.

RENEWABLE & SUSTAINABLE ENERGY REVIEWS (2014)

Article Computer Science, Interdisciplinary Applications

Profile of developments in biomass-based bioenergy research: a 20-year perspective

Weishu Liu et al.

SCIENTOMETRICS (2014)

Article Thermodynamics

Thermal characteristics of the combustion process of biomass and sewage sludge

Aneta Magdziarz et al.

JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY (2013)

Article Chemistry, Applied

Influence of alkali metals on the kinetics of the thermal decomposition of biomass

A. Saddawi et al.

FUEL PROCESSING TECHNOLOGY (2012)

Review Thermodynamics

Biomass feeding for thermochemical reactors

Jianjun Dai et al.

PROGRESS IN ENERGY AND COMBUSTION SCIENCE (2012)

Article Energy & Fuels

Physico-chemical characteristics and market potential of sawdust charcoal briquette

Joseph O. Akowuah et al.

INTERNATIONAL JOURNAL OF ENERGY AND ENVIRONMENTAL ENGINEERING (2012)

Article Engineering, Chemical

Bed height and material density effects on fluidized bed hydrodynamics

David Escudero et al.

CHEMICAL ENGINEERING SCIENCE (2011)

Article Energy & Fuels

Comparison of the Combustion Characteristics of Rice Husk, Sawdust, and Groundnut Shells in a Bubbling Fluidized Bed

K. V. N. Srinivasa Rao et al.

ENERGY SOURCES PART A-RECOVERY UTILIZATION AND ENVIRONMENTAL EFFECTS (2011)

Review Green & Sustainable Science & Technology

A review on biomass as a fuel for boilers

R. Saidur et al.

RENEWABLE & SUSTAINABLE ENERGY REVIEWS (2011)

Article Green & Sustainable Science & Technology

The physicochemical properties of different biomass ashes at different ashing temperature

Ruirui Xiao et al.

RENEWABLE ENERGY (2011)

Article Energy & Fuels

Fluidized bed combustion of some woody biomass fuels

J. Han et al.

ENERGY SOURCES PART A-RECOVERY UTILIZATION AND ENVIRONMENTAL EFFECTS (2008)

Article Chemistry, Applied

Catalytic gasification of char from co-pyrolysis of coal and biomass

Wenkui Zhu et al.

FUEL PROCESSING TECHNOLOGY (2008)

Article Energy & Fuels

Energy exploitation of agricultural biomass potential in Turkey

H. Huseyin Ozturk et al.

ENERGY EXPLORATION & EXPLOITATION (2006)

Article Engineering, Chemical

Revisiting the Wen and Yu equations for minimum fluidization velocity prediction

A Delebarre

CHEMICAL ENGINEERING RESEARCH & DESIGN (2004)

Article Energy & Fuels

Characterization of chars from pyrolysis of lignin

RK Sharma et al.