4.6 Article

Role of trace additions of Ca and Sn in improving the corrosion resistance of Mg-3Al-1Zn alloy

Related references

Note: Only part of the references are listed.
Article Materials Science, Multidisciplinary

Role of trace additions of Mn and Y in improving the corrosion resistance of Mg-3Al-1Zn alloy

Soo-Min Baek et al.

Summary: The corrosion resistance of conventional and experimental Mg-3Al-1Zn-based alloys with different Mn and Y content was compared. The experimental Mg-3Al-1Zn-0.05Mn-0.03Y alloy exhibited a corrosion rate of 0.91 mm y(-1), about four times slower than that of a conventional Mg-3Al-1Zn-0.3Mn alloy, highlighting the importance of trace additions of Mn and Y in improving corrosion resistance.

CORROSION SCIENCE (2021)

Review Materials Science, Multidisciplinary

Toward the development of Mg alloys with simultaneously improved strength and ductility by refining grain size via the deformation process

Zhi Zhang et al.

Summary: Grain size significantly influences the strength and ductility of magnesium alloys, and refining grain size is a feasible strategy to prepare high-performance magnesium alloys. Further research and discussion on the effects of grain size on various magnesium alloys are needed to fully understand the key mechanisms.

INTERNATIONAL JOURNAL OF MINERALS METALLURGY AND MATERIALS (2021)

Article Chemistry, Physical

Improvement of mechanical properties of hot extruded and age treated Mg-Zn-Mn-Ca alloy through Sn addition

Xia Chen et al.

Summary: The addition of Sn in Mg-Zn-Mn-Ca alloys was found to significantly increase the mechanical properties, with precipitate strengthening being the main contributor. The strength of the alloy gradually improved with increasing Sn content, showing noticeable effects in both hot extruded and age treated conditions.

JOURNAL OF ALLOYS AND COMPOUNDS (2021)

Article Materials Science, Multidisciplinary

Microstructural evolution, mechanical properties and corrosion behavior of as-cast Mg-5Li-3Al-2Zn alloy with different Sn and Y addition

Xiang Peng et al.

Summary: The influences of Sn and Y on LAZ532 alloy were investigated, showing improved mechanical properties and corrosion resistance. LAZ532-0.8Sn-1.2Y alloy demonstrated the best mechanical properties and corrosion resistance, with the smallest corrosion current density and the lowest anodic dissolution rate.

JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY (2021)

Article Metallurgy & Metallurgical Engineering

Tailoring the microstructural characteristic and improving the corrosion resistance of extruded dilute Mg-0.5Bi-0.5Sn alloy by microalloying with Mn

Yang Liu et al.

Summary: The addition of 0.5 wt% Mn microalloy significantly enhances the corrosion resistance of Mg-0.5Bi-0.5Sn alloy, reducing grain size and dislocation density, while also observing new second phase and grain boundary segregation in certain micro-regions.

JOURNAL OF MAGNESIUM AND ALLOYS (2021)

Article Chemistry, Physical

Effect of microalloyed Ca on the microstructure and corrosion behavior of extruded Mg alloy AZ31

Cheng Zhang et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2020)

Article Materials Science, Multidisciplinary

Effect of LPSO phases and aged-precipitations on corrosion behavior of as-forged Mg-6Gd-2Y-1Zn-0.3Zr alloy

Yujiao Wang et al.

JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T (2020)

Article Chemistry, Physical

Role of second phases on the corrosion resistance of Mg-Nd-Zr alloys

Jianyue Zhang et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2020)

Article Materials Science, Multidisciplinary

Improving the corrosion resistance of MgZn1.2GdxZr0.18 (x=0, 0.8, 1.4, 2.0) alloys via Gd additions

Siqi Yin et al.

CORROSION SCIENCE (2020)

Article Metallurgy & Metallurgical Engineering

Evolution of microstructure, phases and mechanical properties in lean as-cast Mg–Al–Ca–Mn alloys under the influence of a wide range of Ca/Al ratio

S. Sanyal et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2020)

Article Materials Science, Multidisciplinary

Highly deformable Mg-Al-Ca alloy with Al2Ca precipitates

Gaoming Zhu et al.

