☆ 4.7 Article

Finite Time Thermodynamic Modeling and Performance Analysis of High-Temperature Proton Exchange Membrane Fuel Cells

INTERNATIONAL JOURNAL OF MOLECULAR SCIENCES (2022)

Related references

Note: Only part of the references are listed.

Article Biochemistry & Molecular Biology

Thermodynamic Modeling and Performance Analysis of Vehicular High-Temperature Proton Exchange Membrane Fuel Cell System

Yanju Li et al.

Summary: A thermodynamic model of a vehicular high temperature proton exchange membrane fuel cell (HT-PEMFC) system using phosphoric acid doped polybenzimidazole membrane is developed, and the effects of stack inlet temperature, pressure, and stoichiometric on system performance are analyzed.

MEMBRANES (2022)

Add to Collection

Article Biochemistry & Molecular Biology

Exergetic Performance Coefficient Analysis and Optimization of a High-Temperature Proton Exchange Membrane Fuel Cell

Dongxu Li et al.

Summary: The study analyzed the performance of a high-temperature proton exchange membrane fuel cell (HT-PEMFC) and the influence of different parameters, finding that EPC represents a better performance criterion and increasing inlet pressure and doping level can improve its efficiency.

MEMBRANES (2022)

Add to Collection

Article Energy & Fuels

Research on air mass flow-pressure combined control and dynamic performance of fuel cell system for vehicles application

Ze Liu et al.

Summary: This paper proposes an air mass flow-pressure combined control strategy for a fuel cell system and successfully applies it to an 80 kW-grade fuel cell system for vehicles. The control effect of the proposed controller is validated and the dynamic response and steady-state performance of the system are investigated. The results show that the proposed control strategy adequately satisfies the operating requirements of the fuel cell system and has good performance output under different operating conditions.

APPLIED ENERGY (2022)

Add to Collection

Editorial Material Physics, Multidisciplinary

Future Perspectives of Finite-Time Thermodynamics

Bjarne Andresen et al.

ENTROPY (2022)

Add to Collection

Article Agronomy

A Novel 10-Parameter Motor Efficiency Model Based on I-SA and Its Comparative Application of Energy Utilization Efficiency in Different Driving Modes for Electric Tractor

Zhun Cheng et al.

Summary: This paper aims to build a more accurate and generalizable motor efficiency model for evaluating and improving the efficiency characteristics of electric vehicles. Based on bench tests of two motors with different rated powers, the paper compares and analyzes three motor efficiency modeling methods, finding that existing methods have limited generalization abilities under full working conditions. Therefore, a new modeling method combining correlation analysis, polynomial regression, and an improved simulated annealing algorithm is proposed. The paper evaluates and verifies the motor efficiency model, and then conducts a comparative analysis of the full vehicle efficiency of electric tractors with different drive systems under five working conditions. The results show that tractors with a dual motor coupling drive system have optimal economic performance.

AGRICULTURE-BASEL (2022)

Add to Collection

Article Green & Sustainable Science & Technology

Comprehensive performance analysis of a high-temperature PEM fuel cell under different operating and design conditions

Mutlucan Bayat et al.

Summary: This paper presents a comprehensive analysis of the performance of a high-temperature PEM fuel cell through a novel model and experimental comparison. Results indicate that increasing the operating temperature has a significant impact on energy and exergy efficiency.

SUSTAINABLE ENERGY TECHNOLOGIES AND ASSESSMENTS (2022)

Add to Collection

Review Engineering, Electrical & Electronic

Review on the Selection of Health Indicator for Lithium Ion Batteries

Wenlu Zhou et al.

Summary: This paper analyzes the current status of health indicator (HI) selection for lithium-ion batteries, discusses the advantages and disadvantages of various HIs, and proposes the direction for future HI selection based on capacity regeneration phenomenon.

MACHINES (2022)

Add to Collection

Review Materials Science, Paper & Wood

Is engineered wood China's way to carbon neutrality?

Christian Sonne et al.

JOURNAL OF BIORESOURCES AND BIOPRODUCTS (2022)

Add to Collection

Article Materials Science, Paper & Wood

Sandwich-like chitosan porous carbon Spheres/MXene composite with high specific capacitance and rate performance for supercapacitors

Lansheng Wei et al.

Summary: This study combines Ti3C2Tx MXene nanosheets with porous carbon microspheres to construct a sandwich-like structure, which exhibits high specific capacitance and good cycling stability in supercapacitors.

