☆ 4.6 Article

Optimized luminescent intensity of Ca2MgWO6:Er3+,Yb3+ up-conversion phosphors by uniform design and response surface methodology

JOURNAL OF LUMINESCENCE (2022)

Related references

Note: Only part of the references are listed.

Article Chemistry, Inorganic & Nuclear

Site Preference-Driven Mn4+ Stabilization in Double Perovskite Phosphor Regulating Quantum Efficiency from Zero to Champion

Yufei Wang et al.

Summary: By proposing a cation-pair co-substitution strategy, a novel Mn4+-activated red phosphor has been successfully designed, which significantly enhances the effective Mn4+/Mn2+ concentration while achieving highly efficient far-red emission.

INORGANIC CHEMISTRY (2022)

Add to Collection

Review Chemistry, Multidisciplinary

Lanthanide-Doped Near-Infrared Nanoparticles for Biophotonics

Hui Li et al.

Summary: Light in the near-infrared (NIR) spectral region is increasingly used in bioapplications due to its deeper penetration in biological tissues. Lanthanide-doped luminescent nanoparticles with excitation and/or emission in the NIR range are gaining attention for noninvasive biological applications, offering unique optical properties such as large Stokes shift, sharp luminescence emissions, long lifetimes, and photostability. Advanced strategies for enhancing the luminescence brightness of these nanoparticles have been introduced, along with a review of their superior biophotonic applications in high-resolution imaging, single-nanoparticle-level detection, and tissue-penetrating diagnostics and therapeutics.

ADVANCED MATERIALS (2021)

Add to Collection

Article Materials Science, Ceramics

Na2YMg2(VO4)3:Er3+,Yb3+ phosphors: Up-conversion and optical thermometry

Ye Tong et al.

Summary: Na2YMg2(VO4)(3):Er3+,Yb3+ phosphors are investigated as optical thermometry, demonstrating efficient up-conversion luminescence and temperature sensing properties, showing promising potential for practical applications.

CERAMICS INTERNATIONAL (2021)

Add to Collection

Article Engineering, Environmental

A three-mode self-referenced optical thermometry based on up-conversion luminescence of Ca2MgWO6:Er3+,Yb3+phosphors

YunCheng Jiang et al.

Summary: A series of Ca2MgWO6:xEr3+, yYb3+ phosphor samples were synthesized through high temperature solid-state reaction method for optical thermometry. These samples showed intense up-conversion luminescence when excited by 980 nm laser, with enhanced emissions by addition of Yb3+ ions. The phosphors demonstrated a dual-mode temperature sensor and superior thermal stability, indicating potential applications for self-referenced optical thermometry.

CHEMICAL ENGINEERING JOURNAL (2021)

Add to Collection

Review Optics

Rational Design of Ratiometric Luminescence Thermometry Based on Thermally Coupled Levels for Bioapplications

Hao Suo et al.

Summary: Noninvasive lanthanide-doped optical thermometers based on fluorescent intensity ratio technique and near-infrared light-responsive nanothermometers show great potential for biomedical applications. These technologies offer new possibilities for temperature measurement in inaccessible areas and deep tissues.

LASER & PHOTONICS REVIEWS (2021)

Add to Collection

Article Engineering, Environmental

High-performance disease diagnosis fluorescent probe based on new type structure YbF3: Er3+@SiO2@GQDs

Zhen Sun et al.

Summary: By integrating YbF3:Er3+ and GQDs, a fluorescent probe is developed to detect temperature and iron ion variances between cancer cells and normal cells, showing potential application prospects in biomedical field for ultra-sensitive measurement and detection.

CHEMICAL ENGINEERING JOURNAL (2021)

Add to Collection

Review Mathematics, Applied

Optimal experimental design for infinite-dimensional Bayesian inverse problems governed by PDEs: a review

Alen Alexanderian

Summary: This review article discusses methods for optimal experimental design for Bayesian inverse problems governed by partial differential equations with infinite-dimensional parameters. The focus is on optimizing measurement point placement to minimize parameter estimation uncertainty, and the mathematical foundations and computational methods for OED problems are presented, along with future research directions.

INVERSE PROBLEMS (2021)

Add to Collection

Article Agricultural Engineering

A comparative study of machine learning methods for bio-oil yield prediction-A genetic algorithm-based features selection

Zahid Ullah et al.

