4.7 Article

Poly(terphenyl piperidinium) containing hydrophilic crown ether units in main chains as anion exchange membranes for alkaline fuel cells and water electrolysers

Journal

JOURNAL OF MEMBRANE SCIENCE
Volume 653, Issue -, Pages -

Publisher

ELSEVIER
DOI: 10.1016/j.memsci.2022.120558

Keywords

Dibenzo-18-crown-6; Anion exchange membranes; Ionic conductivity; Alkaline stability; Alkaline devices

Funding

  1. National Natural Science Foundation of China [21835005, 21975002]
  2. Science and Technology Major Projects of Shanxi Province of China [20181102019]
  3. STS Project of Chinese Academy of Sciences [KFJ-STS-QYZD-2021-02-003]
  4. Hundred Talents Program of the Shanxi Province [20210302123095]
  5. Natural Science Foundation of Shanxi Province

Ask authors/readers for more resources

Poly(arylene piperidinium) polymers with hydrophilic crown ether units were synthesized and showed improved hydroxide conductivity and stability, making them promising materials for AEM-based electrochemical devices.
Poly(arylene piperidinium) polymers are recognized as promising anion exchange membrane (AEM) materials for alkaline fuel cell and water electrolysis, due to the aryl-ether free polyaromatic backbones and stable piperidinium cations. Herein, hydrophilic crown ether units have been introduced into poly(terphenyl piperidinium) (PDTP) by readily superacid-catalyzed polycondensation of dibenzo-18-crown-6 (DE), p-terphenyl and N-methyl-4-piperidine followed via quaternization. The obtained PDTP membranes showed much higher hydroxide conductivity than the control poly(terphenyl piperidinium) (PTP) sample without DE units, due to their high water uptake. The highest hydroxide conductivity of 110 mS/cm was reached at 80 degrees C for PDTP-10 (where 10 denoted the molar content of crown ether units) membrane with an ion exchange capacity (IEC) of 2.57 meq./g. The introduction of DE units alleviated the chemical degradation of PDTP membrane in 1 M NaOH at 80 degrees C as compared to the PTP membranes. Furthermore, membrane electrode assemblies based on PDTP-10 membrane shown a peak power density of 621 mW/cm(2) at 60 degrees C in AEM fuel cells and a current density of 2000 mA/cm(2) at 2.1 V for water electrolysers circulated with 1 M NaOH at 80 degrees C. The in-situ stability tests in fuel cells and water electrolysers also manifested that the chemical structure of PDTP-10 membrane remained intact during short-term durability tests under galvanostatic mode. The above results manifested that AEMs containing hydrophilic crown ether units in the polymer mainchain showed potential in the application for AEM based electrochemical devices.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.7
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available