JOURNAL OF BIORESOURCES AND BIOPRODUCTS (2022)

Add to Collection

Article Biochemistry & Molecular Biology

Performance Analysis and Optimization of a High-Temperature PEMFC Vehicle Based on Particle Swarm Optimization Algorithm

Yanju Li et al.

Summary: A high-temperature proton exchange membrane fuel cell (HT-PEMFC) model is developed based on finite time thermodynamics, and the particle swarm optimization (PSO) algorithm is used for multi-objective optimization, improving the output performance. Simulation tests show that the FCV with the optimized HT-PEMFC is more efficient and consumes less hydrogen.

MEMBRANES (2021)

Add to Collection

Article Nanoscience & Nanotechnology

Stability of Calcium Ion Battery Electrolytes: Predictions from Ab Initio Molecular Dynamics Simulations

Sharma S. R. K. C. Yamijala et al.

Summary: This work examines the stability of candidate salts and solvents for calcium-ion batteries (CIBs), finding tetraglyme solvent and carborane salt to be promising candidates due to their resistance to decomposition on the calcium surface. By analyzing the microscopic mechanisms of salt/solvent decomposition using simulations, it provides a predictive path toward designing stable electrolytes for CIBs.

ACS APPLIED MATERIALS & INTERFACES (2021)

Add to Collection

Article Thermodynamics

Exergy analysis of a polymer fuel cell and identification of its optimum operating conditions using improved Farmland Fertility Optimization

Xiaohui Lu et al.

Summary: This paper presents an exergy analysis of a power generation system based on high-temperature proton exchange membrane fuel cells, which includes a complex mathematical model and parameter analysis to optimize the system for improved efficiency and performance. The proposed optimization algorithm, Farmland Fertility Optimization (FFO), outperforms other compared algorithms in terms of irreversibility, exergy efficiency, and work.

ENERGY (2021)

Add to Collection

Article Thermodynamics

Performance analysis and exergo-economic optimization of a solar-driven adjustable tri-generation system

Yuzhu Chen et al.

Summary: A novel adjustable CCHP system was proposed in this study, and its thermal and adjustable performance was analyzed through energy, exergy and heat to electricity ratio. By utilizing a modified exergo-economic method, the thermal allocation ratio among system components was optimized, resulting in higher energy efficiency and heat to electricity ratio. This research presents a new way to effectively utilize solar thermal energy for district energy systems.

ENERGY CONVERSION AND MANAGEMENT (2021)

Add to Collection

Review Engineering, Chemical

Review on the Battery Model and SOC Estimation Method

Wenlu Zhou et al.

Summary: This study categorizes and analyzes battery models and SOC estimation, providing references for future in-depth research. The paper summarizes the principles, applicable scenarios, and research progress of existing estimation algorithms, pointing out directions for improvement.

PROCESSES (2021)

Add to Collection

Article Mathematics

Ecological Performance Optimization of a High Temperature Proton Exchange Membrane Fuel Cell

Dongxu Li et al.

Summary: The study establishes an irreversible high temperature proton exchange membrane fuel cell (HT-PEMFC) model and deduces expressions for output power, energy efficiency, exergy efficiency, and ecological coefficient of performance (ECOP). The results show that increasing operating temperature and doping level can improve HT-PEMFC performance, while increasing operating pressure and relative humidity have minimal effect on performance.

MATHEMATICS (2021)

Add to Collection

Article Mathematics

Thermodynamic Optimization of a High Temperature Proton Exchange Membrane Fuel Cell for Fuel Cell Vehicle Applications

Bing Xu et al.

Summary: In this paper, a finite time thermodynamic model of high temperature proton exchange membrane fuel cell (HT-PEMFC) is established, and the influences of operating conditions on the maximum output power density and efficiency are studied to provide guidance for practical applications.

MATHEMATICS (2021)

Add to Collection

Article Materials Science, Paper & Wood

Second generation biorefining in Ecuador: Circular bioeconomy, zero waste technology, environment and sustainable development: The nexus

Lourdes M. Orejuela-Escobar et al.

Summary: The projection of world population growth and concurrent generation of large volumes of agro-industrial waste have raised concerns about environmental impacts. The article discusses the importance of Circular Bioeconomy, Zero Waste Technology, Sustainable Development, and Biorefineries in addressing these issues. It highlights the need for emerging technologies and innovation to promote the use of renewable materials and develop environmentally friendly processes in order to improve industrial competitiveness and trade balance.

JOURNAL OF BIORESOURCES AND BIOPRODUCTS (2021)

Add to Collection

Article Chemistry, Physical

Thermodynamic modeling and exergy analysis of proton exchange membrane fuel cell power system

Guokun Liu et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2020)

Add to Collection

Article Thermodynamics

Performance analyses of a combined system consisting of high-temperature polymer electrolyte membrane fuel cells and thermally regenerative electrochemical cycles

Xinru Guo et al.