Summary: A novel genetic algorithm-based feature selection approach was used in this study to predict bio-oil yield using four different machine learning methods. The findings suggested that Random Forest model performed the best and was able to reliably predict bio-oil yield. The research provided new insights into the pyrolysis process of biomass and offered a new approach to improve bio-oil yield.

BIORESOURCE TECHNOLOGY (2021)

Add to Collection

Article Optics

Tunable photoemission and energy transfer of heavily Bi3+,Eu3+ co-doped Y4GeO8 phosphors

ZiWei Lu et al.

Summary: Co-doping activators can optimize the visible light emission of Y4GeO8 polycrystalline materials, with a doping concentration of Bi3+ reaching up to 6.25%. Under ultraviolet excitation, Y4GeO8:Bi3+,Eu3+ phosphors exhibit tunable emission, especially the sample Y4GeO8:0.25Bi(3+),0.65Eu(3+) shows excellent red emission performance.

JOURNAL OF LUMINESCENCE (2021)

Add to Collection

Article Automation & Control Systems

Multiobjective Design Optimization of a Double-Sided Flux Switching Permanent Magnet Generator for Counter-Rotating Wind Turbine Applications

Seyed Armin Mirnikjoo et al.

Summary: This article introduces the concept and design optimization procedure of a counter-rotating wind turbine, which utilizes double-sided flux switching permanent magnet generators and high-power electric generators to enhance wind power generation systems. Taguchi optimization is employed for design experiments, and a decision-making algorithm is used to select the best combination of control factors for multiobjective optimization. The performance of the optimized generator will be evaluated through finite element modeling and experimental tests.

IEEE TRANSACTIONS ON INDUSTRIAL ELECTRONICS (2021)

Add to Collection

Article Automation & Control Systems

Multi-objective Optimization Design of Variable-Saliency-Ratio PM Motor Considering Driving Cycles

Xue Zhou et al.

Summary: In this article, a variable-saliency-ratio permanent magnet motor is designed and optimized with a new design concept to enhance output torque, widen speed range, and lower irreversible demagnetization risk. A multiobjective optimization considering driving cycles is proposed to optimize the design objective of saliency ratio using a multiobjective genetic algorithm method. Both simulation and experimental results confirm the effectiveness of the proposed method.

IEEE TRANSACTIONS ON INDUSTRIAL ELECTRONICS (2021)

Add to Collection

Article Engineering, Environmental

Predicting operational capacity of redox flow battery using a generalized empirical correlation derived from dimensional analysis

Manshu Kapoor et al.

CHEMICAL ENGINEERING JOURNAL (2020)

Add to Collection

Article Chemistry, Multidisciplinary

Multi-Objective Optimization of Process Parameters of Longitudinal Axial Threshing Cylinder for Frozen Corn Using RSM and NSGA-II

Jun Fu et al.

APPLIED SCIENCES-BASEL (2020)

Add to Collection

Article Nanoscience & Nanotechnology

Modifying the Crystal Field of CsPbCl3:Mn2+ Nanocrystals by Co-doping to Enhance Its Red Emission by a Hundredfold

Pengjie Song et al.

ACS APPLIED MATERIALS & INTERFACES (2020)

Add to Collection

Article Chemistry, Physical

Highly sensitive optical thermometer based on FIR technique of transparent NaY2F7:Tm3+/Yb3+ glass ceramic

SunYueZi Chen et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2020)

Add to Collection

Article Materials Science, Multidisciplinary

Synthesis, luminescence properties and energy transfer of Ca2MgWO6:Cr3+, Yb3+ phosphors

Dandan Xu et al.

MATERIALS RESEARCH BULLETIN (2019)

Add to Collection

Article Chemistry, Physical

Investigation of photocatalytic malachite green degradation by iridium doped zinc oxide nanoparticles: Application of response surface methodology

N. Babajani et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2019)

Add to Collection

Article Optics

An abnormal yellow emission and temperature-sensitive properties for perovskite-type Ca2MgWO6 phosphor via cation substitution and energy transfer

Min Cui et al.

JOURNAL OF LUMINESCENCE (2019)

Add to Collection

Article Materials Science, Multidisciplinary

Enhanced up-conversion luminescence and optical temperature sensing in graphitic C3N4 quantum dots grafted with BaWO4:Yb3+,Er3+ phosphors

Lifei Xu et al.

