Related references
Note: Only part of the references are listed.
Article
Thermodynamics
Ahmed Alshehri et al.
Summary: The use of nanofluids in engineering and research has attracted significant interest. This study focuses on the impact of hybrid nanofluid and single nanofluid flow on a slippery nonlinear, non-uniform stretching surface, taking into account factors like radiative flux and heat source/sink. Mathematical modeling and numerical calculations were conducted using computational MATLAB software.
CASE STUDIES IN THERMAL ENGINEERING
(2022)
Article
Thermodynamics
Arshad Khan et al.
Summary: This study focuses on the application of nanofluids in improving industrial electrical structures and engineering devices, investigating the mass and thermal flow of micropolar hybrid nanofluid flow and finding that flow decreases with an increase in magnetic, material parameters, and nanoparticles volumetric fraction, while thermal profiles supported this phenomenon.
Article
Thermodynamics
Shahid Ali Khan et al.
Summary: This study evaluates the effectiveness of utilizing nanoparticles suspension in water at supercritical pressures to mitigate heat transfer deterioration (HTD) in supercritical fluid heat exchanger systems. The results show that the suspension of Al2O3 nanoparticles increases the mitigation of HTD, with higher volume fraction achieving better suppression of wall temperature peaks.
INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER
(2022)
Article
Nanoscience & Nanotechnology
Abdullah Dawar et al.
Summary: This study investigates the magnetohydrodynamic flow of a water-based hybrid nanofluid containing ferrous and graphene oxide nanoparticles past a flat plate, taking into account the stagnation points, magnetic field and thermal radiation. The non-Newtonian behavior of the flow is also considered, and the proposed model is analytically solved using HAM. The results show that the velocity field is significantly reduced with increasing volume fractions of the nanoparticles, while the thermal field is increased. The viscosity of the flow is increased with a larger power-law index, resulting in an increased velocity field but an opposite effect on the thermal field.
JOURNAL OF NANOMATERIALS
(2022)
Article
Multidisciplinary Sciences
Fazle Mabood et al.
Summary: This article investigates the flow of nanofluid over a variable thickened stretching sheet by incorporating non-Fourier's heat flux and non-Fick's mass flux. The study shows that an increase in the power-law index parameter enhances the fluid flow, heat, and mass transfer.
Article
Multidisciplinary Sciences
Muhammad Ramzan et al.
Summary: This study investigates the effects of Hall current, Joule heating effect, and variable thickness on the bidirectional flow of nanoliquid past a stretchable sheet. The results show that increasing the nanoparticles volume fraction enhances the fluid velocities and higher estimations of magnetic field parameter and thermal relaxation time parameter reduce the fluid temperature. It is also found that the Fe3O4-Vacuum pump oil (VPO) nanofluid improves the rate of heat transfer.
Article
Engineering, Mechanical
A. A. Farooq et al.
Summary: This study investigates the impact of entropy generation on the irreversibility characteristics of various heat transport processes in a microchannel with ciliated walls. The mathematical model consists of nonlinear partial differential equations and is analyzed under the lubrication approximation theory. The study provides analytical solutions for the velocity, pressure, temperature, and concentration distributions, as well as expressions for entropy production rate and Bejan number. The results highlight the importance of including Hall current and the eccentricity parameter in controlling the irreversibility of thermodynamical systems in cilia-based micro-devices.
PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART C-JOURNAL OF MECHANICAL ENGINEERING SCIENCE
(2022)
Article
Engineering, Multidisciplinary
Jifeng Cui et al.
Summary: The study investigates a non-similar model for forced convective magnetic flow of a viscous fluid above an exponentially expanding surface saturated by nano-fluid, exploring the influences of various factors on concentration, velocity, and temperature distribution. The results show that heat penetration increases with enhancements in Brownian motion and Prandtl number.
ALEXANDRIA ENGINEERING JOURNAL
(2022)
Article
Mathematics
Obai Younis et al.