ENERGY (2020)

Add to Collection

Article Thermodynamics

Minimum exergy destruction from endoreversible and finite-time thermodynamics machines and their concomitant indirect energy

Michael Tierney

ENERGY (2020)

Add to Collection

Article Green & Sustainable Science & Technology

Energetic, exergetic and ecological analyses of a high-temperature proton exchange membrane fuel cell based on a phosphoric-acid-doped polybenzimidazole membrane

Yanhong Guo et al.

SUSTAINABLE ENERGY TECHNOLOGIES AND ASSESSMENTS (2020)

Add to Collection

Article Thermodynamics

Performance evaluation of an integrated high-temperature proton exchange membrane fuel cell and absorption cycle system for power and heating/cooling cogeneration

Xinru Guo et al.

ENERGY CONVERSION AND MANAGEMENT (2019)

Add to Collection

Article Electrochemistry

Investigation of the Effect of Humidity Level of H2 on Cell Performance of a HT-PEM Fuel Cell

F. Zhou et al.

FUEL CELLS (2019)

Add to Collection

Article Thermodynamics

Finite time thermodynamic analysis of a solar duplex Stirling refrigerator

Dongdong Dai et al.

APPLIED THERMAL ENGINEERING (2019)

Add to Collection

Article Engineering, Chemical

Finite Time Thermodynamic Optimization of an Irreversible Proton Exchange Membrane Fuel Cell for Vehicle Use

Changjie Li et al.

PROCESSES (2019)

Add to Collection

Article Thermodynamics

Multi-objective optimization and decision making of endoreversible combined cycles with consideration of different heat exchangers by finite time thermodynamics

Amir Ghasemkhani et al.

ENERGY CONVERSION AND MANAGEMENT (2018)

Add to Collection

Article Thermodynamics

Exergy Analysis of High-Temperature Proton Exchange Membrane Fuel Cell Systems

Lin Ye et al.

INTERNATIONAL JOURNAL OF GREEN ENERGY (2015)

Add to Collection

Review Green & Sustainable Science & Technology

Finite-time thermodynamics optimization of absorption refrigeration systems: A review

Paiguy Armand Ngouateu Wouagfack et al.

RENEWABLE & SUSTAINABLE ENERGY REVIEWS (2013)

Add to Collection

Article Green & Sustainable Science & Technology

Exergy analysis of two phase change materials storage system for solar thermal power with finite-time thermodynamics

Ya-Qi Li et al.

RENEWABLE ENERGY (2012)

Add to Collection

Article Green & Sustainable Science & Technology

Optimization of solar-powered Stirling heat engine with finite-time thermodynamics

Li Yaqi et al.

RENEWABLE ENERGY (2011)

Add to Collection

Article Green & Sustainable Science & Technology

Analytical modeling of PEM fuel cell i-V curve

Shaker Haji

RENEWABLE ENERGY (2011)

Add to Collection

Article Energy & Fuels

Finite time exergoeconomic performance of an irreversible intercooled regenerative Brayton cogeneration plant

B. Yang et al.

JOURNAL OF THE ENERGY INSTITUTE (2011)

Add to Collection

Article Engineering, Chemical

An isothermal model of a laboratory intermediate temperature fuel cell using PBI doped phosphoric acid membranes

T. Sousa et al.

CHEMICAL ENGINEERING SCIENCE (2010)

Add to Collection

Review Physics, Condensed Matter

Application of density functional theory to CO tolerance in fuel cells: a brief review

Sergey Stolbov et al.

JOURNAL OF PHYSICS-CONDENSED MATTER (2009)

Add to Collection

Article Chemistry, Physical

Exergetic performance coefficient analysis of a simple fuel cell system

Ali Volkan Akkaya et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2007)

Add to Collection

Article Chemistry, Physical

Parameters estimation of a PEM fuel cell polarization curve and analysis of their behavior with temperature

M. G. Santarelli et al.

JOURNAL OF POWER SOURCES (2006)

Add to Collection

Article Thermodynamics

Performance analysis of an irreversible Brayton heat engine based on ecological coefficient of performance criterion

Y Ust et al.

INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2006)

Add to Collection

Article Energy & Fuels

Performance analysis and optimization of an irreversible dual-cycle based on an ecological coefficient of performance criterion

Y Ust et al.

APPLIED ENERGY (2005)

Add to Collection

© Peeref 2019-2024. All rights reserved.