ACTA MATERIALIA (2020)

Article Chemistry, Physical

Role of Sn in microstructure and corrosion behavior of new wrought Mg-5Al alloy

Polina Metalnikov et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2019)

Article Chemistry, Physical

Role of the LPSO structure in the improvement of corrosion resistance of Mg-Gd-Zn-Zr alloys

Jing Liu et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2019)

Article Materials Science, Multidisciplinary

Effects of small additions of Zn on the microstructure, mechanical properties and corrosion resistance of WE43B Mg alloys

A. Koltygin et al.

INTERNATIONAL JOURNAL OF MINERALS METALLURGY AND MATERIALS (2019)

Article Materials Science, Multidisciplinary

Microstructure, mechanical, and corrosion properties of extruded low-alloyed Mg-xZn-0.2Ca alloys

Ying-zhong Ma et al.

INTERNATIONAL JOURNAL OF MINERALS METALLURGY AND MATERIALS (2019)

Article Materials Science, Multidisciplinary

Effect of Sn on microstructure and corrosion behaviors of Al-Mg-Si alloys

Chuan He et al.

MATERIALS CHARACTERIZATION (2019)

Article Metallurgy & Metallurgical Engineering

Effect of Sn addition on the mechanical properties and bio-corrosion behavior of cytocompatible Mg-4Zn based alloys

Weiyan Jiang et al.

JOURNAL OF MAGNESIUM AND ALLOYS (2019)

Article Chemistry, Physical

Phase selection and mechanical properties of permanent-mold cast Mg-Al-Ca-Mn alloys and the role of Ca/Al ratio

Hamid Ali Elamami et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2018)

Article Materials Science, Multidisciplinary

Exfoliation corrosion of extruded Mg-Li-Ca alloy

Zi-You Ding et al.

JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY (2018)

Article Materials Science, Multidisciplinary

Effects of Sn addition on microstructure and mechanical properties of Mg-Zn-Al alloys

Bo Wang et al.

PROGRESS IN NATURAL SCIENCE-MATERIALS INTERNATIONAL (2017)

Article Materials Science, Multidisciplinary

Effects of Sn addition on microstructure and mechanical properties of Mg-Zn-Al alloys

Bo Wang et al.

PROGRESS IN NATURAL SCIENCE-MATERIALS INTERNATIONAL (2017)

Article Materials Science, Multidisciplinary

Role of Sn in corrosion and passive behavior of extruded Mg-5 wt%Sn alloy

Heon-Young Ha et al.

CORROSION SCIENCE (2016)

Article Materials Science, Multidisciplinary

Role of alloyed Nd in the microstructure and atmospheric corrosion of as-cast magnesium alloy AZ91

R. Arrabal et al.

CORROSION SCIENCE (2015)

Article Materials Science, Multidisciplinary

Corrosion and characterisation of dual phase Mg-Li-Ca alloy in Hank's solution: The influence of microstructural features

Rong-Chang Zeng et al.

CORROSION SCIENCE (2014)

Article Materials Science, Multidisciplinary

Influences of metallurgical factors on the corrosion behaviour of extruded binary Mg-Sn alloys

Heon-Young Ha et al.

CORROSION SCIENCE (2014)

Article Materials Science, Multidisciplinary

Anodic oxidation of Mg-Sn alloys in alkaline solutions

Sungmo Moon et al.

CORROSION SCIENCE (2012)

Article Materials Science, Multidisciplinary

Effects of Sr and Sn on microstructure and corrosion resistance of Mg-Zr-Ca magnesium alloy for biomedical applications

Wenjin Zhang et al.

MATERIALS & DESIGN (2012)

Article Materials Science, Multidisciplinary

Electrochemical behavior of anodized Mg alloy AZ91D in chloride containing aqueous solution

YJ Zhang et al.

CORROSION SCIENCE (2005)

Article Materials Science, Multidisciplinary

The corrosion behavior of scandium alloyed Al 5052 in neutral sodium chloride solution

Z Ahmad et al.

CORROSION SCIENCE (2001)