Summary: This study investigates the numerical analysis of MHD-free convective heat transfer and its interaction with radiation over a heated flame inside a porous semicircular cavity loaded with SWCNTs-water nanofluid for the first time. The results indicate that decreasing the heated region length is beneficial for enhancing natural convection, and increasing parameters such as Ra, phi, Rd, and Da result in a proportional increase in Nu(out) while Ha shows an inverse relationship. Furthermore, an increase in radiation and Hartmann number leads to a 4% increase and 56.55% decrease, respectively, in the average Nu on the heated length. Additionally, a rise in radiation number causes a 73% increase in the average Nu of the heated flame, and increasing the Hartmann number results in an 82.4% decrement of the maximum velocity profile in the vertical direction.
Article
Engineering, Multidisciplinary
Samia Elattar et al.
Alexandria Engineering Journal
(2022)
Article
Thermodynamics
Hassan Waqas et al.
Summary: This article examines the impacts of non-linear thermal radiations on nanoparticles in water-based hybrid nanofluid flowing over a rotating disk, specifically focusing on the types and applications of carbon nanotubes. The study also looks into the behavioral analysis of velocity components and heat transfer under different parameters, showing that factors such as magnetic parameter and temperature ratio can affect the velocity field and heat transfer.
CASE STUDIES IN THERMAL ENGINEERING
(2021)
Article
Thermodynamics
Asmat Ullah Yahya et al.
Summary: The study examines thermal transport of hybrid nanofluids for managing increasing heat density in miniature and technical processes. By employing numerical solutions and computational software, it is found that the velocity is affected by the growing parameters of magnetic field and porosity, resulting in higher temperature.
CASE STUDIES IN THERMAL ENGINEERING
(2021)
Article
Thermodynamics
Wasim Jamshed et al.
Summary: The study numerically simulated the unsteady flow of a non-Newtonian Casson nanofluid on a slippery surface, discussing the effects of thermal transport and entropy, and found that thermal conductivity increases under the Casson phenomenon.
CASE STUDIES IN THERMAL ENGINEERING
(2021)
Article
Engineering, Multidisciplinary
Nurul Amira Zainal et al.
Summary: The study demonstrates that increasing the nanoparticle volume fraction in the magnetohydrodynamic hybrid nanofluid can enhance wall shear stress and convective heat transfer rate. Moreover, non-uniqueness solutions and unique solutions are observed under specific conditions.
ALEXANDRIA ENGINEERING JOURNAL
(2021)
Article
Engineering, Chemical
Bagh Ali et al.
Summary: This study investigates the magnetohydrodynamic effects on the transient rotational flow of Oldroyd-B nanofluids, revealing the impact of parameters like magnetic force and Deborah number on flow characteristics and temperature distribution through numerical simulations.
Article
Thermodynamics
T. Salahuddin et al.
Summary: The study investigates heat and mass diffusion in 2D Cross nanofluid flow over a parabolic surface using the Cattaneo-Christov model, considering temperature-dependent viscosity, enthalpy change, and activation energy. The determining equations are generated in the form of PDEs and transformed into ODEs using similarity transformations, and numerical outcomes are analyzed using the BVp4c method in Matlab software. The velocity of fluid shows reverse results with increasing Weissenberg number and viscosity parameter, while larger values of thermal and concentration relaxation parameters indicate a decrease in the respective fields. Numerical results for skin friction coefficient, Sherwood number, and Nusselt number for various parameters are presented in tables.
INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER
(2021)
Article
Biochemistry & Molecular Biology
Anwar Saeed et al.
Summary: This research scrutinizes the mathematical model for hybrid nanofluid flow in converging and diverging channels, focusing on drug delivery applications. The study reveals that combining TiO2 with other metals can more effectively destroy cancer cells, while increasing the couple stress parameter improves the stability of the base fluid and affects heat transfer rate based on nanoparticle volume fraction.
Article
Multidisciplinary Sciences
Muhammad Ramzan et al.
Summary: The study analyzes the magnetohydrodynamic flow of Ag - MgO/ water hybrid nanoliquid with slip conditions on an extending surface, incorporating thermal radiation and Joule heating effects. By utilizing the HAM method, solutions for higher-order ordinary differential equations are obtained, revealing significant variations in thermal and flow performance of the hybrid nanofluid under different flow parameters.