JOURNAL OF MATERIALS CHEMISTRY C (2019)

Add to Collection

Review Automation & Control Systems

Uniform experimental design in chemometrics

Qing-Song Xu et al.

JOURNAL OF CHEMOMETRICS (2018)

Add to Collection

Article Optics

Statistical design for the optimization of the red to orange ratio in YBO3:Eu3+ phosphors

Xianwen Zhang et al.

JOURNAL OF LUMINESCENCE (2018)

Add to Collection

Article Chemistry, Multidisciplinary

Enhancing Upconversion from NaYF4:Yb,Er@NaYF4 Core-Shell Nanoparticles Assembled on Metallic Nanostructures

Qi Luo et al.

JOURNAL OF NANOSCIENCE AND NANOTECHNOLOGY (2018)

Add to Collection

Article Physics, Multidisciplinary

Experimental optimum design and luminescence properties of NaY(Gd)(MoO4)2:Er3+ phosphors

Jia-Shi Sun et al.

CHINESE PHYSICS B (2016)

Add to Collection

Article Chemistry, Physical

Broad-Scope Thermometry Based on Dual-Color Modulation up-Conversion Phosphor Ba5Gd8Zn4O21:Er3+/Yb3+

Hao Suo et al.

JOURNAL OF PHYSICAL CHEMISTRY C (2016)

Add to Collection

Article Materials Science, Multidisciplinary

Quadratic general rotary unitized design for doping concentrations and up-conversion luminescence properties of Er3+/Yb3+ co-doped NaLa (MoO4)2 phosphors

Jiashi Sun et al.

MATERIALS RESEARCH BULLETIN (2016)

Add to Collection

Article Materials Science, Ceramics

Optimization method for green SrAl2O4:Eu2+,Dy3+ phosphors synthesized via co-precipitation route assisted by microwave irradiation using orthogonal experimental design

Wenfei Shan et al.

CERAMICS INTERNATIONAL (2015)

Add to Collection

Article Chemistry, Inorganic & Nuclear

Response surface methodology approach for optimization of simultaneous dye and metal ion ultrasound-assisted adsorption onto Mn doped Fe3O4-NPs loaded on AC: kinetic and isothermal studies

Arash Asfaram et al.

DALTON TRANSACTIONS (2015)

Add to Collection

Article Chemistry, Physical

Optimization of synthesis conditions of PbS thin films grown by chemical bath deposition using response surface methodology

Ersin Yucel et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2015)

Add to Collection

Article Optics

A new chemiluminescence method for determination of dicyandiamide based on the N-bromosuccinimide-merbromin-cetyltrimethylammonium bromide system

Hua Yu et al.

JOURNAL OF LUMINESCENCE (2015)

Add to Collection

Review Nanoscience & Nanotechnology

Controlling upconversion nanocrystals for emerging applications

Bo Zhou et al.

NATURE NANOTECHNOLOGY (2015)

Add to Collection

Review Chemistry, Multidisciplinary

Upconversion Nanoparticles: Design, Nanochemistry, and Applications in Theranostics

Guanying Chen et al.

CHEMICAL REVIEWS (2014)

Add to Collection

Article Chemistry, Physical

Application of response surface methodology (RSM) for optimization of the sintering process of preparation calcia partially stabilized zirconia (CaO-PSZ) using natural baddeleyite

Jing Li et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2013)

Add to Collection

Article Chemistry, Applied

Optimization of total polysaccharide extraction from Dioscorea nipponica Makino using response surface methodology and uniform design

Dianhui Luo

CARBOHYDRATE POLYMERS (2012)

Add to Collection

Article Chemistry, Analytical

Role of the host matrix on the thermal sensitivity of Er3+ luminescence in optical temperature sensors

Sergio F. Leon-Luis et al.

SENSORS AND ACTUATORS B-CHEMICAL (2012)

Add to Collection

Article Chemistry, Physical

Optimization of fermentative hydrogen production process using genetic algorithm based on neural network and response surface methodology

Jianlong Wang et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2009)

Add to Collection

Article Chemistry, Physical

Visible upconversion in rare earth ion-doped Gd2O3 nanocrystals

H Guo et al.

JOURNAL OF PHYSICAL CHEMISTRY B (2004)

Add to Collection

© Peeref 2019-2024. All rights reserved.