Article
Engineering, Multidisciplinary
P. Sudarsana Reddy et al.
Summary: The heat transfer and flow characteristics of Tiwari-Das model nanofluid inside a differentially heated square enclosure with single walled carbon nanotubes and water, considering thermal radiation, were investigated in this study. Numerical simulations were conducted to analyze the effects of various parameters on the heat transfer performance, showing that the addition of single walled carbon nanotubes can enhance the heat transfer rate of the nanofluid by up to 6%. Additionally, it was observed that the radiation parameter can increase the Nusselt number values inside the cavity. The numerical code used in this study was validated and showed good agreement with available data.
ALEXANDRIA ENGINEERING JOURNAL
(2021)
Article
Thermodynamics
Farooq Ahmad et al.
Summary: The research theoretically analyzed the heat transfer enhancement of hybrid nanofluids flowing through a porous medium in the presence of a magnetic field. The results showed that the flow speed increases with the Maxwell fluid parameter, while the increasing strength of the magnetic field and porosity resistance slows down the flow but causes a rise in temperature. Additionally, the additive volume fraction of silver with Graphene oxide helps decelerate the flow and enhance heat transportation.
CASE STUDIES IN THERMAL ENGINEERING
(2021)
Article
Chemistry, Physical
Umair Khan et al.
Summary: The time-dependent stagnation point flow and heat transfer of a water-based hybrid nanofluid from a radially permeable shrinking or stretching surface are investigated. Numerical results indicate the existence of dual solutions, with only one being stable, and the hybrid nanofluid enhances heat transfer rate compared to a regular fluid.
JOURNAL OF MOLECULAR LIQUIDS
(2021)
Article
Multidisciplinary Sciences
Hina Gul et al.
Summary: This study examines the flow of nanofluid containing multi and single-walled carbon nanotubes submerged in Ethylene glycol in a Darcy-Forchheimer permeable media over a stretching cylinder with multiple slips. The mathematical model takes into account non-uniform source/sink impacts, modified Fourier law, and autocatalytic chemical reaction. Entropy optimization analysis is performed and the nonlinear system is converted to ordinary differential equations for solution using the Shooting technique and bvp4c MATLAB software. The study shows that a strong magnetic field enhances temperature profile and decreases velocity profile, while fluid velocity decreases with increasing slip parameter. Additionally, entropy number increases with higher thermal relaxation parameter and Reynolds number.
SCIENTIFIC REPORTS
(2021)
Article
Multidisciplinary Sciences
Muhammad Waseem et al.
Summary: This study investigates the hydromagnetic flow of gravity-driven couple stress hybrid nanofluid past a heated plate. It has been observed that fluid flow decreases with an increase in magnetic parameter and volumetric concentrations, while thermal and concentration characteristics increase with an increase in volumetric concentrations.
SCIENTIFIC REPORTS
(2021)
Article
Nanoscience & Nanotechnology
Nilankush Acharya et al.
APPLIED NANOSCIENCE
(2020)
Article
Computer Science, Interdisciplinary Applications
Zahir Shah et al.
COMPUTER METHODS AND PROGRAMS IN BIOMEDICINE
(2020)
Article
Nanoscience & Nanotechnology
Saeed Islam et al.
Article
Nanoscience & Nanotechnology
Shafiq Ahmad et al.
APPLIED NANOSCIENCE
(2020)
Article
Multidisciplinary Sciences
Muhammad Ramzan et al.
SCIENTIFIC REPORTS
(2020)
Article
Multidisciplinary Sciences
Nomana Abid et al.
SCIENTIFIC REPORTS
(2020)
Article
Nanoscience & Nanotechnology
Nilankush Acharya et al.
PHYSICA E-LOW-DIMENSIONAL SYSTEMS & NANOSTRUCTURES
(2019)
Article
Mathematics, Applied
S. A. Shehzad et al.
APPLIED MATHEMATICS AND MECHANICS-ENGLISH EDITION
(2017)
Article
Engineering, Multidisciplinary
S. P. Anjali Devi et al.
INTERNATIONAL JOURNAL OF NONLINEAR SCIENCES AND NUMERICAL SIMULATION
(2016)
Article
Multidisciplinary Sciences
Junaid Ahmad Khan et al.
Article
Nanoscience & Nanotechnology
S. Nadeem et al.
APPLIED NANOSCIENCE
(2014)
Review
Thermodynamics
Omid Mahian et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER
(2013)
Article
Mechanics
C. I. Christov
MECHANICS RESEARCH COMMUNICATIONS
(2009)
